The tank in figure below is filled through point 1 with velocity equal to 5 m/s and point 3 with volumetric flow rate equal to 0.012m3/s. If the level of the water h is constant, determine the exit velocity V2. If the water level h varies and V2 =8 m/s, find the rate change (dh/dt). Assume d=1m.

Q: 3. As shown in the figure below, water at 20°C is flowing through the tubes A and B, then joining…

A: Temperature of water, T=20°C Diameter of tube A, DA=1 mm=1×10-3 m Maximum velocity through tube A,…

Q: Bernoulli equation Can you please share your steps, thank you

A: V2​=17.94sft​Explanation:Step 1: Step 2: Step 3: Step 4:

Q: . A stream of methane gas enters a 7.50 cm diameter pipe with a velocity of 60.0 m/s at 27o C and…

A: A stream of methane gas enters Point1 D1=7.5cm u1=60 m/s T1=27o C P1=1.8bar gauge pressure Point-2…

Q: Soybean oil is being pumped through a uniform-diameter pipe at a steady mass- J mass of fluid…

A:

Q: water at 20 c is being delivered from pump through a coaxial annular smooth at a rate of 0.91…

A:

Q: On a circular pipe there are different diameters: diameter D1= 2 m changes into D2 = 1.5 D1. The…

A:

Q: 4.8. In a power plant, the inlet water has a velocity of 100 ft/s and an elevation of 80 ft above…

A:

Q: A vertical Venturi meter, as shown in Figure Q3 below, carries a liquid of specific gravity 0.9 and…

A: specific gravity = 0.9 D1 = 250 mm and D2 = 175 mm  Q = 80 liters s-1 density = 1000 kg/m3 Cd = 0.96

Q: 1. The ff. equation is proposed to calculate the pressure drop (Ap) across a length of pipe (L) due…

A:

Q: Water flows at a velocity of 3.0 m/s. Calculate the dynamic pressure, pd, by assuming that the…

A:

Q: Water flows steadily from an open tank as represented in the diagram below. The elevation (from…

A: Area at point A = 0.048m2 Area at point B =0.0160 m2 elevation at point A =10m elevation at point B=…

Q: The initial free fall of water from a faucet can be thought of as an inviscid flow because friction…

A: Given: The distance between points 1 and 2 is 7 cm i.e. z1 - z2 = 7 cm or 0.07 m The diameter of…

Q: There is a storage tank with a height of 5 m. Initially the tank is empty. The cross- sectional area…

A: For the given system apply conservation of mass to obtain the time. The flow rate is dependent on…

Q: Derive the dynamic mass balance equations for the following two simple cases. Assume (i) a linear…

A: This is a system of two first order system connected in series. The cases are interacting and non…

Q: Water is flowing inside the pipe shown in the sketch below. A Venturi meter equipped with a…

A: Given thatdp =12 cmdt = 6 cmh =4.5 cm

Q: A liquid is flowing from one large tank to another through a 1 in. diameter pipe. The level in tank…

A:

Q: Question 3 The average volumetric flow through an open rectangular duct can be estimated using the…

A:

Q: Imagine that you are inflating a round balloon with a pump that delivers 900 mL of gas with each…

A: Given the data between the number of pumps and balloon diameter.   (A) Draw the graph between the…

Q: 33. Viscous flow in a plunger-M. A tube of diameter D = 2.0 cm and length L = 100 cm is initially…

A: Given data: Diameter of tube = 2 cm Length = 100 cm Density of the fluid = 1 g/cm3 Viscosity of the…

Q: Water is flowing in a convergent duct. In one area, the diameter is 14 cm. If the velocity there is…

A: Given data: Diameter = 14 cm Velocity at point 1 = 12 m/s Diameter at point 2 = 2.5 cm

Q: 3. Chapter 4: Water is steadily flowing through a three-way connector in the Figure. It enters the…

A:

Q: We need to pump crude oil from the port to the refinery. The length of the pipe from the port to the…

A: The problem can be solved by applying Bernoulli's law. But before using it, let's check the type of…

Q: In a convergent-divergent nozzle where air, at 540 degrees F and 15200 torr enters and flows…

A: Note-Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question…

Q: Oil is pumped at the flow rate (q), through a pipe length, L. The pressure drop of the fluid across…

A:

Q: Example Water flows through a 500-N bend. The discharge is 0.25 m s, and the pressure at the center…

A: Given: 500 N bend, discharge is 0.25 m3/s Pressure at inlet is 150 kPa gauge Volume of bend is 0.1…

Q: Water with a specific volume of 0.001 mxkg1 flows through a centrifugal pump that operates under…

A:

Q: Q6: 5.3.1R (WP Water flowing in a pipe with a velocity of 25 m/s and a static gage pressure of 940…

A: Applying Mass balance over three sections- Density of water be, d = 1000 kg/m³ Mass in = Mass out…

Q: Problem 1: Water flows steadily through the piping junction, entering section 1 at 0.0013 m³/s. The…

A:

Q: A gas with a velocity of 350 m/s flows through a horizontal pipe at a section when the pressure is…

A: The amount of heat will be negligible or equal to zero as the system is in adiabatic condition. This…

Q: In a steady flow system, the entry mass is 8.26 kg after doing work at standard atmospheric…

A: Answer: 8.26 Kg

Q: The water in an aboveground huge swimming pool is to be emptied by unplugging a 3-cm- diameter…

A:

Q: 2-13. A tank of water is completely immersed in a tank of gasoline. Water flows out of an opening in…

A: Given,

Q: Water is flowing in a fire hose with a velocity of 1.0 m/s and a pressure of 200,000 Pa. At the…

A:

Q: P.4.9 Water is pumped at 1.4 m/s from a tank at a treatment plant to a tank at a local works through…

A: Volumetric flow rate Q=1.4 m3/s Diameter of the 1st pipe d1=0.3 m  Diameter of the 2nd pipe d2=0.6 m…

Q: A fluid is flowing with a mass flow rate om in a smooth horizontal pipe of length L and dia result…

A:

Q: Figure 3 shows flood water flowing into two tanks. Assume that the flow is steady and there are no…

A: For system having constant pressure at in and out position Bernaulli equation becomesV^2/2g…