RAn inductor has been connected in series with aresistor to a DC source at t-0. If the inductor hasan initial current Io-2A flow in oppositedirection of the final current, then the circuitcurrent i(t) is

In this question, we have given series RL circuit with dc source and we have to find out circuit…

Answered: to a DC source at t-0. If the inductor…

to a DC source at t-0. If the inductor has l current Io-2A flow in opposite n of the final current, then the circuit (t) is

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter21: Resistive-capacitive Series Circuits

Section: Chapter Questions

Problem 7RQ: An RC series circuit is connected to a 120-V, 60-Hz power source. The resistor is 25 and has a...

See similar textbooks

Related questions

Q: A voltage source is connected to the two terminals of a 54.23 µF capacitor. The source voltage…

Q: If the voltage across the 2mF capacitor is represented by the signal shown in figure x, find and…

Q: An RL circuit has an emf of 5V, a resistance of 50Ω , an inductance of 1H and no initial current.…

Q: An inductor has been connected in series with a resistor to a DC source at t-0. If the inductor has…

A: To find the expression for the circuit current I(t)

Q: Eudora is observing a certain circuit consists of an inductance of 0.05 henry having a resistance of…

Q: For a 3.9 mH inductor which has a current as shown below, what is the voltage across into the…

Q: The voltage across a 2 H inductor is given by the waveform shown in figure. Find the current in the…

A: Voltage across inductor VL = L*di/dt For current i =1/L*area of VL * time curve For 0 to 2 sec I =…

Q: find the voltage across the 6 k Ω resistor for both the initial and steady-state conditions assuming…

Q: 5. A voltage v(1) = 100 cos(60r + 20°) V is applied to a parallel combination of a 40-kN resistor…

Q: The shown circuit is connected for a long time. IfC-24 µF and s-5.5 V, then find the charge on the…

Q: Ot Tutorial for Be.. Find the equivalent capacitance (in F) seen by the source if C = 8.5 F C O 4.15…

A: Given circuit, Where, C = 8.5 F

Q: For the following circut, de co-efficient and the energy storced in the couple inductors at t- 3.5s.…

A: To find the coupling coupling we need to know the value of the mutual inductance between the two…

Q: A 20-µF capacitor is connected in parallel to the series connection of a variable resistor R and a…

A: Given that,A series connection of variable resistor and inductor is connected in parallel connection…

Q: (d) Find vc() and in(). (d) Find the energies in the inductor and capacitor at t = 0, wi(0) and…

Q: A 0.25 μH inductor is used in an FM radio circuit that oscillates at 100 MHz. The current through…

A: Given L=0.25 μH, f = 100 MHz, t = 5.0 ns, i = 2.0 mA Calculating Inductive reactance…

Q: Lesson= Second Order Transient Response A 24-V battery is connected in seires with a 1-Henry…

Q: A 275mH inductor with a quality measure of 6 and a 1502 resistor are series connected to a 120V,…

A: Given: Inductance, L=275 mH Resistance, R=150 Ω Quality measure is 6 Source voltage, V=120∠0°V…

Q: An RC circuit has an emf of 10 sin t volts, a resistance of 100 ohms, a capacitance of 0.005 farads,…

A: Based on the basic electrical circuit

Q: In the figure shown below, if R=212 and L=3 H, find the current in A flowing through the inductor…

Q: Find the current at 2ms through a 11 mH inductor if the voltage across it is v(t) = 15t'sin2000t.…

A: 8. It is given that: v(t)=15 t2sin2000t VL=11 mH=11×10-3 HIo=3 mA=3×10-3 A

Q: 2. Solve for the voltage drop across the 1H inductor using Thevenin's theorem.

A: The thevenin's equivalent circuit can be calculated by using the nodal analysis and the thevenin's…

Q: The voltage on 3 mH inductor is shown in figure. Find and draw the * .current i UL 15.0 4 t, ms…

A: Voltage across an inductor of inductance 'L' is V=Ldidt

Q: Q2/ For the network shown in figure (Q:), the switch has been open for a long time before closing at…

A: Transient is a period of time a circuit takes in order to come back to the steady state condition…

Q: a) For the capacitor circuit shown find the total capacitance CT (in pF). Do not enter the unit.…

Q: Using Kirchoff's law, find the current that goes through the capacitor in the circuit below.

A: In this question we will find current going through capacitor using mesh analysis...

Q: 10te-" A. Find the voltage The current through a 0.1-H inductor is i(t) = across the inductor and…

Q: The voltage across a 5-H inductor is 10e" +20e V. If the initial current through the inductor is 3A,…

Q: Eudora is observing a certain circuit consists of an inductance of 0.05 henry having a resistance of…

Q: In the figure below, the switch has been open for a significant period of time. The switch is closed…

A: First find the differential equation governing the system then find the complementary and particular…

Q: Find v (t) for t>0 in the circuit if the initial current in inductor is zero

A: For standard charging equation time constant is define as time at which response will be 63.2% of…

Q: Given the following image of a practical inductor, what is true? Practical HEFF inductor Rpc RAC L…

Q: Obtain the equivalent capacitance of the circuit below

A: In this question we will find equivalent capacitance....

