The heating coils in a hair dryer are 0.800 cm in diameter, have a combined length of 1.00 m, and a total of 400 turns.(a) What is their total self-inductance assuming they act like a single solenoid? (b) How much energy is stored in them when 6.00 A flows?              (c) What average emf opposes shutting them off if this is done in 5.00 ms (one-fourth of a cycle for 50 Hz AC)?

Q: An inductor with an inductance of 7.50 H and a resistance of 8.00 ohms is connected to the terminals…

A: a)The required rate of electrical energy just after circuit is completed is,

Q: A solenoid of radius 2.30 cm has 660 turns and a length of 25.0 cm. (a) Find its inductance. mH (b)…

A: Given Radius of the solenoid is r=2.30 cm=0.023 m Number of turns in the solenoid is N=660 Length of…

Q: An electromagnet can be modeled as an inductor in series with a resistor. Consider a large…

A: The inductance L=13.0 H The resistance R=3.50 Ω The emf of the battery V=18.0 V The maximum current…

Q: A 96-mH solenoid inductor is wound on a form 0.80 m in length and 0.10 m in diameter. A coil is…

A:

Q: A long, straight solenoid with a radius of rs = 3.0 cm and a length of y = 25 cm is wound with 1,500…

A:

Q: If two coils placed next to one another have a mutual inductance of 5.00 mH, what voltage is induced…

A: Mutual inductance, M = 5 mH  change in current, dI =2 A  change in time, dt = 30 ms

Q: 10 V = 10 mH 40. In the circuit shown above, the switch S is closed at t= 0. Which of the following…

A: The given configuration is a series RL circuit. The time constant (τ) of this circuit can be…

Q: The current in a 20.0-mH inductor changes with time as i = 3.00t2 – 8.00t, where i is in amperes and…

A: Given value--- inductance = 20 mH. i  = 3 t2 - 8 t. We have to find--- (a) Find the magnitude of…

Q: At t = 0, an emf of 500 V is applied to a coil that has an inductance of 0.800 H and a resistance of…

A: Values given in the question are as follow; ε=500 VR=30 ΩL=0.8 H Maximum current; Io=εRIo=500…

Q: An inductor with inductance 10.23 H and a resistor with resistance 3.24 ohms are connected in series…

A: This is an LR series circuit problem. All the given data is already in SI units so we don't need to…

Q: A conducting coil, with current i(t) = 4.00e-0.0250t sin(120at), with i in amperes and t in seconds,…

A:

Q: What is the energy density at the center of a circular loop of wire carrying a 26.0 A current if the…

A:

Q: A lab tech observes that the current in a coil of conducting wire goes from i, At = 0.200 s.…

A: By general definition the voltage in in an inductor is defined as E = L di/dt  .L = Inductance di =…

Q: An electromagnet can be modeled as an inductor in series with a resistor. Consider a large…

A:

Q: How much energy is stored in the 0.632 mH inductor of the preceding example when a 30.0 A current…

A: The expression for the stored energy,

Q: Since inductors can be used as energy storage elements, how much inductance is needed to power up a…

A:

Q: A constant inductance of one henry and a variable resistance R are connected in series with a…

A:

Q: A transformer consists of two coils of wire wound on a common toroidal iron core. The mutual…

A:

Q: Two single-turn coils are magnetically coupled with a mutual inductance of 3.06 x 105 H. If a mutual…

A: number of turns in each coil = 1 Mutual inductance = 3.06×10-5 H new mutual inductance = 8.89 mH

Q: The time for the current in the resistor of an RL circuit, in units of ms, to reach -63% of its…

A: Given:-  The resistance R = 513 ohm  The inductor L = 87.3 mH  Find:-  The time for the current in…

Q: Find the energy stored in a 6.8-mH inductor when the current is 3.7 A.

