Three point masses ma, mB and mc are located in the x-y plane at points A, B and C as shown in Figure They are connected together by massless rods. Find the kinetic energy of the system if it rotates with an angular speed of 4.0 rad/s about the z-axis passing through point A. Fig# y mg = 0.10 kg 0.30 m 0.40 m A m, = 0.30 kg mc = 0.20 kg A) 0.46 J В) 0.69 J C) 0.21 J D) 1.2 J E) 2.5 J

Three point masses ma, mB and mc are located in the x-y plane at points A, B and C as shown in Figure They are connected together by massless rods. Find the kinetic energy of the system if it rotates with an angular speed of 4.0 rad/s about the z-axis passing through point A. Fig# y mg = 0.10 kg 0.30 m 0.40 m A m, = 0.30 kg mc = 0.20 kg A) 0.46 J В) 0.69 J C) 0.21 J D) 1.2 J E) 2.5 J

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

Q-6: A 10 kg cylinder rolls along a horizontal floor so that the cylinder's center of mass has a speed of 5 m/s. How much work must be done on the hoop to stop it? A) 25 J B) 63 J C)-125 J D) -188 J E)-375 J
In the game of tetherball a rope with length ?=1.50 m connects a ball with mass ?=0.750 kg to the top of a vertical pole so that the ball can spin around the pole as shown in the figure. What is the speed ? of the ball as it rotates around the pole when the angle ? of the rope is 38.0∘ with the vertical?
Two solid spheres of radius R and mass m are initially separated by a distance d such that the two centres of mass are separated by d+3R as shown below. The spheres are initially at rest, but the gravitational force accelerates them towards each other until they collide.a) Calculate the initial mechanical energy of the system.b) Calculate the gravitational potential energy of the system at the moment they collide.c) Derive an expression for v. State carefully what physical law you are applying.d) Show that, in the limit d >> R, the velocity v is independent of d.
Two hangers are attached by a string to a vertically mounted pulley system as shown. One disk is bigger than the other, and the disks are attached to each other such that they rotate together. The axle has negligible friction. The mass of the large disk is 1200 grams and the radius is 11 cm. The mass of the small disk is 400 grams and the radius is 4 cm. The high hanger has a mass of 200 grams and starts 80 cm above the ground. The lower mass starts on the ground and has a mass of 100 grams. The hangers are released from rest. What is the velocity of the 200 gram hanger when it hits the floor?
The figure shows a ball with mass m = 0.69 kg attached to the end of a thin rod with length L = 0.99 m and negligible mass. The other end of the rod is pivoted so that the ball can move in a vertical circle. (a) What initial speed must be given the ball so that it reaches the vertically upward position with zero speed? What then is its speed at (b) the lowest point and (c) the point on the right at which the ball is level with the initial point? (d) If the ball's mass were doubled, what would the answer to (a) be?
lo completes one orbit about Jupiter in 1.77 days and the average Jupiter-Io distance is 4.22 x 10° m. Calculate the angular speed w of Io as it orbits Jupiter. W =
Determine the moment of the 130-lb force about point A and about point O. 39" B 30" F = 130 lb Answers: M₂ = (1 Mo= (1 26° k) lb-in. k) lb-in.
The turntable in a microwave oven has a moment of inertia of 0.040 kg⋅m2 and is rotating once every 4.4 s . What is its kinetic energy?Express your answer with the appropriate units.
Discuss why the differences in peak torque and average power between the two speeds 60 and 180°/sec during extension. Can you relate these differences to the measurements of strength and power? Why? Use the force-velocity curve to answer this question Extension Peak Torque (N/M) Peak Torque (N/M) 60•/sec Flexion 60°/sec 180°/sec 180•/sec s1 160.7 119.2 s1 78.3 75.3 S2 90.8 57.2 S2 49.3 36.7 S3 132 104.9 S3 89.3 68.2 S4 127.1 88.4 S4 58.8 48.1 S5 213.3 151 S5 98.9 72.3 S6 138.2 104.2 S6 61.8 55.7 S7 115.4 84.1 S7 49.2 40.8 S8 117.5 82.1 S8 59.7 40.2 S9 119.5 80 S9 62.3 43.2 s10 113.7 79.9 S10 53.6 38 s11 122.5 89.2 S11 57.6 33.8 Average 132 95 Average 65 50 Extension Average Power (W) Flexion Average Power (W) 60°/sec 180•/sec 60•/sec 180•/sec s1 120.2 202.5 s1 66.9 113.4 S2 80.9 134.8 S2 45.7 77.1 S3 117.5 272.6 S3 74.7 147.3 S4 116.2 192.2 S4 55.1 105.1 S5 130 255 S5 67.3 108.5 S6 118.9 164.2 S6 59.6 114.7 S7 94.1 187.4 S7 47.7 98.9 S8 94.7 128.9 S8 44 55.2 S9 97.3 130.4 S9 48.1 60.6…
A ezto.mheducation.com/ext/map/index.html?_con3con&external_browser%3D0&launchUrl=https%253A%252F%252Fnewconnect.mheducation.com%252F.. 18 i Saved Help Save 5 How much work is done by the motor in a CD player to make a CD spin, starting from rest? The CD has a diameter of 12.0 cm and a mass of 15.8 g. The laser scans at a constant tangential velocity of 1.20 m/s. Assume that the music is first detected at a radius of 20.0 mm from the center of the disk. Ignore the small circular hole at the CD's center. Вook Hint Int ences < Prey 5 of 21
A 26 g block hangs from a 350 g rotating solid disk, as shown below. If the radius of the disk is12 cm, what is the speed of the block after it has dropped 55 cm starting from rest? If a disk with radius5.0 cm is used instead, how does your answer change?
Question 17: A non-uniform rod of length l has linear mass density = Ao.x where Xo is a positive constant. The rod is pivoted at point P as shown in Figure 10. The rod is released at rest (7 is the gravitational acceleration). Find the speed of the bottom of the rod when it becomes in the vertical position. M,l Figure 10 ニニニ」