The sum of the electrical and magnetic energies in an L-C circuit is 0.800 J. At a certain instant the energy is exactly half electrical and half magnetic, the capacitor charge is 5.30 mC, and the current is 8.00 A. Find (a) the capacitance, (b)

The sum of the electrical and magnetic energies in an L-C circuit is 0.800 J. At a certain instant the energy is exactly half electrical and half magnetic, the capacitor charge is 5.30 mC, and the current is 8.00 A. Find (a) the capacitance, (b)

Glencoe Physics: Principles and Problems, Student Edition

1st Edition

ISBN:9780078807213

Author:Paul W. Zitzewitz

Publisher:Paul W. Zitzewitz

Chapter25: Electromagnetic Induction

Section: Chapter Questions

Problem 76A

See similar textbooks

Similar questions

A parallel-plate capacitor with plate separation d is connected to a source of emf that places a time-dependent voltage V(t) across its circular plates of radius r0 and area A = πr0 2 (see below). (a) Write an expression for the time rate of change ofenergy inside the capacitor in terms of V(t) and dV(t)/dt.(b) Assuming that V(t) is increasing with time, identify thedirections of the electric field lines inside the capacitor andof the magnetic field lines at the edge of the region betweenthe plates, and then the direction of the Poynting vectorS →at this location.(c) Obtain expressions for the time dependence of E(t), forB(t) from the displacement current, and for the magnitudeof the Poynting vector at the edge of the region between theplates.(d) From S → , obtain an expression in terms of V(t) anddV(t)/dt for the rate at which electromagnetic field energyenters the region between the plates.(e) Compare the results of parts (a) and (d) and explain therelationship between them.
A series electric circuit contains a resistor R, a capacitor C and a battery supplying a time-varyingelectromotive force V(t). The charge q on the capacitor therefore obeys the equation R(dq/dt) + (q/C) = V(t) Assuming that initially there is no charge on the capacitor, and given that = sinωt V(t) V0 , findthe charge on the capacitor as a function of time. [Hint: First, find an appropriate integrating factor.]
in the circuit shown in the figure, the S switch is closed at t=0 and the capasitors, which are completely empty, begin to fill. Here E=30V, C=3 uF and R=40 ohm. A) what is the time constant of the circuit, T, in the units of microseconds? B)when t=T, what is the total charge, in units of microcoulomb?
(a) In the figure what value must R have if the current in the circuit is to be 1.1 mA? Take ε1 = 1.5 V, ε2 = 3.5 V, and r1 = r2 = 4.0 Ω. (b) What is the rate at which thermal energy appears in R? Please be specific about the units in the work and the final answer.
(a) In the figure what value must R have if the current in the circuit is to be 0.84 mA? Take ε1 = 1.9 V, ε2 = 3.4 V, and r1 = r2 = 3.1 Ω. (b) What is the rate at which thermal energy appears in R?
A capacitor in a telephone circuit has a capacitance of 3μF. What current flows through it when 15V at 800Hz is impressed across it? answer should be in polar form
The formula for the power output P of a battery is P=VI−RI2P=VI−RI2, where V is the electromotive force in volts, R is the resistance in ohms, and I is the current in amperes. Find the current that corresponds to a maximum value of P in a battery for which V = 12 volts and R = 0.8 ohm. Assume that a 10-ampere fuse bounds the output in the interval 0≤I≤100≤I≤15
Problem 8: A capacitor of capacitance C-10 uF has been charged so that the potential difference between its plates is Vo 380 V. The capacitor is then connected to a resistor of resistance R-6.5 k2. The switch S is closed, and the capacitor begins to discharge Randomized Variables Vo 380 V l- ©theexpertta.com Δ Part (a) Calculate the time constant of the circuit in seconds. tan() cos0) cotanasin) acos(0 atan() acotan sinh() cosh)tanh cotanh) O Degrees O Radians sin HOME 4 5 6 0 BACKSPACE CLEAR Submit Hint I give up! Hints: 1%, deduction per hint. Hints remaining: 2 Feedback: 1% deduction per feedback. a Part (b) Calculate the charge Qo on the capacitor before the switch is closed, in coulombs. Part (c) Calculate the current Io immediately after the switch is closed, in amperes. . Part (d) Calculate the potential difference VC in volts between the capacitor plates at time t - 5.0 ms after the switch is closed A Part (e) Calculate the time T in s after which the charge on the capacitor…
The capacitor in the circuit shown below is initially uncharged. The switch is closed at t = 0 s. AV battery = 30 V, C = 3.0 F, and R = 2.0 2. At sometime after the switch is closed, the current in the circuit is measured to be 9.3 A. What is the charge on the capacitor at this time, in Coulomb? Your answer needs to have 2 significant figures, including the negative sign in your answer if needed. Do not include the positive sign if the answer is positive. No unit is needed in your answer, it is already given in the question statement.
In the figure, suppose the switch has been closed for a length of time sufficiently long for the capacitor to become fully charged. For this circuit, R1 = 12.0 kΩ, R2 = 15.0 kΩ, R3 = 3.000 kΩ, C = 10.0 μF , and emf = 9.00 V. Find (d) the potential differance across R2. (e) the charge on the capacitor.
The average television set is said to be on 6 hours a day. a) Calculate the yearly cost (total cost) of electricity, in billions of dollars, required to operate 100 million TVs, assuming their power consumption averages 130 W and the cost of electricity averages 13.5 cents/kW⋅h.
z=-4.1 cm ve z=4.1 cm noktalarına yerleştirilmiş hava-boşluklu r=2 m yançaplı iki silindirik plakadan oluşan sistemin kapasitansını (nF cinsinden) bulunuz. T=3,1416 Find the capacitance of the system (interms of nF) consisting of two air-filled cylindrical plates of radius r=2 m placed at the points z=-4.1 cm and z=4.1 cm. h Answer: Choose.