TRUE OR FALSE: 1. Positive power implies that the element is supplying power. 2. Passive components are resistors, capacitors, and inductors that do not amplify or rectify. 3. All the current in the circuit passes through the ammeter must have a very high resistance. 4. If the current does not change with time, but time remains constant, we call it a direct current (DC). 5. 5hp is equivalent to 3.73kW

TRUE OR FALSE: 1. Positive power implies that the element is supplying power. 2. Passive components are resistors, capacitors, and inductors that do not amplify or rectify. 3. All the current in the circuit passes through the ammeter must have a very high resistance. 4. If the current does not change with time, but time remains constant, we call it a direct current (DC). 5. 5hp is equivalent to 3.73kW

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter18: Resistive-inductive Parallel Circuits

Section: Chapter Questions

Problem 1PA: Incandescent lighting of 500 W is connected in parallel with an inductive load. A clamp-on ammeter...

See similar textbooks

Similar questions

The maximum value of an alternating voltage is 300 V. It takes 20 ms for one cycle. So write the formula for alternating voltage and (1) Find the time taken to reach 200 V for the first time after zero, and (2) find the value of the voltage at 18 ms.
When a voltage of 100V at 50Hz is applied to a choking a coil A, the current taken is 8A and the power is 120W, when applied to a coil B, the current is 10A and the power is 120W. what power will be is 10A and the power is 120W. what power will be taken when 100V is applied to the two coils connected in series?
what is the equivalent resistance Rab
a p.d. of 500 V is applied across the winding of an electric motor and the resistance of the winding is 50 ohmios determine the power dissipated by the coil
3-4 81 A d'Arsonval meter movement with a full-scale deflection current rating of 200 μA and an internal resistance of 500 2 is to be used in an ac voltmeter using full-wave rectification. Calculate the value of the multiplier resistor for a 50-V peak-to-peak sine-wave range.
The hot resistance of an incandescent lamp is 10 ohms and the rated voltage is 50 V. Find the series resistance required to operate the lamp from an 80 V supply
Connecting an ammeter and voltmeter to a series Resistive Capacitive circuit powered by a 60 Hz line results in the following readings. 240 , and 0.715 A. The resistor is 150 What is the true power ?
A direct current of 12.5 A flows in a 25-ohm resistance. Determine the maximum value of an alternating current that will produce heat at the same rate in this resistance. Expresss answer to the nearest hundredths.
Incandescent lighting of 500 W is connected in parallel with an inductive load. A clamp-on ammeter reveals a total circuit current of 7 A. What is the inductance of the load connected in parallel with the incandescent lights? Assume a voltage of 120 V and a frequency of 60 Hz.
Determine the potentials in a, b, c and d in Figure 5. Determine the voltages Uac and Ucb
A student wants to measure the electric potential difference across the battery for the circuit below. R, A D C R2 Except from point A to point D, where should a student hook up a voltmeter to measure the electric potential difference across the battery? O From point D to point C From point B to point C From point B or point D O From point A to point B
A voltmeter reads 100.5 V. The error taken from an error curve is 5%. Find the true value of the voltage.