This method of leak detection is simple and practical as it does not require expensive equipment, sometimes the use of antifreeze is required. c) ultrasonic detection b) ultraviolet light d) simple auditory inspection a) soap solution   Which of the following groups of refrigerants has the greatest impact on the ozone layer? b) HCFC d) HFC a) CFC c) HC

Q: A 75-gallon vessel is prepared for placing into service. Use a sweep-through purging method, to…

A:

Q: be done in practice. Focus on (1) choice of solvent (II) choice of sample cuvette material (III)…

A:

Q: [Evaporation] A triple effect evaporator concentrates a 10% caustic soda solution from 10% to 50%…

A: Introduction  Chemical engineers refer to a multiple-effect evaporator as a device for effectively…

Q: Calculate the %CO2 in the stack gas analysis resulting from the complete combustion with 100% excess…

A: Given that, Fuel: Formaldehyde CH2O %excess air = 100% It is required to calculate the %CO2 in the…

Q: The rate of effusion of CO2 gas through a porous barrier is observed to be 8.13 x 10 mol/h. mol/h…

A: The rate of effusion of CO2 gas through a porous barrier r = 8.13 × 10-4mol/hr Molecular weight of…

Q: Powdered milk can be produced from liquid milk in a three-stage process: (1) vacuum evaporation in a…

A: The reason for three-stage process is preferable to a single stage process involving just spray…

Q: standardization of kmno4 and the determination of ferrous sulfate

A: KMnO4 in the burette is of unknown concentration Ferrous iron 0.1M to be pipette. Indicator is as…

Q: Silica gel is to be used to separate a mixture of butane and butylene. The feed containing 55%…

A: Given :Feed at the bottom contains-Basis feed= 100 mol (supposed)Butane= 55% = 55 molButylene= 45%…

Q: In the figure below there are two different drying kinetics curves, analyze them and answer: a)…

A:

Q: 3. An evaporator is used to concentrate cane sugar solutions. A feed of 10000 kg/day of a solution…

A:

Q: Design of Absorption Tower A mixture of gas containing 90.5% mole % Hydrogen peroxide (H₂O2) and…

A: It is given that,the fraction of methanol recovered is mole fraction of methanol in the gas mixture…

Q: Plot the the attached data - Absorbance vs. Time

A: According to the Beer-Lambert law, a linear relationship between the concentration and the…

Q: It has been determined that the key quality attribute affecting the shelf life is browning in a…

A:

Q: #2. (NH4)2C2O4 is soluble to the extent of 4.4 kg per 100 kg of water. A slurry is made by mixing 20…

A: Given.

Q: Identify the species that is oxidized and the speciesthat is reduced when the lead-acid battery is…

A: Given that, The lead-acid battery is charging. In this process, the reactions is: Pb (s) + PbO2 (s)+…

Q: In the process of drying carrots using a parallel flow drying system, the material with a moisture…

A: Draw the diagram for the drying of carrots as follows:

Q: 80% RH, specific volume 16.5 Cu-ft of air / lb of dry air. Calculate what is wet bulb temperature,…

A:

Q: If you perform an extraction operation using a solvent that is insoluble in the original solvent and…

A:

Q: What is the difference between physical absorption and chemical (reactive) absorption?

A: Absorption is separation process in which liquid is brought in contact with gas mixtures and one or…

Q: What will be the influence of using more alkaline/acidic water in boilers? Discuss the type of…

A: Boiler is a closed vessel where water is heated. There may or may not be phase change of water to…

Q: Which of the following does not affect the apparent density of the dust? Please select one: A.Powder…

A: Apparent density of dust

Q: Explain Flue gas desulfurization.

A: The flue gas desulfurization is to be explained.

Q: QUESTION 2 What was the solvent used in preparation of the sample stock solution? O Any solvent that…

A: Its answer should be any solvent that fully dissolves the sample because sample stock solutions are…

Q: ) Determine the minimum mass of ethylene glycol (C2H¢O2) that must be dissolved in 14500 g water to…

A:

Q: A 9.86 x 10 M sample of compound X in a solvent has an absorbance of 0.349 at 528 nm in a 1.000 cm…

A:

Q: the amount of excess combustion air is normally determined by analysis of stack_____ a) the fuel…

A: Excess air is the air which is used in excess for combustion of various fuels (solids, liquid, and…

Q: Dissolve 2g of table salt in 8 g of distilled water. Calculate the percentage of solvent and solvent

A:

Q: Solvent extraction is essential for separation in the chemical industry, briefly describe four…

A: The applications of solvent extraction in the chemical industry are to be mentioned.

Q: How much water must be added to potato granules containing 13.0% moisture (dry basis) to give a…

A: The moisture in material or food is reported on a wet basis and dry basis. The dry basis water…

Q: The test kits used to determine COD contain chemicals that react with the organic compounds n an…

A: It is the measure of quality of water. Test is based on the assumption that strong oxidizing agent…

Q: A 1200 mole charge of 30 mole % naphthalene and 70 mole % dipropylene glycol it is separated in a…

A: Given, The moles of the feed to the vaporizer, F = 1200 mol The mole fraction of naphthalene in…

Q: Silica gel is to be used to separate a mixture of butane and butylene. The feed containing 55%…

A: A substance molecule's retainment onto a solid's surface or liquid's surface is an adsorption…

Q: Silica gel is to be used to separate a mixture of butane and butylene. The feed containing 55%…

A: The feed is a mixture of butane and butylene with 55% and 45% by mole respectively. Silica gel is…