Two power plants are connected by a transmission line. The entire load is connected at plant Plant 1 is supplying 150 MW of power and a transmission loss of 10 MW. The incremental fuel cost of plant 2 is dF₂ 2 = 0.03P₂ +15Rs/MWh andλ = 21 Rs/MWh. dP₂ For minimum value of total fuel cost, the generated power at plant 2 in MW is

Two power plants are connected by a transmission line. The entire load is connected at plant Plant 1 is supplying 150 MW of power and a transmission loss of 10 MW. The incremental fuel cost of plant 2 is dF₂ 2 = 0.03P₂ +15Rs/MWh andλ = 21 Rs/MWh. dP₂ For minimum value of total fuel cost, the generated power at plant 2 in MW is

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.31P: Consider two interconnected voltage sources connected by a line of impedance Z=jX, as shown in...

See similar textbooks

Similar questions

Consider two interconnected voltage sources connected by a line of impedance Z=jX, as shown in Figure 2.27. (a) Obtain expressions for P12 and Q12. (b) Determine the maximum power transfer and the condition for it to
What are the elements which contribute to the cost of the electricity? And discuss how the “load curves’ and ‘load duration curves’ can helpful in the economics of generation.
Q2. For the circuit shown below, sketch the current waveforms iş and io and determine the Average and RMS for both currents. a = 50° TI 50 2 Vs = 300 sin 100zt ( cot T2 in cot
A 500 MVA synchronous machine has H, = 5.6 MJ/MVA and a 1200 MVA machine has H₂ = 2.0 MJ/MVA. The two machines operate in parallel in a power station. What is the equivalent. H constant for the two, relative to a 100 MVA base?
The reactance of a generator is given as 0.1 pu based on the generator of 17 KV, 300 MVA. Determine the pu reactance on a base of 17 KV, 250 MVA. New pu reactance is.......
Electricity has composite demand. True False
Referring to the Figure 2, compute the following values, given that the operating frequency is 60Hz and the voltage is 120V: (a) The inductive reactance (b) Source current (c) Apparent power, active power and reactive power Sketch and illustrate the power triangle with proper labelling, units and values. E 160 150 mH Figure 2
6. If a power system has 10,000 kVA capacity, operating at 0.7 lagging power factor and cost of synchronous capacitors to correct the p.f is $10.5/kVA.Determine the cost involved and also required leading reactive power to increase the power factor to (a) 0.85 lagging p.f
Discuss the key challenges associated with integrating renewable energy sources into the power grid.
Discuss the challenges and solutions for integrating renewable energy sources into existing power grids.
What effects are produced by change in voltage? 1. Iron los..........varies approximately as V². 2. Cu loss..........it also varies as V² but decreases with an increase in voltage if constant kVA output is assumed. 3. Efficiency...........for distribution transformers, efficiency at fractional loads decreases with in- crease in voltage while at full load or overload it increases with increase in voltage and vice- versa. 4. Regulation..........it varies as but decreases with increase in voltage if constant kVA output is assumed. 5. Heating.........for constant kVA output, iron temperatures increase whereas Cu temperatures decrease with increase in voltages and vice-versa.
OR e) What is BILS? Explain their significance in power system studies.