The van Deemter equation decribes how the column, stationary phase, and linear velocity influence plate height. The equation is HA+ + Cux B Ux Match each symbol with its term in the van Deemter equation. 1000 plate height linear velocity multiple path (eddy diffusion) equilibration time (mass transfer) longitudinal diffusion A B Answer Bank H Ux For an open tubular column (not capillary electrophoresis), which term(s) in the van Deemter equation does(do) not affect the plate height? O multiple paths

The van Deemter equation decribes how the column, stationary phase, and linear velocity influence plate height. The equation is HA+ + Cux B Ux Match each symbol with its term in the van Deemter equation. 1000 plate height linear velocity multiple path (eddy diffusion) equilibration time (mass transfer) longitudinal diffusion A B Answer Bank H Ux For an open tubular column (not capillary electrophoresis), which term(s) in the van Deemter equation does(do) not affect the plate height? O multiple paths

Principles of Instrumental Analysis

7th Edition

ISBN:9781305577213

Author:Douglas A. Skoog, F. James Holler, Stanley R. Crouch

Publisher:Douglas A. Skoog, F. James Holler, Stanley R. Crouch

Chapter27: Gas Chromatography

Section: Chapter Questions

Problem 27.26QAP

See similar textbooks

Similar questions

The sedimentation coefficient for a protein in solution is determined to be 4.3 S, and the diffusion coefficient to be 5.5x10-11 m2s-1 (vb = 0.74 mLg-1; density = 1.0 gmL-1; and viscosity = 1.0x10-3 Pas-1). Use this information to calculate the molar mass (kgmol-1) of the protein. Assume temperature of 298 K.
An amino acid moves randomly through water with steps of about 3 angstroms (3 x 10^-8 cm) in length at a rate of 1 x 10^10 steps per second. This substance is passing through a reverse phase HPLC column which has a plate height of 0.010 cm. 1. Estimate the diffusion coefficient for the amino acid in water. 2. Calculate the width at the base of the elution zone after the amino acid has migrated 50 cm through the column
Aluminum atoms are to be diffused into a silicon wafer using both predeposition and drive-in heat treatments; the background concentration of Al in this silicon material is known to be 2.5 x 101⁹ atoms/m³. The drive-in diffusion treatment is to be carried out at 1050°C for a period of 4.0 h, which gives a junction depth x; of 3.0 μm. Compute the predeposition diffusion time at 950°C if the surface concentration is maintained at a constant level of 2 x 1025 atoms/m³. For the diffusion of Al in Si, values of Qd and Do are 3.41 eV and 1.38 x 10-4 m²/s, respectively. min
2. Consider the diffusion of oxygenthrough alow density polyethylene (LDPE) sheet 15 mm thick. The pressures of oxygen at the two faces are 2000 kPa and 150 kPa, which are maintained constant. Assuming conditions of steady state, what is the diffusion flux (in cm³ STP/ cm2-s) at 298 K?
7. The sedimentation and diffusion coefficients for myoglobin in dilute aqueous solution at 20°C are 2.04 x 10-13 s and 1.13 x 10-10 m²s¹, respectively. The partial specific volume of the protein is 0.741 cm3g-1, the density of the solution is 1.00 x 10-3 gcm³ and the coefficient of viscosity of the solution is 1.00 × 103 kgm 1s¹. Calculate (a) the relative molecular mass and (b) the frictional ratio of this protein. What is the probable shape of a dissolved myoglobin molecule? U n
A method of quantitative determination of the concentration of constituentsof a sample analyzed by gas chromatography is area normalization. Thiscomplete elution of all sample constituents is required. Thearea of each peak is measured and corrected for the detector response to the diffe- renteseluatos. This correction involves dividing the area by an empiricalcorrection factorDetermined. The concen ration of the analyte is found from the ratio between itscorrected and the total corrected area of all peaks. For a chromatogram containing threerelative areas were determined as 16.4; 45,2; and 30.2, in the order ofincreased retention time. Calculate the percentage of each compound if therelative responses from the detector are 0.65, 0.73 and 0.85, respectively.
1.13 Which of the following is a parameter that cannot be obtained by a typical DLS experiment? O The hydrodynamic radius O The diffusion coefficient O A polydispersity index O A sedimentation coefficient
Using the regression equation below, calculate the molar absorptivity with 1cm path length y= 0.0068x-0.0026
What other method besides conductivity can be used to determine CMC (critical micelle concentration)?
Determine the relative concentration (C/Co) of a contaminant as a function of depth (Le., distance from the source) brought about by molecular diffusion alone in a semi-infinite domain. Assume Du-10-10 m²/s. Plot the curves for 10, 100, 1,000 and 10,000 yr on log-log coordinates for concentration ratios varying 1.0 to 0.01 and for depths from 0.01 to 100 m.
One of the most important reactions in biology is photosynthesis. In this complex chemical process, plants combine molecules of carbon dioxide and water to create glucose and oxygen. The reaction looks something like this: CO2 + H20 – C6H1206 + 02 Of course the number of atoms don't balance on the two sides. You might be able to intuit your way to the correct counting (stoichiometry), but let's do it systematically by setting up equations. (a) Write the reaction as a CO2 + b H20 -→ c CGH1206 + d O2 where a, b, c, and d are meant to be integers adjusted so that the number of each kind of atoms balance on each side. For this reaction, we have three kinds of atoms that must balance: carbon (C), hydrogen (H), and oxygen (0). Write three equations for a, b, c, and d that, if satisfied, will guarantee that the number of atoms of each kind are the same on each side of the reaction. (b) Find the smallest set of integers that will satisfy these equations. First, solve for a. (c) Solve for b.
Q(3): Figure below shows a plot of the logarithm (to the base 10) of the diffusion coefficient versus reciprocal of absolute temperature for the diffusion of carbon in iron (a-Fe). Determine values for the activation energy and the preexponential? 10-10 C in a-Fe 10-12 10-14 10-16 10-18 0.5 1.0 1.5 Reciprocal temperature (1000/K) Diffusion coefficient (m2/s)