A: Given, Inductance(L) = 6.8*10-3  Current(I) = 3.7 Ampere

Q: A solenoid of radius 1.50 cm has 760 turns and a length of 15.0 cm. (a) Find its inductance. mH (b)…

A:

Q: A coil has 3.45 Ω resistance and 450 mH inductance. If the current is 3.92 A and is increasing at a…

A: The equation for the potential difference across the coil can be given by the equation

Q: The current in a 50.0-mH inductor changes with time as i = 4.00t? – 7.00t, where i is in amperes and…

A: Given data *The given inductor is L=50.0 mH=50.0×10-3 H *The given current is i=4.00t2-7.00t

Q: Suppose that a rectangular toroid has 1, 600 windings and a self-inductance of 0.070 H. If h = 0.13…

A:

Q: At t = 0, the current through a 43.0-mH inductor is 47.0 mA and is increasing at the rate of 127…

A:

Q: How many turns should a solenoid of cross-sectional area0.035 m2 and length 0.32 m have if its…

A: The solenoid’s cross-sectional area is, The solenoid’s length is, The inductance of a solenoid is,

Q: A 10-turn ideal solenoid has an inductance of 7.0 mH. When the solenoid carries a current that is…

A:

Q: At time t =0, a 45 V potential difference is suddenly applied to the leads of a coil with inductance…

A: The equation for the current is given by,

Q: coil has 2.55-Ω resistance and 121-mH inductance. If the current is 3.00 A and is increasing at a…

A:

Q: A 96-mH solenoid inductor is wound on a form 0.80 m in length and 0.10 m in diameter. A coil is…

A: Given: Inductance of inductor, L = 96 mH = 96 X 10-3 H Length of wire, l = 0.8 m Diameter of wire, d…

Q: a = 10CM, b = 12 CM, h = 1CM, and N turns = 800, and free space permeability, then the…

A: Given data: a=10 cm; b=12 cm h=1 cm=0.01 m Number of turns, N=800 Free space permeability,…

Q: Physics The heating coils in a hair dryer are 0.800 cm in diameter, have a combined length of 1.00…

A: in this question we get inductance , energy and emf.

Q: What is the self-inductance per meter of a coaxial cable whose inner radius is 0.50 mm and whose…

A: R = 4 mm  r = 0.5 mm

Q: A 96-mH solenoid inductor is wound on a form 0.80 m in length and 0.10 m in diameter. A coil is…

A:

Q: Calculate the inductance of a toroid whose inside radius is equal to b and cross-section has the…

A:

Q: A long, straight solenoid with a radius of rs = 3.0 cm and a length of y = 25 cm is wound with 1,500…

A:

Q: What is the inductance of a coil in which the average emf induced is  20.0 mV when the current in…

A: E = 20mV  3.5 A to 7.7 A t = 0.33 sec L=?

Q: Suppose you wish to make a solenoid whose self-inductance is 1.8 mH. The inductor is to have a…

A:

Voltage Across Inductor

An actor is a passive electrical component that consists of a coil bent in the form of wire which uses electromagnetism to produce electric current through the coil. When the electric current flows through a conductor that is the coil, a magnetic flux is developed around the conductor. This flow of current through the coil creates a magnetic field based on Fleming's Right-hand thumb rule. If there is any decrease in the current passing through the inductor, then the magnetic field will also decrease and energy is released through the generation of electric current. There is also a secondary voltage inducing in the same coil due to the magnetic flux, since it opposes any changes in the electric current flowing through the circuit. An inductor is also called choke, coil, or solenoid. A choke is designed to block certain frequencies when the DC current passes. A winding coil is coated with insulation to give extra insulation and protect the circuit. They are usually tightly wrapped around a central core which is cylindrical in nature so that the magnetic flux can be induced. The solenoid is a three-dimension coil that is used to exhibit electromagnetism when the magnetic field is developed due to the current flowing through the coil. The sign convention of the inductor is the same as the power dissipating device. When the current flows into the positive side of the voltage across the inductor, the value is positive and the inductor dissipates power whereas when the inductor releases the power back to the circuit, the current has a negative sign convention.