Answered: Three capacitors 3 µF, 5µF, and 9µF are…

Three capacitors 3 µF, 5µF, and 9µF are connected in parallel with an 9V battery. Determine the: (2) charge drawn from the battery.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter19: Capacitors

Section: Chapter Questions

Problem 3PA: You find that a 25-F capacitor connected to 480 VAC is defective. The storeroom has no capacitors...

See similar textbooks

Related questions

Q: parameters Dtotal, Jtotal

A: Open Loop System- A system which is controllable in which input of the system does not depends on t...

Q: Write down the general expression for the input impedance of a transmission line of length 1 and cha...

A: "According to the Company's policy, we will solve only the first part of the question". We need to w...

Q: Determine Vac in the circuit in polar form. Write the magnitude only in four decimal places. 80260°V...

Q: Find the Fourier transform of f(t) = [Ae^-at]u(t) and draw the amplitude and phase %3D spectrum

Q: 5) In liquid insulation, the volume of the bubble remains constant during elongation: a. True. b. Fa...

A: 5) The elongation of the bubble takes place either in presence of electrostatic force or the due to ...

Q: A series RLC circuit is constructed using component values R = 100 2 and L = 1.5 mH along with a sin...

A: Current: This is the time rate of the change of charges and its unit is ampere.

Q: Give example problems for admittance. Formula: Y = G ± jB = 1/Z.

A: Admittance problem

Q: 3. Determine K, which makes damping ratio of the system 0.5. For this Kp find w, and tp, ts, tp and ...

Q: 5. Consider the transfer function given by: 100 G(s) =- s +15s +100 Find the peak overshoot of the s...

Q: The voltage applied to a purely inductive coil of self-inductance 15.9 mH is given by the equation v...

Q: f(t) t -3T

Q: For R1=R1=3 kΩkΩ, R2=R2=4 kΩkΩ, R3=R3=2 kΩkΩ, and a source E=E=219 VV, find the total resistance of ...

Q: a. Simplify the circuit below such that there is only one voltage source and one equivalent resistor...

A: Note: As per the policy we can solve only one question at once, please re-upload the remaining quest...

Q: Class À Amplifier questions A. If the amplifier input signal is 10 mV, what is the effective output...

A: Given: Consider the following circuit: To find: A. If the amplifier input signal is 10 mV, what is ...

Q: (a) DN; (b) Da (c) \D1l;

A: As per our company guidelines we are supposed to answer only first 3 subpart kindly repost other par...

Q: Question # 2: A 2000/400 V, 100 kVA, 60 Hz step-down single-phase transformer has a primary and seco...

Q: Discussion: 2. 1. Compute the Band Width and Pow r of AM-DSB-SC ? 2 What is the application of AM-D....

A: The answer of the following questions are

Q: 1. State ohm's law

A: “Since you have asked multiple question, we will solve the first question for you. If you want any s...

Q: Derive the formula for Average Power, Pavg = VI cosθ watts, where V is the root-mean-square (rms) vo...

A: To derive the formula for Average power Pavg = VI cosθ watts

Q: The maximum value of the sinusoidal voltage wave generated in one coil of an alternator is 12v. How ...

Q: A 50 uF capacitor is connected across a 230V, 50Hz supply. Calculate a) the reactance offered by the...

Q: R1 R4 3.0 kn 1.5 kn +10V +V -V IN -10V R2 2.5 kn Figure 4.7

Q: In The Potentiometer Experiment: In order to achieve high accuracy, the slide wire of a potentiomete...

A: Generally the slide wire of a potentiometer should be as long as possible , in order to have the hi...

Q: 2. For the circuit in Figure 7-41, determine the following: (a) the power dissipated in the transist...

Q: 1. According this circuit apply? to your experiment al results where does

A: BJT and MOSFET are the class of transistors used in analog electronics. They are widely used nowaday...

Q: Charge stored in depletion layer (coulomb) NNe AW N+N Forward current (A) 1 1,+1, D, 1,- Ag n LN D, ...

Q: Figure below shows a 4-bit digital-to-analogue converter of type R-2R ladder. Given the converter ha...

A: In a 4 bit digital to analog converter like above we can firstly find the equivalent source voltage ...

Q: Refer to the given circuit below. Determine the equivalent resistance across terminals a and b if R1...

Q: In an FM broadcast transmitter, the carrier signal is being deviated between 103.505MHz and 103.495M...

Q: Use only simple circuit techniques to find the power of the 3iz source 32n DIA iz

Q: The peak load on a 50 MW substation is 36 MW. It supplies power for feeders whose connected loads ar...

A: In this question we need to find a diversity factor of substation. The value of diversity factor is ...

Q: The Frequency response of an LTI system is H(w) = The impulse response of the 1+w2" system is h(t). ...

Q: The maximum value of the sinusoidal voltage wave generated in one coil of an alternator is 12 volts....

Q: Using Cuss 10I, - 712 -31,+21,t 61, =4 %3D

Q: 2. A pair of automotive headlamps is connected to a 12 V battery via the arrangement shown in figure...

A: Given circuit,

Q: Determine the following A) Voltage gain (Av) B) Current gain (Ai) C) Determine the Peak-to-Peak out...

A: As per company guidelines we can solve only first three sub parts kindly post another parts separate...

