The volatility of component A can be determined by O a. Ratio of total pressure of B to mole fraction of A in liquid phase O b. Ratio of total pressure of A to mole fraction of B in liquid phase O c. Ratio of total pressure of A to mole fraction of A in liquid phase O d. Ratio of partial pressure of A to mole fraction of A in liquid phase

Q: Q2- Propane burns with an oxygen concentration of 3 mole percent in the flue gases, determine the op...

A: Complete combustion reaction,C3H8+5O2→4H2O+3CO2. Actual combustion reaction, C3H8+ Air→H2O+CO2+N2+O2...

Q: I want the answer

A: Pressure head in pipe A is asked.  

Q: Question about reactor design

A: The Volume of bigger reactor(Vb)=100m3 The volume of smaller reactor(Vs)=50m3 CAo=CBo=1gmol/lit Volu...

Q: An isotherm analysis was performed on a surface soil and an aqueous solution of toluene. Six 1-L bea...

A:     Mass of adsorbent (soil), m = 10 g The volume of the beaker, V = 1 L Time for adsorption, t = 24...

Q: 1. Write the combustion equations for (a) Complete combustion in theoretical air of 1 mol of gasolin...

A: Note: Since we are entitled to answer only 1 question, we will answer the first one as it is not men...

Q: Please, I need to solve the question in less than an hour.

A: Given, Weight of sample=2 g =2000 mg Weight of Mn3O4 precipitated=0.126 g = 126 mg FW (O)=16 3Mn203↔...

Q: Liquid acetone (CaH.O) is fed at the rate of 4OOL/min into a heated chamber, where it evaporates int...

A: Given InfoInlet flow rate of acetone=400L/minInlet flow rate of nitrogen=419 m3/minCombined gas pres...

Q: Instructions: Copy and solve each problem as neatly as possible and show complete solution. Round ev...

A: Let x be the kgs of overhead product formed Let y be the kgs of Alcohol and water mixture supplied.

Q: The gas flow rate is 2.5×10° scf/day from a gas reservoir at an average temperature and pressure of ...

A: Given data: Gas flow rate = 2.5×00 scf/day Average temperature = 150 0F Average pressure = 170 atm S...

Q: The time at which the initial concentration of reactor dropped (decreased) to 50% of its oringial va...

A: Concentration of a reactant (chemical species) represents the ampleness of that reactant per volume ...

Q: / Determine the molar volume of butane at 510 K and 25 bar by each of the following a- Ideal gas law...

A: For butane, Tc = 425.5K Pc = 38bar ω = 0.193 Given: T = 510K P = 25bar = 25*105 Pa To find : V@n=1

Q: A piston-cylinder assembly contains 2.0 lbm of air at a temperature of 540 °R and a pressure of 1 at...

A: A piston-cylinder assembly will work by the pressure of the gas. The piston is placed inside the cyl...

Q: Two process streams are mixed to form a single stream. Only the flow in themixed stream is known. A ...

A: The ratio of the flows in the two original streams is to be determined.

Q: I am allowed to work with someone but I do not understand this Calculations : Show neatly labeled a...

A: The volumetric additions are taking place with the help of volumetric cylinder. The volumes of cylin...

Q: Many chemicals generate emissions of volatile compounds that need to be controlled. In the process s...

A:

Q: The specific reaction rate is dimensionless if the reaction is zero order Select one: True OR Fals...

A: The solution and explanation are given below.

Q: A piece of beef steak 5 cm thick will be frozen in the freezer room -35 ° C. This product has a mois...

A: Given:Ta=-350Cmm=0.73ρf=970kgm3k=1.1Wm.KTf=-1.750Ch=10Wm2.KL=333.22 kJkg

Q: Carbureted water gas is produced in the same way as blue water gas but in the presence of cracked oi...

A: Because you have posted a question with multiple subparts, we will solve the first three for you. If...

Q: Estimate the terminal velocity of a particle 1mm in diameter with a density of 5000kg/m^3 settling i...

A: Since there are 2 questions posted, according to our guidelines we are allowed to answer to only one...

Q: 1. Atmospheric air at 1.02 bar 22°C initially occupying a cylinder volume of 0.015m3 is compressed r...

A: P1 = 1.02 bar P2 = 6.8 bar V1 = 0.015 m3 T1 = 22 + 273 = 295 K Polytropic index for air is determine...

Q: Show the COMPLETE SOLUTIONS and DIAGRAM (pv and Ts) including the switching of table and interpola...

A: Given,  Mass flow rate, m˙=35 kg/s Boiler pressure, P2=P3=3MPa=3000KPa Condenser pressure, P1=P4=50K...

Q: Question about mass and energy balances:

A: Fermentation is a metabolic process that produces chemical changes in organic substrates through the...

Q: Two process streams are mixed to form a single stream. Only the flow in themixed stream is known. A ...

A: A mass balance is defined as an application of conservation of mass to the analysis of physical syst...

Q: What is the rate expression for this reaction if the stoichiometric equation is written as

A:

Q: From a 0.002M KMnO4 stock solution, prepare 50mL of the following concentrations 7, 14, 20, 30 and 5...

A: The concentration of a solution is a measure of the amount of solute that has been dissolved in a gi...

Q: Oleum produces fumes of a. SO2 + H2SO4 b. SO2 c. H2SO4 d. SO3

A: Oleum is also known as pyrosulphuric acid and has the formula H2S2O7. It is made by dissolving SO3 v...

