Two rivers located 2000 m apart fully penetrate an aquifer (Figure below). The aquifer has a K value of 4.0 m/day. The region receives an average net recharge of 2*10-3 m/day as a result of rainfall and evaporation. Assume that the water elevation in River 1 is 26 m and the water elevation in River 2 is 14 m. Use the Dupuit equation with recharge, and determine the location of the water divide in m. Enter your answer with 1 decimal. ho hmax Water table hi

Two rivers located 2000 m apart fully penetrate an aquifer (Figure below). The aquifer has a K value of 4.0 m/day. The region receives an average net recharge of 2*10-3 m/day as a result of rainfall and evaporation. Assume that the water elevation in River 1 is 26 m and the water elevation in River 2 is 14 m. Use the Dupuit equation with recharge, and determine the location of the water divide in m. Enter your answer with 1 decimal. ho hmax Water table hi

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: Q₂: A) At the beginning of a given day a reservoir has a surface area 30 Km. The inflow to the…

A: Reservoir surface area (A) = 30 km2 Inflow rate (Qi) = 80 m3/s Outflow rate (Qo) = 15 m3/s Seepage…

Q: A reservoir had an average surface area of 20 km during June 1982. In that month the mean rate of…

Q: 3. A reservoir had the following average values of climate parameters during a week: Relative…

A: Given- Relative humidity R.H=40%wind velocity at 1m above ground surface=16 km/hrew=saturation…

Q: A reservoir with as surface area of 300 hectares had the following average values of climate…

A: Given Data:water temperature = 36°CRelative Humidity = 30%Wind velocity u=20km/hK=0.50

Q: 2. In an unconfined aquifer, the drawdown is 2m at a radial distance of 9m from a well after two…

A: Given:- The drawdown from the unconfined aquifer = 2 m The radial distance from a well = 9 m Time…

Q: Refer to the cross section of the earth dam shown in the figure. Calculate the rate of seepage…

Q: A reservoir with as surface area of 300 hectares had the following average values of climate…

Q: Q2: At the beginning of a given day a reservoir has a surface area 30 km². The inflow to the…

Q: Two rivers located 2000 m apart fully penetrate an aquifer (Figure below). The aquifer has a K value…

A: Distance between two rivers, L=2000 m Hydraulic conductivity of aquifer, K=8 m/day Average net…

Q: A concrete dam is going to be built on a silty/clayey sand stratum as shown in Figure 1 to provide a…

A: Given: L = 100 m h = 6.1 m L = 1.5 m γsat = 18.5 kN/m3 γwater = 9.81 kN/m3 To find: The minimum…

Q: 6). Suppose an unconfined aquifer lies over a confined aquifer as shown in the figure w. Determine…

Q: An artifical recharge pond is located in a sandy area (Kv = 10 m/day; porosity = 30%). The pond…

A: We can use the one-dimensional equation for vertical water flow in unsaturated porous media, known…

Q: Shown is the cross section of a levee that is 424m long (perpendicular to section) and is underlain…

A: Given- Length of cross section of levee =424 m Thickness of permeable sand layer = 2.5m Quantity of…

Q: In a homogeneous unconfined aquifer of area 3.00 km², the water table was at an elevation of 102.00…

Q: An earth dam has conductivity kx = 4.5x10-8 m/s and ky = 1.6x10-8 m/s in the vertical and horizontal…

A: An earth dam has conductivity in vertical and horizontal direction,Number of flow channel, Nf =…

Q: An earth dam built on an impervious foundation has Horizontal & vertical permeabilities as 3.2 ×…

A: Given: Horizontal permeabilities, kH=3.2×10-2 mms Vertical permeabilities, kV=1.5×10-2 mms The full…

Q: The hydraulic conductivity of a homogeneous sandy/gravelly aquifer is 3 x 10-2 cm/sec. The…

Q: 2) Consider a confined aquifer 20 m thick and 2000 m wide. Two wells 1000 m apart are located in the…

A: Confined aquifer The thickness of the aquifer = 20m The distance between the two wells, L = 1000m…

Q: A tube well of 15 cm diameter penetrates fully an artesian aquifer 27 m thick. Determine…

A: This question is related to the Soil Mechanics.

Q: 1. A reservoir with a surface area of 300 ha had the following average values of parameters during…

A: saturation vapour pressure for 32o. From the table of temperature and saturation vapour pressure we…

Q: The pressure heads of an aquifer at 2000 m are 55.5 m and 36 m. The hydraulic conductivity of the…

A: Length = L = 2000m Pressure heads - h1 = 55.5m h2 = 36m Hydraulic conductivity = K = 76m/day…

Q: A tube well having a diameter 15 cm fully penetrates a confined aquifer of thickness 10 m. The…

A: Confined aquiferDiameter of well (d) = 15cm Thickness of confined aquifer (B) = 10m Discharge from…

Q: 5. Aquifer shown in figure represents: (a) confined aquifer (b) unconfined aquifer (c) Can be…

Q: The two pressure heads of an aquifer are of 56 m and 35 m at a distance of 1500 m. Calculate the…

A: using Darcy’s equation to find discharge velocity and then we can get seepage velocity which…

Q: Water is pumped from a well tapping an unconfined aquifer at a rate of 2400 m³/day. A no-drawdown…

Q: Referring to Figure Q3, calculate the following quantities: a. Elevation head, total head, and…

Q: Q₂: A) At the beginning of a given day a reservoir has a surface area 30 Km². The inflow to the…

A: Reservoir surface area (A) = 30 km2 Inflow rate (Qi) = 80 m3/s Outflow rate (Qo) = 15 m3/s Seepage…

Q: Determine the aquifer characteristics S and T assuming that Eq. (4.28) is valid.

