The viscous fully developed flow in a pipeline has a parabolic velocity distribution . Determine name of flow and estimate flow Reynolds Number Re Lütfen birini seçin: a. Poiseuille Re= 5000 b. Poiseuille Re= 1200 c. Prandtl Re= 1200 d. Couette Re= 5000 e. Couette Re= 1200

Q: )Water 10°c flows down through a 53.13 deg, nclined, converging pipe section as shown. The fiow…

A:

Q: 9. The orifice in Fig. 57 is 2 in. in diameter and is sharp-edged with - 0.63 and C, = 0.97. The…

A:

Q: T? D5 dx b) If we assume that the Darcy-Weisbach equation can be used for the head loss, how vill…

A: ∫x=0x=LdPdx=∫D1D232ρQ2π2D5dDdxP1-P2ρgL=32Q2π2D5gD2-D1LP1-P2ρg=32Q2π2D5gD2-D1   →Pressure gradient

Q: air-fuel ratio for this combustion process.

A: Determine the air-fuel ratio for this combustion

Q: For the horizontal series-parallel system of the figure below, all pipes are 7 cm diameter asphalted…

A: Given: d = 7cm ε = 0.12 mm ρ= 998 kg/m3 μ=0.001 kg/m.s Q= 0.0269 m3/s L.A = 250 m L.C = 150 m…

Q: 5. A 50-m duct is 0.060-m in diameter (Figure 2). Calculate the flow rate (m³/sec). Pfluid=917 kg/m³…

A:

Q: Compute the volumetric gas flow in the duct (m3/s)

A: Pitot tube Pitot tube is a flow measurement device used to measure fluid flow velocity. Pitot tube…

Q: The maximum velocity with which a fluid 3. having density of 90kg/m and viscosity 0.1 Ns/m2 can flow…

A:

Q: 1200 m long carries 0.020 m^3/s of heavy fuil oil with S= 0.904 and kinematic

A:

Q: A pump delivering 0.23 m3/s of water has a 304.8mm diameter suction flange and 254mm discharge…

A: Given:Water flow rate, Q=0.23 m3/sSuction flange diameter, ds=304.8 mm=0.3048 mDischarge flange…

Q: A is 2000 m gas flow line (6-in) and B is 2500 m liquid flow line (4-in) should be onnected both…

A:

Q: Take water density p = 998 kg/m° and dynamic viscosity u = 0.001 kg/(m.s). The total flow rate is…

A:

Q: 5. For the solid-propellant rocket in Fig. 3, compute the rate of mass loss of the propellant,…

A:

Q: 4.W.4_ Given: Vehicle Velocity = 50m/s discharge = 5 m/s O = IB0° VI neglect frictions Find the…

A:

Q: Solve for velocity profile using Navier-Stokes Equation; not shear stres

A: Reynolds number is the ratio of inertia force to the viscous force:- Re=Inertia forceViscous…

Q: Determine whether of the following flows are irrotational, and find the velocity potential function,…

A:

Q: he figure shown below is a series pipeline system used to draw a fluid from a lower source open tank…

A: Given       Volume flow rate: Q=0.015 m3/s                     Length: Ld=100 m Elevation…

Q: Jet water in Pipe with chameter equal to Somn to velocity-30 - divided into two branches with…

A: The velocity will remain the same in both the pipes. V=V1=V2 Now,

Q: Hot oil is cooled in a double-tube counter-flow heat exchanger. 2 cm diameter copper inner wall…

A: Inner diameter = 2 cm Outer diameter = 3 cm Mass flow rate of water = 0.5 kg/s Mass flow rate of oil…

Q: 2 For a flow of oil (m = 0.1 N.s/m, S.G. = 0.28 ) through a horizontal, straight, smooth 5 cm…

A: The given data are: m=0.1 Ns/m2sg=0.28d=5 cm=0.05 mQ=14 m3/hL=10 m Here, m is the viscosity, sg is…

Q: 2. Ciren Inlet alr How is 500 ft/cnd cabauef gae has spead 3500 H/sc0ond flow parssura - Inlet and…

A: Mass flow rates are calculated at inlet and outlet. Momentum equation is used to calculate the…

Q: nozzle With X8. E Sam holes pump = l16 L/mn pi pe dia = 9.6 mm Nbzzle = X 8 Smm holes pump Assume…

A: A pump delivers or flows liquid, but it does not exert pressure. It generates the flow required for…

Q: By this theory, all else being equal, a doubling of the pressure difference corresponds to increase…

A:

Q: Water (SG 1) flows through the diverging frictionless pipe shown at flowrate of Q with the given…

A: Given Data: The flow rate of water is, Q˙=500 m3/h=500 m3/h×h3600 s=0.138 m3/s. The pressure at the…

Q: A piston-cylinder is producing a viscous oil flow, which has the flow rate of Q, radius R=1.5 mm,…

A:

Q: ough a s = 600m/s,T stream

A:

Q: Q.3 b) A total of 14 litres per second of oil is pumped through two pipes in parallel, one 12 cm in…

A:

Q: Water at 20 °C flows at 4 m/s in a 200 mm smooth pipe. Calculate the air velocity in a 100 mm pipe…

A: Given Data

Q: Water (density 1000 kg/m) flows through an inclined pipe of uniform diameter. The velocity. pressure…

A: According to information we have A sloping pipe of a uniform diameter flows through water (dansity…

Q: Given that: • Pipe diameter: 0.450 m Crude oil: Kinematic viscosity = 0.0000232 m2/s Water: Dynamic…

A:

Q: ven A)A horizontal gas well of 2000 ft long is draining an area of approximately 120 acres. The…

A:

Q: P₂ * 1/3 + 2,5-1,8 = 2/3 +² ₂ === Y OB.h₂ = (2₂-2₂) +h, OCP₁ 7 -2₁ - 1₁ + 1 = 21/2² +2₂ 7 - +²₂+. 2g…

A: Volume flow rate: Q=0.015 m3/s Elevation difference:  h=8.0m Suction line:…

Properties of Fluids

The term fluid represents a type of substance that can easily change its shape under any external pressure/force and can flow. Fluids can acquire any shape in which it is stored and can resist normal stresses but cannot resist shear stress in rest condition. Whenever external shear stress is applied to fluids, it starts to flow. The fluids may be liquid or gas. Example- water, air, etc.