The foundation design for the constmction of a telecommunication mast is to support a concentric load of 800kN and to be inclined at 80° to the horizontal, a I .5mxl .5m footing is to be placed at 2.0m below ground level as shown in Figure 2. The soil properties are; C=70kN/m², Y=18KN/m³ , 4–30° Assume the ground water table to be deep a). Determine the expected foundation pressure at the base of the footing due to the application of the load. b). Using the Meyerhof's bearing capacity equation, determine the ultimate bearing capacity of the underlying soil. c). Determine the factor of safety of the design, and comment on the adequacy of the design in terms of shear failure, give recommendations should the design is not safe against shear failure Q=800KN 80 ]2.0m 1.5m

The foundation design for the constmction of a telecommunication mast is to support a concentric load of 800kN and to be inclined at 80° to the horizontal, a I .5mxl .5m footing is to be placed at 2.0m below ground level as shown in Figure 2. The soil properties are; C=70kN/m², Y=18KN/m³ , 4–30° Assume the ground water table to be deep a). Determine the expected foundation pressure at the base of the footing due to the application of the load. b). Using the Meyerhof's bearing capacity equation, determine the ultimate bearing capacity of the underlying soil. c). Determine the factor of safety of the design, and comment on the adequacy of the design in terms of shear failure, give recommendations should the design is not safe against shear failure Q=800KN 80 ]2.0m 1.5m

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Design of Rectangular and Combined Footing Question: (See photo) Note: Avoid rounding off values in the course of solution proper as much as possible. ROUND OFF ONLY AT THE FINAL ANSWER.
I need the answer as soon as possible
Q3/ A square rigid footing of size 10 x 10 m is founded at a depth of 2.0 m below ground level. The type of strata met at the site is as below: Туре of soil Sand Depth below N.G.L (m) 0 to 5 5 to 7 Below 7 m Clay Sand The water table is at the base level of the foundation. The saturated unit weight of soil above the foundation base is 20 kN/m³. The coefficient of volume compressibility of clay, m, is 0.0001 m²/kN, and the coefficient of consolidation c, is 1 m2/year. The total contact pressure q = 100 kN/m². Water table is at the base level of foundation. Compute primary consolidation settlement.
A combined footing is proposed to support two columns, C1 and C2, with loads equal to 2000 kN and 3000 kN, respectively. The column C1 has dimensions equal to 25x50 cm and C2 has dimensions 25x75 cm, while the spacing between the two columns is 5 meters. The footing is to be founded in a silty sand soil layer with the following engineering properties: γ = 18.2 kN/m3; φ = 33o and c = 30 kPa. The groundwater table is very deep, while the foundation level is 2.1 m from the ground surface, tp.c. (thickness of plane concrete) = 10 cm, fcu = 25 MPa, and the factor of safety against bearing capacity failure is equal to 5.0. It is required to do the following: (i). calculate the soil bearing capacity (limit to 2.0 kg/cm2 if exceed this value) (ii). determine the footing dimensions (iii). design the footing for flexure (iv). check shear and punching (v). sketch the required steel reinforcement
Design of Shallow Footing Question: (See photo) Note: Avoid rounding off values in the course of solution proper as much as possible.
Q.1. A rectangular footing 2.0 m by 3.0 m is built in a homogeneous bed of sand of having bulk unit weight 20 kN/m³ and saturated unit weight 21 kN/m³ with an angle of shearing resistance of ( 37 P. The depth of the base of footing is 1.8 m below the ground surface and water table is located at a deth of 1.0m below the base of the foundation. a) Justify the adequacy of the footing if the proposed design load on the foundation is 1500 kN. b) depth 1.0 m below the ground Level. Calculate the safe load can be carried by the footing if the water table is located at a Consider the factor of safety of 3. Use Terzaghi's Analysis.
A square footing has a dimension of 1.78 m x 1.78 m and has its bottom 1.54 m below the ground surface. Compute for the gross allowable load in kg that the footing has to carry if it has a factor of safety of 2.86. Ground water table is located 0.73 m from the bottom of the footing. Soil Properties: c = 1,803 kg/m? Specific gravity, Gs= 2.67 Void ratio, e =0.47 - 30 degrees HINT: Use Dry unit weight for soil above the groundwater table. Unit weight of water 9.81 kN/m
Solve fast