The two 200N blocks are pushed apart by the 15⁰ wedge of negligible weight. The angle of static friction is 12⁰ at all contacts surfaces. Determine the force P required to start the blocks moving.

The high strength, square-threaded bolt that holds the three plates together has a nominal diameter of 1 in. The coefficient of friction is us = 0.36. The mean diameter of the thread is 0.94 in. The lead of the bolt is L = 0.160 in. Neglect friction between the nut and the washer. Determine the torque one must apply in in. Ib to the nut to induce a tension of 47,500 lb. (Enter the magnitude.) in. · Ib When that tension is achieved, determine the torque in in. · Ib required to loosen the bolt. (Enter the magnitude.) in. • Ib

The man pushes on the roller with force P through a handle that connects to the central axle of the roller. If the coefficient of static friction between the 49-lb roller and the floor is s = 0.22, determine the maximum force Pthat can be applied to the handle, so that roller rolls on the ground without slipping. Assume the roller to be a uniform cylinder. Please pay attention: the numbers may change since they are randomized. Your answer must include 2 places after the decimal point, and proper unit. Take g = 32.2 ft/s2. 1.5 ft 30° Your Answer: Answer units

The man pushes on the roller with force P through a handle that connects to the central axle of the roller. If the coefficient of static friction between the 43-lb roller and the floor is g = 0.16, determine the maximum force P that can be applied to the handle, so that roller rolls on the ground without slipping. Assume the roller to be a uniform cylinder. Please pay attention: the numbers may change since they are randomized. Your answer must include 2 places after the decimal point, and proper unit. Take g = 32.2 ft/s². Your Answer: Answer 30° units 1.5 ft