Two-three phase ac generators 1 and 2 are connected in parallel. The first generator has a per phase impedance of 5 ohms and 80 percent power factor lagging while the second one has a per phase current of 85 amperes and 82 percent power factor lagging. If the total apparent power is 277,459.88 bar angle of negative 35.972 degrees volt amperes, calculate the line to line voltage.

Two-three phase ac generators 1 and 2 are connected in parallel. The first generator has a per phase impedance of 5 ohms and 80 percent power factor lagging while the second one has a per phase current of 85 amperes and 82 percent power factor lagging. If the total apparent power is 277,459.88 bar angle of negative 35.972 degrees volt amperes, calculate the line to line voltage.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.41P

See similar textbooks

Similar questions

The reactance of a generator is given as 0.1 pu based on the generator of 17 KV, 300 MVA. Determine the pu reactance on a base of 17 KV, 250 MVA. New pu reactance is.......
5.5 kW, 1450 rpm. L-type equivalent circuit and parameters for a continuous sinusoidal phase of a star connected 3-phase ASM with line voltage 220 V and frequency 50 Hz are given as follows, ignoring core (iron) losses: R1=0.21 Ohm, R2=-0.18 Ohm, X1=X2-0.66 Ohm and Xm = 9.9 Ohm How many times the inrush current will be the rated current when the ASM is started directly? Answer options group 8.0815 2.6455 4.3763 7.1534 1.2558 6.3414 5.2280 3.7473
In a Three-phase alternator, a given field current produces an armature current of 250 A on short-circuit and a generated e.m.f. of 1500 V on open-circuit. Calculate the terminal p.d. when a load of 250 A at 6.6 kV and 0.8 p.f. lagging is switched off. Calculate also the regulation of the alternator at the given load. Subject: Electrical engineering
e = 0 Q1: What does happen if we change two currents? a. Q2: What does happen if we have a three-phase four poles machine? Q3: What does happen if we have a two-phase two poles machine? e = 0 Q4: What does happen if we apply a capacitance in phase b and then use same voltage for both phase. Dr. Ali Ki. pw --
Alternator A(100 kVA,3-phase, 240V,60HZ,1800 rpm) is operating with alternator B(125 kVa,3- phase,240 V,60 Hz,1800 rpm). The load of alternator A is 60kW at 90% pf lagging and the load of alternator B is 80kW at 70% lagging. Determine pf of load.
Q2 (a) Three-phase generator consist of three set of single-phase generators, with voltages equal in magnitude but differing in phase angle by 120° apart. (i) Sketch phasor diagram of the three-phase voltages VA, VB and Vc (ii) Plot the three-phase voltages waveform in Q2(a)(i) in single plot.
(Qle, A three phase generator is operating at 1500rpm and has a no-load voltage of 7 kV. What would be the terminal voltage if a capacitive load is connected to its terminals? (a) 6.7 kV, (b) 6.9 kV, (c) 7 kV, (d) 7.2 kV
The instantaneous power absorbed by the load in a single-phase ac circuit, for a general R LC load under sinusoidal-steady-state excitation. is (a) Nonzero constant (b) Zero (c) Containing double-frequency components
A single-phase, 120V(rms),60Hz source supplies power to a series R-L circuit consisting of R=10 and L=40mH. (a) Determine the power factor of the circuit and state whether it is lagging or leading. (b) Determine the real and reactive power absorbed by the load. (c) Calculate the peak magnetic energy Wint stored in the inductor by using the expression Wint=L(Irms)2 and check whether the reactive power Q=Wint is satisfied. (Note: The instantaneous magnetic energy storage fluctuates between zero and the peak energy. This energy must be sent twice each cycle to the load from the source by means of reactive power flows.)
For the same alternator, the ratio of rated KVA, when connected as 3-phase winding to when connected as single phase alternator (by utilizing the coils) is, a.1.33 b.0.50 c.0.67 d.1.50
4. A 3-phase 50 Hz star connected alternator has 180 conductors per phase and flux per pole is 0.0543 Wb. Find i) e.m.f generated per phase and ii) e.m.f between line terminals. Assume the winding to be full pitched and distribution factor to be 0.96.
i. A 2300 V, With 2500 kVA three phase delta-connected alternator has a resistance of 0.1ohm/phase and a synchronous reactance of 1.5 ohms/phase. The alternator is adjustedto rated voltage at no load. Calculate its terminal voltage when carrying ratedcurrent at no load power factor of 0.6 lagging.