Q: A 40uF capacitor is connected across a 230V, 50HZ supply. Calculate a) the reactance offered by the ...

Q: Give at least 3 important specifications of a rectifier circuit. For every specification, explain wh...

A: To convert Alternating supply to Direct supply DC, Rectifiers are used. It can controlled as well as...

Q: Point charges of 50 nC each are located at B (-1,0,0). C(0,1,0) and D (0,-1,0) in free space. Find t...

A: We need to find out force on given charge particle due to others charge particle .

Q: Calculate the voltage induced in the armature winding of a 4-pole, lap-wound, de machine having 728 ...

Q: Practice Question 2 A bridge circuit shown in Figure Q2 is used to measure the relative permittivity...

A: Given: A bridge circuit shown in the figure below is used to measure the relative permittivity of a ...

Q: The impulse response of an LTI system is h(t). The Laplace Transform of h(t) is 2 H(s) =+ . The inpu...

A: The solution is given below

Q: نقطة واحدة ?What is the (X,Y,Ci) for this circuit vcc Key - Space 5.0V U3 U4 XOR2 XOR2 US U6 Y U1 Ke...

A: Given circuit:

Q: the inductor as a function of t

A: Resistance in parallel-1Req=1R1+1R2+1R3+........... Resistance in series-Req=R1+R2+R3+...........

Q: Determine the current l2 in the circuit below in polar form. Write the magnitude only in four decima...

Q: 1- Find phase margin, gain margin, gain crossover frequency, phase Crossover frequency, delay margin...

A: The stability of the system can be calculated by using the bode plot. The Gain margin and Phase marg...

Q: 1. Given the operational amplifier below. a. Solve for the input voltage, if the feedback resistors ...

Q: What is the mass of an electron?

A: What is the mass of an electron?

Q: Q2. Find the current through the RI (60 2) resistor of the network shown in figure below, using mesh...

Q: Design the given circuit shown. Finalize answers as: Idavertgmin= Idpkrtgmin=:Vdpkrtgmin=: Isavertgm...

Question

Three capacitors 3 µF, 5µF, and 9µF are connected in parallel with an 9V battery. Determine the: (2) charge drawn from the battery.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

You are working in an industrial plant. You have been instructed to double the capacitance connected to a machine. The markings on the capacitor, however, are not visible. The capacitor is connected to 560 volts and an ammeter indicates a current of 6 amperes flowing to the capacitor. What size capacitor should be connected in parallel with the existing capacitor? What is the minimum AC voltage rating of the new capacitor? What is the minimum DC voltage rating of the new capacitor? What is the minimum KVAR size that can be used in this installation?
You find that a 25-F capacitor connected to 480 VAC is defective. The storeroom has no capacitors with a 480-VAC rating. However, you find two capacitors rated at 50 F and 370 VAC. Can these two capacitors be connected in such a manner that they can replace the defective capacitor? If yes, explain how they are connected and why the capacitors will not be damaged by the lower voltage rating. If no, explain why they cannot be used without damaging the capacitor.
You are an electrician working in an industrial plant. You discover that the problem with a certain machine is a defective capacitor. The capacitor is connected to a 240-volt AC circuit. The information on the capacitor reveals that it has a capacitance value of 10 mF and a voltage rating of 240 VAC. The only 10-mF AC capacitor in the storeroom is marked with a voltage rating of 350 WVDC. Can this capacitor be used to replace the defective capacitor? Explain your answer.
Which of the following is not a requirement for an electric circuit? a. a source b. a path c. a load d. a signal light
A resistance of 12 ohms and capacitance of 0.01 farad is connected in series with a 200 volts battery. Find the charge after 0.5 second and the current after 0.4 second
163. A capacitance is charged to 100 V and has 100 micro coulombs of charge. The value of capacitance will be
80 V voltage is applied to the circuit with capacitors in the figure. a) Find the equivalent capacity? b) Find the total charge? c) Calculate the charge on capacitor C?
Three 20uF capacitors are connected in series with each other. A 1k ohm resistor and an LED connected in series to each other as well, but branched in parallel to all three capacitors. How long would the LED stay lit after power is removed? What current would flow through it during the charge cycle if VT=9v?
The circuit in the figure below contains two resistors, R1 = 4.00kΩ and R2 = 5.00kΩ, and two capacitors, C1 = 4.00uF and C2 = 5.00uF, connected to a battery with emf E = 120V. If no charges exist on the capacitors before switch S is closed, determine the charge q1 on capacitor C1 1.00ms after the switch is closed. Determine the charge q2 on capacitor C2 1.00ms after the switch is closed.
Three capacitors of 2, 3 and 6 microfarads are connected in series to 500 volts d.c. Find (1) the charge on each capacitor and (2) the energy stored in the 6 microfarad capacitor if connected to the supply.
3. A 45 uF capacitor and a 30 uF capacitor are connected in parallel to a 25 V battery. What is the total capacitance of the circuit? b. What is the voltage, V, across capacitor, C,? c. What is the voltage, V, across capacitor, C? d. How much charge, Q, is on capacitor, C,? How much charge, Q2, is on capacitor, C,? a. e.
a.) What is the resistance in the circuit a long time after the switch is closed? b.) What is the current through both resistors a long time after the switch is closed? c.) What is the current through the inductor a long time after the switch is closed?