The forces F1 = = 590 lb, F2 = 380 lb, F3 240 lb and F 330 lb. Determine the forces in each member of the truss. = Use positive values to indicate tension and negative values to indicate compression. a a a с E b ד. F₁ A B. F₂V H G F3 F4 b BY NC SA 2013 Michael Swanbom Values for dimensions on the figure are given in the following table. Note the figure may not be to scale. Variable Value a 6 ft b 10.1 ft The force in member AB is lb. The force in member AH is lb. The force in member GH is lb. The force in member BH is lb. The force in member BC is lb. The force in member BG is lb. The force in member EG is lb. The force in member CD is lb. The force in member DE is lb. The force in member CE is lb. The force in member CG is lb.

1 help please drw FBD and answer

TDE= TBE Required information The structure consists of pin-connected members. Take X = 4 kN. NOTE: This is a multi-part question. Once an answer is submitted, you will be unable to return to this part. = 2m Determine the force supported by all members. Enter forces as positive numbers if the member is in tension and as negative numbers if the member is in compression. (Round the final answers to four decimal places.) The force supported by all members are as follows: TAB -7.0711 KN TAD= -5 KN TBD= 2.2361 kN KN |1m-1m-1m-1m4 2 kN 3 KN X 3 KN D TEF= TBF= 4.4721 TCF= TBC= -5.6569 kN KN E KN KN F C

Please provide  factual solution and I will leave thumbs up

A BB-series Astromech Droid of mass 154 kg is suspended by the truss structure shown. The truss structure is pinned to the wall at A and is supported by a rocker against the wall at F. A B 2w E F Allow w = 3 m. Determine the forces in all the members in the structure and indicate whether they are in tension or compression.

Consider the truss under the loading conditions shown below. Determine the forces in members GH, CH, and CD. If the members are in tension, your answers should be positive. If the members are in compression, your answers should be negative. 20 kN 25 kN 4 m ° 2.5 m TITTTT 2.5 m 4.7 m 4.7 m 20 kN Member GH is in [ Select] and has an internal force equal to [ Select ] v kN. Member CH is in [ Select] and has an internal force equal to [ Select ] kN. Member CD is in [ Select ] and has an internal force equal to [ Select ] kN.

oft Word - Test 2 Practice x T Tech|Express B Homepage - Tennessee Technolo x pads/Test%202%20Practice%20Problems.pdf ms 5 / 6 100% If the roller at B can withstand a max load of 3 kN, determine the largest magnitude, F, of the three applied forces. Ans. F = 354 N Problem 9: 2 m 45° 2 m 2 m 2 m F F N 50°F Clear ヘ x の f11 f9 144 h2ナ insert 14 15 %, & 4 7. 8. 6. 1

Please explain in clear detail and explain where you got your numbers from.

Round off to 4 decimals. Previous answers are all wrong. Please double check.

Please no hand writing solution for other wise down vote