The flow nozzle in the figure is used to measure the flow rate. if we install the 5 inch diameter nozzle inside a 16 inch tube and thickness 40, Calculate Flow Rate in Section 1 and Nozzle Throat when there is a flow of 9.5 ft3/sec of water through the system

Q: 6.1 Convert a volume flow rate of 3.0 gal/min to m³/s. 6.2 Convert 459 gal/min to m3/s. 6.27 A small…

A:

Q: Saline solution is delivered into the vein of a patient through a needle. The saline solution has a…

A:

Q: A salt water tank is 21 m tall and is open at the top to the atmosphere. A small hole with a cross…

A: Height of drain from free Surface                 h' = H- h = (21-4) m = 17 m Density  ρ of Sea…

Q: Pls help ASAP. Pls show all steps and calculations.

A:

Q: Consider the hydraulic lift shown in the figure. The small piston has an area A1 of 0.0330 m², and…

A:

Q: What force must be applied to a 2.5 cm-diameter piston in a hydraulic lift system in order to lift a…

A: Given value--- diameter d1 = 2.5 cm. mass = 1210 kg. diameter d2 = 15 cm. We have to find--- What…

Q: The figure below shows a horizontal pipe with a varying cross section. A liquid with a density of…

A:

Q: 10.0 cm 5.00 cm D1 D2 m/s. The speed of the water flowing in the Smaller channel with diameter D2 is

A: Here given the diagram with height of liquid. In first tube height is 10 cm and in second 5 cm. We…

Q: In the figure below, what is the volume flow rate at the opening in Point 2 whose diameter is 3.0…

A:

Q: Consider the hydraulic lift shown in the figure. The small piston has an area Aj of 0.0330 m², and…

A: A) As per Pascal’s principle, Here, P1 and P2 are the pressures at the pistons of area A1 and A2,…

Q: Two pistons of a hydraulic lift have a radius of 5 cm and 11.5 cm respectively. If the input force…

A: in the case of hydraulic lift  , pressure at both piston is same  that is P1 =P2 P1 = input pressure…

Q: A  submarine is comletely submerged under sea and displaces a volume of 450 m3 of seawater. Volume…

A: According to the Archimedes Principle The volume of the completely submerged Object is equal to the…

Q: Oil of density of 900Kg/m3 flow at full bore through a pipe 75mm inside diameter at a velocity of…

A: The mass flow rate is the mass of the liquid  passing through a given cross sectional area per unit…

Q: Water is flowing through a pipe whose cross-sectional area is smaller on the left side and larger on…

A:

Q: Calculate the mass flow rate (in grams per second) of blood (ρ = 1.0 g/cm3 ) in an aorta with a…

A:

Q: A horizontal pipe of diameter 25cm has a constriction of diameter of 5cm. The velocity of the water…

A: Given,  Diameter of pipe, d1=25 cm=0.25 m Diameter of constriction,d2=5 cm=0.05 m Velocity of water…

Q: Saline solution is delivered into the vein of a patient through a needle. The saline solution has a…

A: The expression for the average pressure is,

Q: In a hydraulic lift, the diameters of the pistons are 5.0 cm and 20.0 cm. A car weighing 8000 N is…

A: Let d1,A1 be the diameter and area of the small piston, d2,A2 be the diameter and area of the large…

Q: Water flows through a venturi meter. At the constricted section where the area is 24 cm2 , the…

A: Area 1 : A1 = 24 cm2 = 0.0024 Area 2 : A2 = 64 cm2 = 0.0064 Pressure 1; P1 = 10.2 N/cm2 = 102000…

Q: In the figure below, what is the volume flow rate in the lower opening (Point 2) which has diameter…

A:

Q: An arteriole in your leg is subject to a maximum pressure of 81.7 mmHg, once per heartbeat. This…

A:

Q: Answer the following question: 1. A Venturi tube narrows down from the inlet section to the throat.…

A:

Q: A cylindrical tank with a large diameter is filled with water to a depth D = 0.295 m. A hole of…

A:

