The same heavy wooden block is dragged by a force F along a rough steel plate, as shown below for two possible situations. The magnitude of the acceleration is the same for the two situations; do not assume that the magnitude of F is the same. The magnitude of the frictional force in (ii), as compared with that in (i) is: ITTTTTT m777 Select one: O a. the same b. greater C. can be less or greater, depending on the gnitude of the applied force. d. less e. less for some angles and greater for others

The same heavy wooden block is dragged by a force F along a rough steel plate, as shown below for two possible situations. The magnitude of the acceleration is the same for the two situations; do not assume that the magnitude of F is the same. The magnitude of the frictional force in (ii), as compared with that in (i) is: ITTTTTT m777 Select one: O a. the same b. greater C. can be less or greater, depending on the gnitude of the applied force. d. less e. less for some angles and greater for others

Name: The same heavy wooden block is dragged by a force F along a rough ste
Uploaded: 2024-03-20T06:57:57.000Z
Channel: Bartleby
Description: The same heavy wooden block is dragged by a force F along a rough steel plate, as shown below for two possiblesituations. The magnitude of the acceleration is the same for the two situations; do not assume that the magnitude of Fis the same. The mag

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

ANSWERS MUST BE IN 3 DECIMAL PLACES 1. A 400-N weight starts down the incline of 30o with the horizontal with an initial velocity of 4m/s. Find the velocity of the weight after 10s if fk = 0.2 for the incline. 2. A 400-N body starts up the incline of 30o with the horizontal (fk = 0.2) with a velocity of 3m/s. How long must a 500-N horizontal force act on the body to increase its velocity to 8m/s? 3. A 400-N body starts up the incline of 30o with the horizontal (fk = 0.2) with a velocity of 3m/s. How far will the body travel while the force is acting?
A sled is on a horizontal surface and a rope with tension T is pulling on it at an angle 0 above the horizontal. The sled had mass M and does not move due to the frictional force. In this case the coefficient of friction is µ̟. In terms of the variables given and g, what is the magnitude of the frictional force in this case? Select one: a. H, Mgsino b. Tcose O c. Tsin0 O d. H, Mgcos0
3. A 6.50 kg block is pressed against a vertical wall by a force (F), as shown in the figure below. The coefficient of static friction between the block and the wall is 0.41 and the directional angle 0 for the force is 46º. Determine the magnitude of the force (F) when the block is about to slide up the wall. N F é
Choose the coefficient of friction wisely. Relevant information is given in the textbook. a. What is the maximum frictional force in the knee joint of a person who supports 70.0 kg of her mass on that knee? Fmax 686.7 XN b. During strenuous exercise it is possible to exert forces to the joints that are easily ten times greater than the weight being supported. What is the maximum force of friction under such conditions? (The frictional forces in joints are relatively small in all circumstances except when the joints deteriorate, such as from injury or arthritis. Increased frictional forces can cause further damage and pain.) Fmax = N
A 10.0 [kg] block is pushed by a 45.0 [N] force against a rough wall that is inclined at an angle 70°. What should be the minimum coefficient of static friction Push Hg so that the block will not slide down the ramp? А. 2.04 C. 0.746 В. 0.245 D. 1.17 0 = 70°
3. A block of mass m = 5.9 kg is pulled up a 0 = 21° incline as in the figure below with a force of magnitude F = 37 N. (Hint: remember to measure all angles from +x axis.) y a. Draw a free body diagram showing all the forces. NORml Fte F Mass = 5.9k 0-21° F-37N there b. Determine the x and y components of all the forces. X Components of Force f = 37 N Y comporents of Force F=0N X componnt of normal force=ON * Componis of weight=-5.9x 9.8x Sin 210=70. FJN Y Comperents of weight=5.9a 9.8 x Casal. - 53.98 Y Compenents of normal force=mglos H%53.98, c. Write equations summing all the x components and all the y components. F-mg Sm@= mxa 37-20.72= 5.9x a 2.7l6 = Comporunts) Normal force - mg les 0: 05 53.98-53.98-0o d. Find the acceleration of the block if the incline is frictionless. (Give the magnitude of the acceleration. Find the acceleration of the block if the coefficient of kinetic friction between the block and incline is 0.12. (Give the magnitude of the acceleration.) е. 3
1B. The given system of knotted cords (label the left knot as J and the right knot as K) supports the indicated weights. a) What is the tension TA in cord A? b) What is the tension TB in cord B? c) What is the tension TC in cord C?
sonia- m pject Pool partment... 7 1 1329 2 S X 7. A 7.50 kg block is pressed against a vertical wall by a force (F), as shown in the figure below. The coefficient of static friction between the block and the wall is 0.41 and the directional angle 8 for the force is 50.0°. Determine the magnitude of the force (F) when the block is about to slide down the wall. N 3 E D 80 F C $ 4 R F % 5 V T G (2991109 911 6 ccito coi16 MacBook Air 6: B S Y H & 7 S 63 91129 911539115 91109 91103 911931 92 U N 6 ceiloo cc 16 ecil6 ceiló ccrl6 cc 16. c 8 J ció ecil6 ceil D-Il ER 1 M ( 9 K MOSISO O O 4 19 P
Question 6 13. A7.5 kg backpack is sliding across the floor. The coefficient of friction between the backpack and the floor is 0.20. Answer the following: c) What is the force of friction on the backpack? Your answer: O 1.5 N O 7.4 N O 15 N O 74 N
QUESTION 9 If the coefficient of static friction between all contacting surfaces μs = 0.3, determine me when block A is on the verge of a. moving up the incline plane. b. moving down the incline plane. mA = 10 kg 30⁰ 45° mB
A 98N force is needed to push a 45kg box across the wooden floor. What is the value of the coefficient of static friction across the floor and the box? O 0.212 O 0.222 O No answer O 0.122 O 0.012
Q5. As in Fig. if the mass of its body is 10 kg. Calculate the acceleration of the body if the coefficient of kinetic friction uk= 0.2. 100N 30