The use of a continuous atmospheric gravity separator which is also known as decanter is widely applied in separating immiscible liquids that are having distinct densities. Figure 1 shows a decenter that separates two immis cible liquids (Liquid A and B) in which liquid B having higher density than liquid A. The feed mixture enters the unit at one end of the separating vessel and flows slowly to the other end which eventually cause the mixture to separate itself into two distinct layers. Liquid A and B flow out at the overflow lines to the respective collection tank which are open to atmosphere. For a properly designed decanter and assuming that the frictional resistance to the flow of the liquid is essentially negligible, analyze the e ffect of the density of both liquids to the vertical height of the liquid B (hBi & hB2).

The use of a continuous atmospheric gravity separator which is also known as decanter is widely applied in separating immiscible liquids that are having distinct densities. Figure 1 shows a decenter that separates two immis cible liquids (Liquid A and B) in which liquid B having higher density than liquid A. The feed mixture enters the unit at one end of the separating vessel and flows slowly to the other end which eventually cause the mixture to separate itself into two distinct layers. Liquid A and B flow out at the overflow lines to the respective collection tank which are open to atmosphere. For a properly designed decanter and assuming that the frictional resistance to the flow of the liquid is essentially negligible, analyze the e ffect of the density of both liquids to the vertical height of the liquid B (hBi & hB2).

Name: analyze the effect of the density of both liquids to the vertical heig
Uploaded: 2024-03-20T06:56:55.000Z
Channel: Bartleby
Description: analyze the effect of the density of both liquids to the vertical height of the liquid B The use of a continuous atmospheric gravity separator which is also known as decanter is widelyapplied in separating immiscible liquids that are having distinct