Q: A 6 cm diameter horizontal pipe gradually narrows to 4 cm. When water flows through this pipe at a…

A:

Q: A diagram for an open-tube manometer is shown below. If the flask is open to the atmosphere, the…

A: Torr is a unit for measuring pressure. It is given by, Also, Now to calculate the pressure inside…

Q: A pressure transducer is installed at an elevation of 417.9 ft (127.4 m) above datum in a borehole.…

A: A pressure transducer is installed at an elevation of 417.9 ft (127.4 m) above datum in a borehole.…

Q: The input piston and output plunger of a hydraulic car lift are at the same level, as shown in the…

A:

Q: Pls help ASAP. Pls show all work and calculations.

A: Given Amanometer field with markari of density 13600 is used to measure the pressure of oil at a one…

Q: A rock with a mass of 575 g in air is found to have an apparent mass of 347 g when submerged in…

A: At equilibrium, the net force on the rock in the vertical direction must be zero. Take the upward…

Q: A horizontal pipe of diameter 25cm has a constriction of diameter of 5cm. The velocity of the water…

A: Given: The diameter of horizontal pipe is d=25 cm. The constriction of diameter is d'=5 cm. The…

Q: The car lift at your neighborhood garage is designed such that the radii of the input piston and…

A:

Q: A horizontal pipe line has different area of cross-section at two points P1 and P2. The diameter at…

A: Diameter of P1= 0.015 m Diameter of P2= 0.005 m

Q: A Venturi tube narrows down from the inlet section to the throat. The inlet is 5 ft^2 while the…

A:

Q: A water pipe has a diameter of 1 inch and is constricted to 0.5 inches. If water flows from the…

A: The given values are, d1=1 ind2=0.5 inv1=78.720 in/s

Q: Saline solution is delivered into the vein of a patient through a needle. The saline solution has a…

A:

Q: A cylindrical tank with a large diameter is filled with water to a depth D = 0.278 m. A hole of…

A:

Q: Water flows through a water hose at a rate of Q1 = 740 cm3/s, the diameter of the hose is d1 = 2.76…

A: Continuity equation is a form of conservation of mass. It states that total rate of flow of fluid is…

Q: 1) Water flows through a hose and fills a 45 gallon drum in 7 minutes a) what is the volumetric flow…

A: Discharge is defined as the volumetric flow per unit time. It is also defined as the product of Area…

Q: A hydraulic jack has an input piston of area 0.0600 m2 and an output piston of area 0.710 m2. How…

A:

Q: The cross-section area of Piston A1 is 0.000400m2 The cross-section area of Piston A2 is 0.000800m2…

A:

Q: A uniform cross-sectional area U-tube is open to the atmosphere, is partially filled with mercury…

A:

Q: A large open tank contains water as shown in the figure. The level of the water in the tank is 8 m…

A:

Q: Water flows to a pipe network as shown in the figure below. D1= 0.15 m V1= 2 m/s; D2 = 0.25 m V2 =…

A:

Q: Water flows through a venturi meter. At the constricted section where the area is 24cm^2, the…

A: Given: Cross-sectional area of the constricted section, A2 = 24 cm2. Pressure the constricted…

Q: Calculate the absolute pressure at an ocean depth of 1.0 km. Assume that the density of Water,…

A:

Q: In both inspiration and expiration, a pressure difference of 0.4 cmH2O causes a flow of 0.15 L/s.…

A: The inhaling of oxygen and exhaling of carbon dioxide is vital to all living organisms. Inspiration…

Q: The intake in the figure has cross-sectional area of 0.79 m2 and water flow at 0.48 m/s. At the…

A: Area of intake (A1) = 0.79 m2velocity of water at intake (v1) = 0.48 msD = 180 m velocity of water…

Q: what is the volume flow rate through the unmarked pipe?

A:

Q: A large tank contains water to a depth of 1.0 m. Water emerges from a small hole in the side of the…

A: Given Data: Water depth, H=1 m Depth of hole from the water level, h=20 cm=0.2 m Diameter of hole,…