Two wattmeters are connected to measure the power consumed by a 3- load with a power factor of 0.4. The total power consumed by the load as indicated by the two wattmeters is 30 kW. The difference between the two wattmeter readings is KW

Q: A delta-connected unbalanced load is connected across a three-phase balanced source. The sequence…

A: Given Data:A delta-connected unbalanced load with three-phase balanced source has,The sequence phase…

Q: A function g[n] defined by: g[n] = -2, n, (n/4, n<4 -4≤n≤1 1≤n

A:

Q: An unbalanced wye connected load whose impedance per phase are given as Zin = 6 + j8Q2, Z2n = 10022…

A:

Q: (c) A DC shunt motor with compensating windings as shown in Figure Q3(e) has a rating of 70 hp, 270…

A:

Q: 30. If D1 were to open what would be the effect on the output voltage? _DROP_ A. Voltage would 20V…

A: The given question is based on voltage regululator circuits.

Q: what is the current through each component

A: It is given that:

Q: V.(t)=8cos(2t-45°). Find the average power of each circuit elements. 152 ww 252 3H : 0.25 F

A:

Q: 14 10 V 202 Α 6Ω 40 Si Sa 30

A:

Q: 6.(20) BJT small signal model, cutoff frequency a) Suppose the PNP BJT of Figure (shown below, left)…

A:

Q: A 800 V, 120kVA, 3-phase, 50 Hz, salient-pole synchronous generator is used in a hydroelectric dam,…

A: Please refer the attached images for the complete answer

Q: A delta connected resistive load is connected across a balanced three phase supply of 400 V as shown…

A: It is given that:

Q: A balanced, three-phase circuit is characterized as follows: Y-A connected; ● ● ● Source voltage in…

A: In this question, we need to determine the single phase equivalent circuit of phase a, Given Data:A…

Q: Series Resistance Microammeter (SRM) is one of the techniques in HVDC measurement: a) Draw an…

A:

Q: 1 Example-i ! A circuit is connected as shown in Fig. 5 to a 240V determine the current wave form 50…

A: Source voltage .Frequency .Diode voltage drop is zero.

Q: (b) In the Op-Amp oscillator circuit, analyse the oscillator conditions at the different effects of…

A:

Q: 2. Draw the Foster Series and Parallel form for the following LC Driving point functions.…

A: Since you have posted multiple questions, we will provide the solution only to the first five…

Q: 7. Determine the type of impedance and admittance function. S² +65 +8 a. Z(S)= b. Y(S)= c. Z(S)= S²…

A: Since you have posted a question with multiple sub parts, we will provide the solution only to the…

Q: 4. For the combination of capacitors shown in fig. below assume that C₁=1 µF, C₂=2 µF, C3= 3 μF, and…

A: Asked to find Total combination equivalent capacitance?Charge on each capacitor?Potential difference…

Q: SOLVE STEP BY STEP IN DIGITAL FORMAT 100 cos (2x 10ft +3°) V 89. Use superposition to determine the…

A: The given circuit isWe need to find the voltages v1(t) using superposition theorem.

Q: A 5 μF condenser is connected in series with a coil having inductance of 50 mH. If a 50 V source…

A: It is given that:

Q: An electromagnet can be modeled as an inductor in series with a resistor. Consider a large…

A:

Q: QUESTION SIX = The input voltage of a Cuk converter is V 15 V. The duty cycle 8 = 0.45 and the…

A: Dear Student,Since you have posted a question with multiple sub parts, we will provide the solution…

Q: 3. CALCULATE THE TRANSFER FUNCTION OF THE GIVEN SIGNAL FLOW GRAPH 10 R_1 2 3 1 -2 4 2 3 3 2 C

A:

Q: A single-phase inductive load draws to 1 kW at 0.6 power-factor lagging from a 230 V AC supply. 1.…

A: It is given that:

Q: The Laplace tan s form of f(t) = 3dt) + 2te-2t is

A:

Q: Question #5 Distance Relays & R-X Diagrams a) A line section has an impedance of 2.8 + j5 Q. Show…

A: A section of the transmission line has,Impedance To Find:Impedance vector on an R-X diagram.On the…

Q: 2. The switch in the circuit shown has been closed for a long time before it is opened at t = 0.…

A:

Q: Find R_AB if each resistor has a value of 6 ohms.

