The hollow rectangular cross-sectioned beam (200 mm wide and 400 mm deep with 10 mm thickness) shown below supports a uniform load of w = 10 kN/m throughout its length and a concentrated load of P = 20 kN (3 m from the left end of the beam). Determine the following: P = 20 kN 3 m w = 10 kN/m 6 m 1 m R1 R2 10 mm 10 mm 200 mm 10 mm 10 mm 400 mm-

The hollow rectangular cross-sectioned beam (200 mm wide and 400 mm deep with 10 mm thickness) shown below supports a uniform load of w = 10 kN/m throughout its length and a concentrated load of P = 20 kN (3 m from the left end of the beam). Determine the following: P = 20 kN 3 m w = 10 kN/m 6 m 1 m R1 R2 10 mm 10 mm 200 mm 10 mm 10 mm 400 mm-

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

For the beam and loading shown, consider the n-n cross section. (a) the absolute value of |M| of the bending moment in the n-n section N.m (b) determine the absolute value of the normal stress in the direction of the X axis at point A of the n-n section |σx| MPa in units, c) determine the absolute value of the maximum shear stress at Point A of the n-n section |tmaks| MPa in units. The inside of the beam is full and the cross-section measures are as shown in the figure. Supports only support vertical forces. Take P1 in the question for 220 N and P2 for 323 N. Point A is at the bottom of the beam.
Beam Number 1 R₁ 25 kN-m 1m 1m 3m 10 kN/m R₂ 2 m
B1
Hi, The maximum stress can't be more than 10MPa so that cannot be the right answer. Also where do the figures for 69.5knm bending moment come from?
A steel I-beam has a web that is 17inches tall and 0.19inches thick. If the max shear in the beam is 6kips, what is the approximate max shear stress in the beam in psi? Type your answer...
Determine the value of maximum principal stress
Higdon
Find the maximum load w applied if the allowable bending stress is 70 Mpa
A concrete beam is reinforced by three steel rods placed as shown. The modulus of elasticity is 3* 106 psi for the concrete and 30 *106 psi for the steel. Using an allowable stress of 1350 psi for the concrete and 20 ksi for the steel, determine the largest permissible positive bending moment in the beam.