Q: he RC circuit shown find (a) the voltage on the capacitor and (b) the voltage on the resistor at t =…

A: Introduction: The DC Power Supply is linked to the capacitor, and current flows through the circuit.…

Q: Eudora is observing a certain circuit consists of an inductance of 0.05 henry having a resistance of…

A: GivenResistance R= 20 ohm Inductance L= 0.05H, Capacitance C= 100uF. Voltage V= 100cos(200t)…

Q: For the circuit show, find the equivalent capacitance. Then find the ch

A: The electrostatic energy in a capacitor is depends on the magnitude of charge and area of the…

Q: A 20-uF capacitor is connected in parallel to the series connection of a variable resistor R and a…

Q: 2. In the circuit shown, find the current through the capacitor using Kirchhoff's Law

Q: In the circuit shown, the switch is closed at t-0. The current through the inductor L after the…

A: To solve above question, one should understand the behavior of Inductor and capacitor in DC circuit.…

Q: Please use Nodal Analysis to solve this problem please. For the following circuit assume it has been…

Q: An RL circuit has an emf of 5 V, a resistance of 50 ohms, an inductance of 1 H, and no initial…

Q: In the shown circuit, the capacitor is initially uncharged. The switch S is closed at time t-0. Find…

A: Given circuit is shown below. At t=0- switch is opened And source disconnected. Capacitor open…

Q: In a 50 hertz circuit, containing a 10 mH inductor, the inductive reactance is Select the correct…

Q: The value of the Inductance can be determined by 2El, if 'E' is energy stored in inductor and T' is…

Q: Find the equivalent circuit of the given circuit. Voltage across inductor at t=39micro second.…

A: Calculate the Thevenin resistance across the inductor.

Q: . Suppose the voltage across the inductor is ΔvL = ΔVmax= RVmax sin wt Find the current through this…

A: Given in the question: Voltage across the inductor, ∆Vmax=RVmaxsinωtAnd, R = 4ΩSo,∆Vmax=4Vmaxsinωt…

Q: Consider the following figure that shows the current in an inductor of 5 H. Find the voltage across…

Q: An RL circuit has an emf of 5V, a resistance of 50 Ω, an inductance of 1 H, and no initial current.…

Q: For the circuit below, what is the initial condition across the inductor? L =? H

Question

R
An inductor has been connected in series with a
resistor to a DC source at t-0. If the inductor has
an initial current Io-2A flow in opposite
direction of the final current, then the circuit
current i(t) is

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sinusoids and Phasors of Alternating Circuit

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Question 4 A boost converter has an input of 5V and an output of 20W at 15V. The minimum inductor current must be no less than 50% of the average. The output voltage ripple must be less than 1%. The switching frequency is 30kHz. Determine the duty ratio, minimum inductor value, and minimum capacitor value. Verify your answers using Matlab, show the inductor current is continues and its minimum is no less than 50% of its average. Furthermore, the output voltage ripple is less than 1%.
C'uk Converter Design A C'uk converter has an input of 12 V and is to have an output of - 24 V supplying a 60 W load. Select the duty ratio, the switching frequency, the inductor sizes such that the change in inductor currents is no more than 12 percent of the average inductor current, the output ripple voltage is no more than 1.5 percent, and the ripple voltage across C1 is no more than 3 percent.
4- Design a boost converter that will have an output of 60 V from a 24-V source. Design for continuous inductor current and an output ripple voltage of less than one percent. The load is a resistance of 50 2. Assume ideal components for this design. VL ooooo ip - ^
A step up converter is operated with a duty cycle of k = 0.75. The input voltage is V, = 20V. and the load is: L= 5mH, R = 202. The minimum source current is I = 10A The maximum inductor current is %3D Select one: O a. None of these O b. 24 A Oc 12 A O d. 22 A O e. 16 A
In DC / DC switching circuits, a resistor-inductance (r-l) circuit is usually connected to the load in series, and also a reverse parallel switching diode is connected to this inductance (l). Write down your comments and approaches about the purpose for which these connected resistance, inductance and diode elements are used by an engineer's approach
this is electric circuit questin ...plz solve it early .plz solve early
Design a Cuk converter that has an input of 25V and the output of -30V. The load is 60W. Specify the duty ratio, switching frequency, inductor values and capacitor values. The maximum change in inductor currents must be 20 percent of the average currents. The ripple voltage across capacitor C1 must be less than 5 percent, and the output ripple voltage must be less than 1 percent.
A step down converter is operated with a duty cycle of k = 0.75. The input voltage is Vs = 20V, and the load is: L = 5mH, R = 1502. The minimum inductor current is I₁ = 0.1A. The maximum inductor current is: Select one: a. 1.9 A b. None of these OC. 0.9 A O d. 1.1 A Oe. 2 A
A step down converter is operated with a duty cycle of k 0.75. The input voltage is V, 20V. and the load is L=5mH, R=152 The minimum inductor current is I 0.1A. The maximum inductor current is %3D %3D Select one: O a. 0.9 A O b. 1.9 A O C. None of these O d. 1.1 A O e.2A
I am getting the output of the clamper circuit wrong, how will this circuit be output ? circuit question : Set the input voltage signal to a sinusoid with 100 Hz frequency and 20V peak-to-peak amplitude with C=1μF. Obtain and plot the input and output voltage waveforms.
Describe and explain the power in ac circuits; Series RLC Circuit, Parallel RLC Circuit and Power Measurement in AC Circuits
I need answer with explaination In a series R–L circuit the p.d. across the resistance R is 12V and the p.d. across the inductance L is 5V. Find the supply voltage and the phase angle between current and voltage