(Triangulation): Two stations B and C were observed from a theodolite set up at station A and following data are recorded as follows: Line AB: azimuth = 233°08' and distance = 500m Line AC: azimuth = 270°00' and distance = 400m If a line is to connect the midpoint of line AB to a point 100m from point B along the line BC, determine its length.

(Triangulation): Two stations B and C were observed from a theodolite set up at station A and following data are recorded as follows: Line AB: azimuth = 233°08' and distance = 500m Line AC: azimuth = 270°00' and distance = 400m If a line is to connect the midpoint of line AB to a point 100m from point B along the line BC, determine its length.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Determine: (a) The probable error of the mean in Taping Operation 1. (b) The probable error of the mean in Taping Operation 2. (c) The combined most probable measurement of the frontage, in meters. Answer these questions using this taping scenario. Two surveying tapes were used in measuring the frontage of an open field. The resulting measurements are as follows: Taping Operation 1 Taping Operation 2 300.977m 300.761m 300.415m 300.772m 299.743m 300.776m 299.994m 300.713m
Two decimal places only.']
*what is the stadia constant of the instrument? *what is the slope length between the telescope @ A and the rod reading @B?
situation 4] In the two-peg test method performed by a group of surveying students, the following observations were taken: Rod reading Instrument Instrument set up near set up near K 1.851 On A On B 1.318 1.741 1.048 Point J is equidistant from A and B, and K is 12.14 m from A and 74.25 m from B. The difference in elevation between A and B. The correct rod reading on B with the instrument set up at K. The correct rod reading on A with the instrument set up at K. iii.
If the rod reading taken at 1 is 2.735 m, the elevation of 2 is 225.395 m, the difference in elevation between stations 1 and 2 is 25.650m and the difference in elevation between the instrument station and station 2 is 33.642m, determine the following: a. Height of the instrument. b. Horizontal distance between stations 1and 2.
In tacheometry survey, an intercept of 0.755m was recorded on a staff which was believed to vertical, and the vertical angle measured on the theodolite was +15º. Actually, the staff which was 4 metres long was 0.14m out of plumb bob and leaning backwards away from the instrument position. Assuming it was an anallatic instrument with a multiplying constant of 100, what would have been the error in the computed horizontal distance?
Imagine that you are the engineer responsible for the tacheometric survey of an area where a public park will be built. While surveying, you found a cliff that needs to be detailed mapped. Using a tacheometer, the following readings were obtained:Data:Zenith angle (z): 45°Reading on stadimetric wires:High wire: 1.485 mMedium yarn: 1,000 mLow wire:0.948 mInstrument height: 1.50mHeight of observed point: 0 m Calculate the horizontal distance from the observed point and the height of the cliff in relation to the instrument position. ∆d = 100. (A-B). cos²z∆h = Dx tan(z)+ (hm+hi-hv)- Give preference to make the resolution editable, handwriting hinders understanding.
definition of a datum in seismic reflection Choose one: a. a level equal to the mean-sea level b. all of the options are true c. a level were time is zero d. datum is the surface level of the earth
I need the answer as soon as possible
1) 2 points B & C were observed from point A where the instrument was set up at a height of 1.25m. Points B & C are ahead of point A. The surveyor used an internally focusing telescope with a stadia interval factor of 100. The table below shows the data recorded as observed for points B & C. Answer the following. (Show complete figures and solutions) a) What is the stadia constant of the instrument? b) What is the slope distance between the telescope at point A and the rod reading at point B? c) What is the difference in elevation between point B & C? d) What is the slope distance between the ground surface at point B and the ground surface at C? e) What is the elevation of point C if point A is at an elevation of +0316.15m above mean sea level? - 1 attachment Vertical Stadia Hair Readings ROD/Point Angle Upper Middle Lower В -25°15' 2.316 1.877 1.438 -45°57' 3.333 2.011 0.689
pls answer asap
In the two-peg test method of a dumpy level, the following observations were taken. What is the difference in elevation between A and B in meters? * Instrument near A 1.455 2.341 Instrument near B 0.978 Reading at A Reading at B 1.957 0.933 0.887 0.949 O 0.871