The pipe with inside diameter of 127 millimeter and throat of a venturi meter have inside diameter of 50.8 millimeter. What is the volumetric flowrate in cubic meter per minute of iso- pentane (density = 621 kg/m³) that will resulted to a difference of mercury (specific gravity = 13.57) level of 381 millimeter in the manometer? Blank 1 m³/min ***EXPRESS YOUR ANSWER in TWO (2) DECIMAL PLACE and WITHOUT UNITS****

Q: width and 5 m A horizontal square wooden rod, 2 m long. 0.2 m head width is hung and fixed at the…

A:

Q: Fluid A Fluid B hz Impact tube at center Question C1 Two liquids A & B are flow throw two pipes to a…

A: fluid A d1=38.1mm=0.0381m d2=18.9mm=0.0189m cd=0.965 R=148cm d=32.9mm note-all data we will take…

Q: Manometeri is being used to indicate the pressure difference between two point. Calculate the volume…

A:

Q: Water flows in a pipeline composed of 75 mm and 150 mm pipe. Calculate the mean velocity in the 75…

A:

Q: Water with density 1000 kg/m3 flow in a 4-in ID pipe at 1,2 m/s, witch connect to a Venturi meter to…

A: Density of water = 1000Inner diameter of pipe = 4 in.Water velocity at the inlet of pipe = 1.2…

Q: If a spherical drop of liquid evaporates at a rate proportional to its area, if initially its radius…

A: Let V and S be volume and surface area of the spherical drop whose radius at time t is r Given…

Q: Q3) Water flows through a 10-mm diameter pipe at a flow rate of 1.33×104 m³/s. Find (a) Velocity (V)…

A: As water is flowing through the pipe with a flow rate of Q. Reynold's number is the dimensionless…

Q: 4. Water is fiowing through a 2.067-in ID pipe with a velocity of 1 m/s. Čalculate: (a) Mass…

A: Mass flow rate is the unit mass of a material or a matter flowing into the system per unit time.…

Q: 17. Calculate the pressure at point A in Fig. 2.50. The slope of the tube is 4 horizontal to 1…

A: Reservoir review is given.Calculate pressure at point A.

Q: Q4: 8*10 m/s of water flowing through a pipe of 0.2 m I.D. What will be the difference in level on…

A: Given: Volumetric flow rate of water, Q = 8 x 10-4 m3/s Internal diameter of the pipe, Di = 0.2 m…

Q: a cubic reservoir has side of 10 meters. if it is initially half full with water by height,…

A: Given, Side=10 m Height of water, h=5 m

Q: A smooth pipe has an inside diameter of 28 mm, is 16 m long, and carries 10C water at a rate of 8…

A: Given,The diameter of the pipe is, the length of the pipe is, the temperature of the water is, The…

Q: Question 3 The average volumetric flow through an open rectangular duct can be estimated using the…

A:

Q: Water at 30°C is being pumped through a 30 m section of 19.49 cm. diameter steel pipe at a mass flow…

A: Given data: Length of the pipe = 30 m Diameter of pipe = 19.49 cm Mass flow rate = 0.07 kg/s Density…

Q: A straight pipe with an expansion in pipe from 6 to 11 cm transports water at a rate of 0.011 m /s.…

A:

Q: 10. Consider a system with a * pitot tube (with a U-tube manometer) attached to a horizontal oil…

A: Given S.G=0.84 μ=0.05 kg/m-sec ID=0.11 yard h=0.42 yard Find Volumetric flow rate,Q

Q: 5.1-2. Frictional Pressure Drop in a Flow of Olive Oil. Calculate the frictional pressure drop in…

A: Olive oil density and viscosity at a given temperature are obtained. The Reynolds number is…

Q: The wastewater treatment process at a polymer plant consists of a longitudinal bio-remediation pond…

A:

Q: Sulphuric acid is flowing through a pipe (2.5 inch diameter, 50 ft length) in a velocity of 0.006 m3…

A: Given: diameter D = 2.5 inch = 0.0635 m, A = pi.D2/4 = 0.003165 m2 Thus, V = Q/A = 0.006/0.003165  =…

Q: P.4.14 Water (density 1000 kg/m', viscosity 1 mNs/m²) is pumped through a 50 mm diameter pipeline at…

A: Case 1: Flow of water through pipe Mass flow rate of water, mW = 4 kg/s Diameter of the pipe, d = 80…

Q: Water at 30°C is being pumped through the annular area of a laboratory scale 1-pass, 1-shell tube…

A: Volumetric flow rate of water = 0.1 m3/s Inside diameter of the shell, d2 = 18.4 cm Outside diameter…

Q: Q2: A 60 mm diameter pipe contains glycerin (sp.gr 1.258) flowing at 8.5 m'/hr as shown in the…

A: Given: d = 60 mm, specific gravity = 1.258, Q = 8.5 m3/hr and zA = 0m, zB = 12 m. PA = 2 atm and PB…

Q: 10. The differantial mercury manometer in the figure is connected to pipe A containing gasoline (SG=…

A:

Q: Water is flowing through a 30-m-long and 5-cm-diameter horizontal pipe at a rate of 9 L/s. Using…

A: We are given that  Length= L = 30 m diameter=d = 5 cm =0.05 m flow rate = Q = 9 L/s = 0.009 m3/s…

Q: )A U-tube containing mercury (relative density 13.6) has its right-hand limb open to at mosphere and…

A: Applying the pressure difference across the manometer, Pρg + h1- ρ2h2 = P2Pρg+0.1 - (13.6×0.05) = 0…

Q: If the natural gas flow rate is 120 MMSCF/Day in a gas pipeline, NPS 20 with 0.25 in wall thickness,…

A: To calculate the outlet pressure using the Panhandle A equation, we can use the following…

Q: 0.4 m 0.4 m 0.5 m 1.0 m water s 0.90 oil, s=

A: Solution Given that different fluids with specific gravity One atmosphere (101.325 kPa) is also the…

Q: Water is flow in a 4 in Schedule 40 steel pipe at 20 0C and 1 atm. Orifice meter with orifice…

A: pipe diameter (d1 )for 4 inch schedule 40 pipe = 4.026 inch = 0.1023m  throat diameter (d2) = 0.062m…

Q: The flow behavior of a polymer melt with a specific gravity of 1.17 and a viscosity of 0.486…

A:

Q: What size of orifice would give a pressure difference of 41 cm water column for the flow of liquid…

A:

Q: In fully developed laminar flow in a circular pipe, the velocity at R/2 (midway between the wall…

A: Consider a fluid element with length dL Now take force balance as shown in figure

Q: em 2.4 and Eqs. (2.20) and (2.23) 2.6 A liquid is flowing through a vertical tube 0.3 m long and 2.5…

A: Hello. Since your question has multiple parts, we will solve first question for you. If you want…

Q: Q: Yotameter with float shape type "B" (see figure below) has tube of 0.3 m long. the internal…

A: