The primary datum feature controls the Size Flatness of the part?

Provide the appropriate datum feature symbols and datum features in the feature control frames on the drawing

What is the geometric term that applies to V-groove?

What is the orientation geometric tolerance that is applied to this feature?:  __________ Does the tolerance control a surface, axis, or center plane?: __________ What is the applied tolerance if the feature is produced at MMC?:  __________

How would you solve this

1. How is the location tolerance of Position different from the other 11 GD&T tolerances?  Pick two (2) other tolerance and contrast write about those two in detail relative to Position tolerancing. 2. Form tolerances,  elaborate how they are different from Orientation tolerances

Machine trades print reading Sectioning problem 13-3 Complete this view as a half section.

Moving to another question will save this response. èstion 10 With respect to a fitting operation, which of the following is the correct sequence of events? O A. Marking-Measuring-Filing B. Measuring-Marking-Filing C. Filing-Measuring-Marking O D. Marking- Filing-Measuing Windows buukl eIT:PA T-TV E/IV

The term "maintenance" refers to maintaining all of the systems and features in working order. * as close as possible to the original O design purpose of the manufacturer tons as close to the manufacturer's original design purpose as impossible as impossible to the manufacturers original design intent tons. as possible to the manufacturers unoriginal design intent tons skip Punctures are- a small hole in a tire resulting in an get- away of air a large hole in a tire resulting in an get- away of air a small hole in an engine resulting in an escape of air a small hole in a tire resulting in an get- away of oil Skip

i need the answer quickly