The figure below shows one of the consumer circuits with three electrical appliances R, S and T, connected into the circuit. а) 7.7 A +4.6 A 2.3 A 110 V 24 a R 48Ω Calculate I. The current at point X and point Y. II. The resistance of appliance T. III. The combined resistance of appliance R and S. IV. The power developed in appliance R. V. The energy converted by the appliances in 2 minutes.

The figure below shows one of the consumer circuits with three electrical appliances R, S and T, connected into the circuit. а) 7.7 A +4.6 A 2.3 A 110 V 24 a R 48Ω Calculate I. The current at point X and point Y. II. The resistance of appliance T. III. The combined resistance of appliance R and S. IV. The power developed in appliance R. V. The energy converted by the appliances in 2 minutes.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter29: Dc Generators

Section: Chapter Questions

Problem 1PA: You are working as an electrician in a large steel manufacturing plant, and you are in the process...

See similar textbooks

Similar questions

The following are the readings taken while conducting an experiment on a wind turbine. what will be the value of open circuit voltage, if the short circuit current is 0.472 A, Maximum power point voltage is 5.32 V, Maximum power point current is 0.111 A and the fill factor is 0.599? Select one: a. 2080 mV b. 2.08 mV c. 8020 V d. 80.2 V
2. The SONEL thermal plant in Limbe supplies SONARA with 1.0 MV at a p.d of 1.0 x 104v The total resistance between the power station and the factory is 0.52. a. What is the power output of the thermal plant b. Explain why the power station output voltage is always stepped up before transmission over a long distance
(Note that the a,b,c,d are branches)1. Measure and record the potential difference for the following branches. Be mindful of the algebraic sign. a-b a-c b-c c-d a-d b-d And using the measured potential difference values, compute for the algebraic sum of the potential difference for the following electrical loops. Indicate the equation with values as well. abca abdca acda abcda acbda
Use the following constants if necessary. Coulomb constant, k = 8.987 x 10° N - m² /C2. Vacuum permitivity, co = 8.854 x 10 12 F/m. Magnetic Permeability of vacuum, Ho = 12.566370614356 x 10-' H/m. Magnitude of the Charge of one electron, e = -1.60217662 × 10–19 C. Mass of one electron, me = 9.10938356 x 10 31 kg. Unless specified otherwise, each symbol carries their usual meaning. For example, µC means micro coulomb. a R5 R3 e R9 R, R6 R8 Ry K Suppose you have the following circuit diagram. Here R1 =1.1 kN, R2 = 3.3 kN, R3 = 2.2 kN, R4 = 22 kN, R5 = 22 kN, Rg = 11 kN, R7 = 11 kN, Rg = 11 kN, R9 = 1.1 kN are the resistances on the circuit where kN stands for kilo ohm. The electromotive forces of the batteries are & = 5 volts and Ez = 3 volts. a) Calculate Rik. the resistance equivalent to R5, Re, R7, Rg and R9 between the terminals b and k. Value of Rhk Give your answer to at least two significance digits. Ω b) Calculate the current through R1.
Consider Two same size series connected PV modules,each with the specification as Po=100W, Voc= 24.5V and Isc=5A.then choose the correct Statement Refer to this PV Panel. a.The output power from this panel is 100W , the Voltage is 24.5V and the current is 10A b.The output power from this panel is 200W , the Voltage is 24.5V and the current is 10A c.The output power from this panel is 200W , the Voltage is 49V and the current is 5A d.The output power from this panel is 200W , the Voltage is 49V and the current is 10AClear my choice
Problem No.2 group Six group of batteries are in parallel. Each has 10 cells connected in series, each has an internal emf of GV and resistance fo 0.412. a. Determine the equivalent emf and the internal resistance of the battery system.. b. If a 1-kn load resistor is connected to the battery system, what is the power dissipated to this load venistor? c. In & hre operation, determine the total energy delivered source to the 1-ks load resistor. the by
2. Determine the equivalent resistance between the terminals a and b 352 C0.6660 0.60 0.33352
Consider Two same size PV Modules which are connected in Parallel. The specification of each module is given as: Number of cells = 36, Area of each cell is 12 cm x 12 cm. (Assume the necessary data) Choose from the following the correct statement. a. The output voltage of this panel is 18 V, the output power is 155W b. The output voltage is this panel 18V, the output power is 75W c. The output voltage is this panel 36 V, the output power is 155W d. The output voltage is this panel 36 V, the output power is 75W
1. A small chrome plating tank needs a 1000 ampere source. Design an ammeter shunt for a 50 µA D'Arsonal meter movement that has a coil resistance of 2500 ohms. What is the resistance of the shunt in parallel with the meter? O a. 50 micro ohms O b. 10 micro ohms O c. 100 micro ohms O d. 125 micro ohms O e. 250 micro ohms
All parts or none .... I vll upvote
W1 A 1 IL Tr1 AC Supply V V w2 12 Tr2 use double range voltmeter Fig.(1)
20. The resistance R and a 2 μF capacitor are connected in series across 200-V dc supply. Across the capacitor is a neon lamp that strikes at 120 volts. Calculate the value of R to make the lamp strikes 5 seconds after the switch has been closed. A. 4.89 kΩ B. 4.89 MΩ C. 2.73 MΩ D. 2.94 MΩ