Q: 2) Number of Ideal Stages for a Hydrocarbon Distillation A four component mixture of ethylbenzene (z...

A: Component Feed Distillate Bottom  αi Ethylbenzene 0.06×80 = 4.8 4.8 - 1.25 p-xylene 0.4×80 = 32 ...

Q: The final volume of buffer solution must be 100.00 mL and the final concentration of the weak acid m...

A: The given data is as follows.        pH of buffer = 4.0,         volume of the solution (V) = 100 mL...

Q: 3. An ideal Otto cycle has a compression ratio of 10.5, takes in air at 90 kPa and 40°C, and is repe...

A: (a) The thermal efficiency of the Otto cycle is to be determined.   The thermal efficiency is given ...

Q: For the reaction A--> B carried out in a batch reactor with a reaction rate –rA = 0.01CA mole/(L*...

A: Given, A→B-rA=0.01CAmole/L·min.........1 Conversion,XA=0.4 From equation (1), we get: k=0.01

Q: With a porous membrane known to work in the Knudsen area; Knudsen diffusion a. H 2 / N 2 b. Ideal me...

A: Knudsen diffusion takes place when the scale length of a system is smaller than the mean free path o...

Q: The reason for more time taken during isochoric cooling compared to isochoric heating is

A: The explanation is given below.

Q: What is the Molar concentration of 5000-1 ppm of Na2SO4 solution (At.w. Na=23, S=D32, .O=16)

A: Concentration Of Na2SO4 = 5000ppm To calculate: Molar Concentration of solution?  

Q: 1/2? + ?→1/2? + 2? A reaction with a stoichiometric equation as given above has the following rate e...

A: Elementary reactions are the reaction in which the concentration terms in rate equation are raised t...

Q: The front end of a typical crude oil refinery is illustrated in the BFD shown below. Crude oil, afte...

A: Distillation is a separation process in which the light hydrocarbons are separated from the heavy hy...

Q: medium 200g Estima te the time (minu tes) it would take to microwe ve polato in refrigerder 9 1000w ...

A: In conduction, energy flows through a material but the material itself does not move. In convection,...

Q: A solution is prepared by mixing 5.00 mL of 0.00100M iodine, 10 mL of 0.500M HCl, and 10 mL of 2.00M...

A: A Solution containing 5.00 mL of 0.0010 M  iodine      10ml of .005 HCl     10 mol of  2.00 M Aceton...

Q: A food product wants to be produced in a small round shape (pellet) by freezing it in a water blast ...

A: Given that, Operating temperature of air freezer Ta = – 35 oC Initial temperature of product = 25 0C...

Q: If the reaction rate is 2nd order, the unit of reaction order n is a. mole/L b. 1/min c. mole/(L.m...

A: If 2nd order of reaction take place. Then unit of reaction order n is ? 

Q: A mixture of solid particles B & A having a size range of 5-9mm is to be separated by classification...

A:

Q: i- Convert the Cp equation so that T can be inserted in the equation in °R, and the units of Cp will...

A: T0F=T(0R)-459.67 hence new Cp relation would be Cp=9.89+0.8273×10-2(T-459.67)-0.3783×10-5(T-459.67)2...

Q: Calculate the rate of diffusion of n-Butanol (A) across a film of non-diffusing water (B) solution o...

A: N-Butanol (A) is diffusing through non-diffusing water (B) i.e. it is steady-state diffusion of A th...

Q: 2. A piece of beef steak 7 cm thick will be frozen in the freezer room -30 ° C. This product has a m...

A: freezing time equation using plank constant is given by; tF={ ρf Lf/(Tf-Ta )  } P'a/h+R'a2/k where; ...

Q: Please answer very soon will give rating surely

A: A 3-step equation in which the second step is is rate-determining step as it is slow. The reaction o...

Q: Producer gas analyzing 25.3% CO, 13.2% H2, 0.4% CH4, 5.4% CO2, 0.5% O2, and 55.2% N2 is burned in ex...

A: Basis : 1 mole of feed producer gas Feed analysis component mol% mol CO 25.3 0.253 H2 13.2 0....

Q: 3. A feed stream flowing at a rate of 300 mol/h contains 20 mol% of components 1 and 80 mol% compone...

A: Flowchart of the process is the diagram indicating all the feed and process streams and equipment. F...

Q: The Heart of the Ocean is the name of a fictitious diamond featured in the vastly overrated 1997 fil...

A: Hydrostatic pressure is the pressure that is exerted by a fluid at equilibrium at a given point with...

Q: 3. Compression and Cooling of Nitrogen Gas A volume of 65.0 ft3 of N2 gas at 90°F and 29.0 psig is c...

A: Given; Initial volume V1 = 65.0 ft3 Initial temperature T1 = 90°F + 459.67 = 549.67°R Initial pressu...

Q: Estimate AHvap, in Btu / Ibm, for: to. ethane at -122 ° F. Use the Antoine equation and the Clausius...

A:

Q: a) Why does the boiling point increase and freezing point decrease of a solution when compared to th...

A: When a solute is dissolved in a solvent, the solute particles interact with the solvent particles. D...

Convective Mass Transfer between Phases

Mass transfer means the transport or movement of mass using streams, phases, components, and so on from one location to another.