A: It is given that:

Q: A. Draw the small-signal equivalent model. B. Given C = 10 nF, T = 5000 , To = 100 kn and ß = 50.…

A: Given:Required:We need to (a) draw a small-signal equivalent model, (b) calculate the values of…

Q: CA B3 A3 Co b a FA4 S S3 C₁ C3 B₂ A₂ b Co a FA3 S S₂ C₁ C2 B₁ A₁ ba FA2 C S S₁ Figure Q2(b) Во…

A:

Q: Can you draw its equivalent circuit for furtger understanding and easy analysis. Also can you…

A: The above question is based on the DC analysis of the BJT circuit.

Q: What is the output voltage?

A: It is given that:

Q: y(t) = -31²+5 t≥0 31² + 5 t<0 From the Equation above, write the MATLAB statements required to…

A: According to the question, for the functionFrom the Equation above, write the MATLAB statements…

Q: 1.-(40) Find P and ight) m elle 7 10 (t) = 10 cosine 377t Amps R R = 100 WL = 105

A: The circuit diagram,The value of the current source,and,

Q: ! Required information Consider the circuit given. The value of Ris 15.00 2. (Round the final answer…

A:

Q: Find the zero state response of y[n+2] -0.6y[n+1]-0.16y[n]=x[n], when x[n]=8[n].

A:

Q: Determine the voltage of Ea if  Ebis 105 and Ec is 120 volts. Carry the answer to two decimal…

A:

Q: a 52-horsepower motor takes 196 amperes at full load, and the motor efficiency is 85%, what is the…

A:

Q: 3) Write the Boolean expression and draw the typical PLC ladder logic diagram for a control system…

A:

Q: When voltage of E = 20 sin wt + 40 sin (3wt +30°) +50 sin (wt + 60°) is applied to an…

A:

Q: Required information Consider the following statements. Calculate a, wo, S₁, and s2 for a…

A: R = 4.5 ohmL = 2.222 HC = 12.5 mf

Q: 6. Use the diagrams below to explain the difference in the Loop Rule vs the Junction Rule of…

A: Loop rule: The sum of all voltage drops in a closed loop is equal to zero is called a loop rule and…

Q: Produce a graph showing current I against the diode voltage VD. Please do it computerized. - Current…

A: It is asked to produce a graph showing current I against the diode voltage VD.Note: Since other data…

Q: What electrical component act as switches that let us switch between 1's and 0's Resistors…

A: From the given list of choices an electrical device which can be used as a switching element needs…

Q: ! Required information Consider the circuit given below. Au(t) mA The value of iL(0) is The value of…

A: The given circuit isWhere A=2.We need to find vL(0-),vL(0+),iL(0-),iL(0+).

Q: How do I make circuit of a 3-8 decoder into a 7 segment display. If the inputs are 000 the display…

A: To build a circuit that uses a 3-to-8 decoder to drive a 7-segment display, we need the following…

Q: A ****** 4) Sketch the resulting timing diagram: A B Y B ****** ****** A + B Exp. Theo. *** *** ***…

A:

Q: broadcast receivers" or "broadcast intentions." Please include specific examples to back up your…

A: In Android development, "broadcast receivers" and "broadcast intents" are concepts related to the…

Q: A 200 V, 50 Hz, inductive circuit takes a current of 10A, lagging 30 degree. Find (i) the resistance…

A: The given information is shown below:

Q: Simplify Z= AB + A (B+C) + B (B+C)

A: It is given that:

Power Measurement

According to Blondel's theorem, the total power is measured with one less number of wattmeters than the number of wires present in the system. So, a single-phase and two-wire system will require one wattmeter and a single-phase and the three-wire system will require two wattmeters, and a three-phase and the three-wire system will also require two wattmeters and a three-phase and the four-wire system will require three wattmeter devices. The wattmeter is a device that measures power using one voltage and one current input as shown in the above figure. Multiple current or voltage input pair cables are used by many power analyzers and digital storage oscilloscopes (DSOs) for measuring watts, in effect within a single instrument acting as multiple wattmeters. It is possible to measure three-phase and four-wire power with one correctly specified power analyzer.