Q: A 3.2 meter thick silty sand stratum intersects one side of a reservoir. The stratum has a hydraulic…

Q: Measurements of a water-balance have been made for 1 year period on a lake with an area of 0.9 km2…

A: Given: Period of measurement = 1 year Area of lake = 0.9 km2 Precipitation, P = 1500 mm Surface…

Q: The aquifer beneath a circular oceanic island has a mean hydraulic conductivity of 100 m d-1. Mean…

A: Given Mean hydraulic conductivity (K0) =100 md-1 Annual recharge W0 = 1 m Year-1 = 0.00273 md-1…

Q: Refer to the cross section of earth dam shown in figure ,Calculate the rate of seepage q in m3/min…

Concept explainers

Field applications of hydraulic conductivity

Hydraulic conductivity is one of the hydraulic properties of soil defined as a measurement of the ability of a porous medium to permit water movement or fluid flow through it. It is denoted by the letter K. It is influenced by the density and viscosity of the fluid. It is also called permeability. Hydraulic conductivity is defined as the ratio of velocity to the hydraulic gradient. The different methods used to determine the hydraulic conductivity are laboratory methods (constant head permeability tests and falling head tests), in-situ field methods (pumping in and pumping out tests), small scale field tests (infiltration tests and slug tests), and indirect methods such as estimation from grain size, consolidation test data, and horizontal capillary test. The pedotransfer function (PTF) method is a specific empirical estimating approach employed in the soil sciences is also used to determine the hydraulic conductivity of the soil.

Question

Two rivers located 2000 m apart fully
penetrate an aquifer (Figure below). The
aquifer has a K value of 4.0 m/day. The
region receives an average net recharge of
2*10-3 m/day as a result of rainfall and
evaporation. Assume that the water elevation
in River 1 is 26 m and the water elevation in
River 2 is 14 m. Use the Dupuit equation with
recharge, and determine the location of the
water divide in m.
Enter your answer with 1 decimal.
ho
W
W
hmax
W
Water table
W
hi
DIII
V

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1: Given

VIEW

Step 2: Calculation

VIEW

Solution

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Field Applications of Hydraulic Conductivity

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

With units please
Refer to the cross section of the earth dam shown in the figure. Calculate the rate of seepage through the dam (q in m3/ min / m) using L. Casagrande's method. K 5 m 1V: 2H 30 m 1V: 2H 25 m k = 3 x 10-4 m/min Impermeable layer Select the correct response: 5.91 x 103 m/min/m 2.37 x 103 m3/min/m 11.4x 104 m/min/m 29.5 x 104 m3/min/m
2
1. A piezometer point is 35 m above mean sea level. The fluid pressure in the aquifer at that point is 6.70 x 10E+6 N/m2. The aquifer has fresh water at a temperature of 15 degree C. a) What is the point water pressure head? b) What is the total head?
The level of water in the reservoir is 1.25 m. If there is a rainfall of 38 cm occurring in a month, during this period evaporation as measured by the class A pan is 32 cm. What is the level of water in m at the end of the month.
A lake with a surface area of 275 ha has the values of: relative humidity = 60% wind velocity at 1m above the ground = 10 kph mean barometric reading 750 mmHg es = 30 mmHg Km = 0.36 Estimate the average daily evaporation from the reservoir and the volume of water evaporated in the body in 5 days using MEYERS
12 Determine the quantity of seepage under the dam cross section shown in m3/s/m if the soil has hydraulic conductivity, k=0.0001 meter cube per second. Note the numbers in the figure from left to right are:2.0m, 1.8m, 2.4m and 8.0 m, respectively. 2.00m 8.00 m 1.80 m Datum 12.40m 777 Enter your answer
The figure shows the cross section of a levee that is 500 m long and is underlain by a 2-m-thick permeable sand layer. It was observed that the quantity of water flowing through the sand layer into the collection ditch is 250 m³/day. What is the hydraulic conductivity of the sand layer? Elv. 160 m Levee 1 Elv. 150 m 2 m Ditch 125 m I Impervious O Sand
Refer to the cross section of the earth dam shown in the figure. Calculate the rate of seepage through the dam (q in m^3 / min / m) using L. Casagrande’s method
4. A confined horizontal aquifer of 20 m thickness and permeability K = 22 m/day, connects two reservoirs M and N situated 2 km apart. The elevations of the water surface in the reservoirs M and N measured from the top of aquifer are 30 m & 10 m respectively. If the reservoir M is polluted by a contaminant suddenly, how long will it take the contaminant to reach the reservoir. N. Assume the porosity of aquifer n=0.26
QUESTION 1 Calculate the transmissivity of an artesian aquifer that has a thickness of 5.5 m and is pumped at a rate of 1.52 m³/min. There are two observation wells located at 150 m and 280 m away with drawdowns of 0.8 and 0.72 m respectively. (15) QUESTION 2 An aquifer has T = 175 m²/day, S = 1.3 x104, and provides a flow of 20 L/s to a well. Find the drawdown at the two observation wells located 15 and 65 m from the producing well after 1 day, 2 months, 10 months and 2 years. (15)
An unconfined aquifer is known to be 32 m thick below the water table. A constant discharge of 2 cubic metres per minute is pumped out of the aquifer through a tubewell till the water level in the tubewell becomes steady. Two observation wells at distances of 15 m and 70 m from the tubewell show falls of 3 m and 0.7 m respectively from their static water levels. Find the permeability in mm/s of the aquifer.