The indicated force-couple system is applied to a small shaft at the center of the plate. Replace this system by a single force R and specify the coordinate x of the point on the x-axis through which the line of action of this resultant force passes. Answers: R= (i X= i y M = 330 N m F = 5.7 KN i+i mm j) kN

The indicated force-couple system is applied to a small shaft at the center of the plate. Replace this system by a single force R and specify the coordinate x of the point on the x-axis through which the line of action of this resultant force passes. Answers: R= (i X= i y M = 330 N m F = 5.7 KN i+i mm j) kN

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Replace the forces and couple system acting on the T member with an equivalent force couple at A. Express your answers as Cartesian vectors. 1 m 120 N 50 N 120 N 1 m 60° 60° 45° 1m 1m | 2 m 40 N 35 N
Express and identify the resultant of the two forces and one couple shown acting on the shaft angled in the x-z plane. Assume F = 500 lb, M = 490 lb-ft, a = 8 in., b = 22 in., 0 = 12° -M Answer: M=1 İ+ i 12.57 k) lb-in. -21.52 İ+ i 300
If the resultant of the loads shown passes through point B, determine the equivalent force-couple system at O. 9 kips 15 kips 3.6' 2.2 Answers: Ro= Mo= i 2 kips OB 2.2' i+ i k kip-ft. I X j) kips
Replace the force and couple moment system acting on the system by a single resultant force and specify its location along the horizontal beam measured from point O. Be specific as to where the resultant force is pointing (i.e. provide an angle and quadrant).
Q5/ Replace the three forces which act on the bent bar by a force-couple system at the support point A. Then determine the x-intercept of the line of action of the stand-alone resultant force R. 2500 lb 1200 lb •A B. 30 E 800 lb
4. Reduce the given loading system to a force-couple system at point A. Then determine the distance x to the right of point A at which the resultant of the three forces acts. gON 72ON 200mm 500 mm 450 mm 1200N
A blade held in a brace is used to tighten a screw at A. (a) Determinethe forces exerted at B and C, knowing that these forces are equivalent to a force-couple system at A consisting of R =-(30 N)i + Ry j+ Rz k and M = –(12 N · m)i. (b) Find the corresponding values of Ry and Rz. (c) What is the orientation of the slot in the head of the screw for which the blade is least likely to slip when the brace is in the position shown?
5
Replace the force system acting on the pipe with an equivalent force-couple system with the force acting at point D.
A twist of 4 N.m is applied to the handle of the screwdriver. Resolve this couple moment into a pair of couple forces F exerted on the handle and P