The pressure in an automobile tire depends on the temperature of the air in the tire. When the air temperature is 25 degC, the pressure gage reads 210 kPa. If the volume of the tire is 0.025 m^3, the pressure rises in the tire when the air temperature in the tire rises to 50 degC. Determine the amount of air, in kg, that must be bled off to restore pressure to its original value at this temperature. Assume the atmospheric pressure to be 100 kPa

The pressure in an automobile tire depends on the temperature of the air in the tire. When the air temperature is 25 degC, the pressure gage reads 210 kPa. If the volume of the tire is 0.025 m^3, the pressure rises in the tire when the air temperature in the tire rises to 50 degC. Determine the amount of air, in kg, that must be bled off to restore pressure to its original value at this temperature. Assume the atmospheric pressure to be 100 kPa

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

onal Assignh Q56. The water in a tank is pressurized by air, and the pressure is measured by a multifluid manometer as shown in the Figure. The atmospheric pressure is 85.6 kPa. Determine the air pressure in the tank if h, = 0.1 m, h2 = 0.2 m, and ha = 0.35 m. Take the densities of water, oil, and mercury to be 1000 kg/m², 850 kg/m², and 13,600 kg/m², respectively. Oil а. 130 КРа Air b. 44 MPa с. 310 КPа Water d. 44 kPa е. 130 MPа Mercury
A rigid tank contains superheated water vapour at 300 kPa. When the tank is cooled, the superheated water vapour starts to condense at a temperature of 125°C. Determine the pressure and specific volume of the water at 125°C when the condensation process starts (kPa; m'/kg). Determine the temperature of the superheated water vapour (°C). Clearly show all calculations. Sketch the process on a properly labelled temperature versus specific volume (T-v) diagram with respect to saturation lines. i. ii. iii.
ii. At temperature T = 250C and pressure 2.25 bar, the volume of gas = 2.5 m3. Subsequently temperature increases to 750C while the pressure remains constant. The volume of gas under the change condition.
PLEASE ANSWER QUICKLY
Determine the pressure, specific volume, and internal energy of water at 25 C and a quality of 70%
Air contained in a piston-cylinder system undergoes a polytropic process. Pv1.3 = constant P1 = 100 kPa pressure and T1 = 220C temperature to P2 = 500 kPa pressure is compressed. Calculate the specific volume and temperature at the end of the process.
A vacuum gage connected to a chamber reads 20 kPa at a location where the atmospheric pressure is 97 kPa. Determine the absolute pressure in the chamber. What is the absolute pressure in the chamber (in kPa)
Convert 2.543 inHg to lb/ft2 manually. Show the step by step Conversion
A spring exerts a force of 17 lbf on a piston inside a piston cylinder device. The mass of the piston is 3.5 lbs and the cross sectional area of it is 0.00018 ft^2. Determine the pressure inside the piston cylinder device.
A gas compressed according to the law PV1.5 = constant from the initial pressure and temperature of 105 kN/m? and 26 °C respectively to a pressure of 900 kN/m² .The gas is then cooled at constant pressure, then the gas was expanded isothermally to the initial conditions. Take y= 1.5.
Pravinbhai
A rigid tank contains water at a pressure of 200 kPa. The volume of the tank is 2 m^3. The mass of liquid in the tank is 0.5643 kg and the mass of vapor in the tank is 2.2572 kg. In the question that follows, select the answer that is closest to the true value. What is the quality of the water in the tank?