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

QUESTION 2 A new induced raft cooling tower is circulating 120 000 L/h of water that is cooled from 50 °C to 22 °C. How much blow-down and make-up is required to maintain the concentration of dissolved solids in the circulating water at four times the concentration in the make-up water? Assume the following: - The evaporated water contains no dissolved solids so all solids entering the system in the make-up must be removed by blow-down and windage. - The windage value of the induced draft cooling tower is 0.3% for each 5.6 °C. - The evaporative losses value is 1.1%.
2. Two hundred and fifty pounds of a mixture of 10 mol% propane 20% n-butane, and 70% n-pentane is completely vaporized in a pipe still in one hour. At the outlet, the temperature anc 433 F and 600 psia. What is the volumetric flow pressure are rate in cfm at the outlet conditions? Answer: The physical properties of the gas are: Tc Pc MW Propane 369.9 K 665.8 R 42.0 atm 44 Butane 425.17 K 765.31 R 37.47 atm 58 Pentane 469.8 K 845.64 R 33.3 atm 72
A steam trap is a device to purge steam condensate from a system without venting uncondensed steam. In one of the crudest trap types, the condensate collects and raises a float attached to a drain plug. Whenthe float reaches a certain level, it “pulls the plug,” opening the drain valve and allowing the liquid to discharge. The float then drops down to its original position and the valve closes, preventing uncondensed steam from escaping.(a) Suppose saturated steam at 25 bar is used to heat 100 kg/min of an oil from 135°C to 185°C. Heat must be transferred to the oil at a rate of 1:00 x 10 4 kJ/min to accomplish this task. The steam condenses on the exterior of a bundle of tubes through which the oil is flowing. Condensate collectsin the bottom of the exchanger and exits through a steam trap set to discharge when 1200 g of liquid is collected. How often does the trap discharge?(b) Especially when periodic maintenance checks are not performed, steam traps often fail to close completely…
11. 225kg/hr of air at 40°C enter a mixing chamber where it mixes with 540kg/hr of air at 15 C. Calculate the temperature of the air leaving the chamber assuming steady flow condition. Assume that the heat loss is neglected A mass of air has an initial pressure of 1.3 MN/m?, volume 0.014m' and temperature 135 "C. It is expanded until its final pressure is 275KN/m and its volume becomes 0.056m'. Determine a- the mass of the air b- the final temperature of the air, take R=0.287kJ/kgK. A quantity of gas has initial pressure and volume of 0.1MN/m and 0.1 m', respectively. It is compressed to a final pressure of 1.4MN/m² according to a law PV 26=C. Determine the final volume of the gas. A quantity of gas has an initial volume and temperature of 1.2 I and 150°C, respectively. It is expanded to 3.6 1 according to the law PV4C. Determine the final temperature of the gas. 15. (22.4 "C) 12. (0.155kg,73"C) 13. (0.01253m) 14. (0°C) 0.23kg of air has an initial pressure of 0.17 Mpa and temperature…
Pls solve accurate and fast A 1-kg steam-water mixture at 1.0 MPa is contained in an inflexible tank. Heat is added until the pressure rises to 3.5 MPa and the temperature to 400: Determine the heat added
8. The exact differential equation of enthalpy can be expressed as below: dH=-uCpdp + C₂dT where C: constant pressure heat capacity u: Joule-Thomson coefficient μl= a) Derive the exact differential equation of enthalpy from the general exact differential equation of enthalpy: = (3), dp + (7) dr T dH = b) Considering that you use nitrogen gas to make a temperature drop to an isenthalpic system, how much pressure drop is required to cool the system by 20 K? The Joule-Thomson coefficient of nitrogen is u 3 0.27 K atm¹. c) Prove that the Joule-Thomson expansion can occur without change of enthalpy (isenthalpic process).
Problem 4: A supply line contains a two-phase mixture of steam and water at 240 °C. To determine the quality of the mixture a device called a throttling calorimeter is used. In this device a small sample of the two-phase mixture is bled off the line and expanded through a throttling valve to atmospheric pressure (100 kPa). The temperature of the steam sample, T2, is measured on the downstream side of the valve. Find the quality of the mixture in the supply line for the following two cases: a. T2 = 125 °C. b. T2 = 150 °C. (Note that the two samples are superheated vapor because at the given temperatures, the temperature is above the boiling temperature for water at 100 kPa.) Steam - Water T, = 240 C Calorimeter P= 100 kPa Supply Line Flow
Presents the diagram of the problem, necessary formulas, clearance and numerical solution: 5 kg of 371.15 K water are mixed with 12 kg of water. If the final mixture has a temperature of 301.15 K, what temperature was the 12 kg of water?
From the enthalpy-concentration diagram find the location of heat removed by the condenser. Enthalpy-vapour H. Enthalpy Enthalpy- liquid x,y- mole fraction Xd- distillate composition OL X-axis. O I Y ONX
1. Two liquid steams enter a combining tube and leave as a single mixture. The first steam has a velocity of 1 m/s and cross sectional area of 3 cm^2. The second steam has a velocity of 3 m/s and cross sectional area of 3 cm^2. How long in seconds will it take for the mixture to fill up a spherical tank of radius 40 cm? 2. A container is filled with a mixture of 2 fluids having densities of 5 kg/L (fluid A) and 400 kg/m^3 (fluid .What will be the overall density (in g/cm^3) of the mixture of 1/3 of the container is filled with fluid A and 1/4 is filled with fluid B?
Evaporator single effect is used to upgrade the concentrate 10000 kg/h of tomato juice than 5% solids the total to 30% solids total. Juice enters the Evaporator at 15 °C. The Evaporator is operated with Steam (quality 80%) in 143.27 kPa. The condition of vacuum in the Evaporator allow the juice to a boil on the 75 °C. The hot kind of material dilute is 4.1 kJ/(kg °C) and the product the concentrate is a 3.1 kJ/(kg °C). Count a. The Rate of the needs of steam = ...kg/h. b. The economic steam if the temperature is condensate is released at 75 °C. = ...(kg water evaporated/kg of steam)
A tank initially contains 100 gal of pure water. Starting at t = 0, a brine containing 4 lb of salt per gal flows into the tank at the rate of 5 gal/min. The well-stirred mixture flows out at the slower rate of 3 gal/min. When is there 50 lb of %3D salt in the tank?