The difference in elevation between observed points A and B is 25m and the horizontal distance between them is 50 m. With transit at Sta. O, additional information was obtained as shown in the table. Determine the stadia intervals at A and B. Assume K = 100 and C = 0 Station Rod Reading (m) VCR Occupied Observed A 2.9696 20 2.6969 19

The difference in elevation between observed points A and B is 25m and the horizontal distance between them is 50 m. With transit at Sta. O, additional information was obtained as shown in the table. Determine the stadia intervals at A and B. Assume K = 100 and C = 0 Station Rod Reading (m) VCR Occupied Observed A 2.9696 20 2.6969 19

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

3:14 م أنت الآن nt/1/CELS%202100%20Part%208%20%28C%29.pdf 4 /5 100% Q25. The length and angles obtained during surveying of a park with a 30 m tape is shown in the following Fig. 25. The tape used was 30 mm too long. 15 38 45 4.5 m 90 Fig. 25 i) Calculate the correct area of the park. 2.5 ii) Calculate the correct perimeter of the park. 2.5 Page 4 of 5 个 I
REE - Apr. 2001 18. Determine the divergence of the vector: V = i(x) + j(-xy) + k(xyz) at the point (3, 2, 1) A. 13.00 B. 9.00 C. 11.00 D. 7.00
34 Assignment In order to carry out tacheometric surveying, following observations wer taken through a tacheometer set up at station P at a height 1.235m. Compute the horizontal distance of S from P and reduced level of statio at S if R.L. of station P is 262.575m Staff held Vertical at Dr Q R S Horizontal distance from P (m) 100 200 ? 20. K ENGIN Staff Reading (m) 1.01 2.03 3.465, 2.27, 1.280 2.03m 1.01m 100m 200m Angle of Elevation 0° 0° 5° 24' 40"
I need Answer of A only A. A tachometric surveying was conducted to obtain some readings forinaccessible points, where it was found that the multiplying and additiveconstants are 98 and 0.1, respectively. The instrument was setup at point C and the readings listed in the table were taken while the staff was held vertically. Calculate the horizontal distance between BM and station D. Also, calculate the reduced level of station D. Figure 1 shows a schematic view of the site.
Stadia Tacheometric Survey Problem 3. In the figure, the difference in elevation between observed points A and B is 15 m and the horizontal distance between them is 35 m. With transit at Station O, additional information was obtained as shown in the table. Determine the stadia intervals at A and B. Assume K=100 and C = 0. Occupied O Station Observed A B B RR (m) 1.863 1.500 S ? ? A VCR 12° 10°
3. A transit with stadia interval factor of 100.8 was set up at point C on the line between points A and B. The following readings were observed HAIR READING ROD UPPER MIDDLE LOWER A 1.972 1.854 1.732 1.01 1.33 If the distance from the focus is 0.38m. determine the following B 1.175 a. Horizontal distance between A and B. b. Difference in elevation between A and B if the value of HI are 300m and 315m respectively.
A transit with a stadia interval factor of 98.99 was set at C on the line between points A and B, the following stadia readings were observed. (draw the Instrument set up) Rod Position Vertical Angle Stadia Hair Readings (m) Upper (a) Middle (c) Lower (b) Rod Held at A + 60 27’ 3.678 2.491 1.287 Rod Held at B - 40 31’ 2.154 1.618 1.082 If the stadia constant is 0.29 m determine the following: Length of line AB (horizontal). ANSWER: ____________________ If the elevation at B is 782m what is the elevation at A. ANSWER: ___________________
A tachometric surveying was conducted to obtain some readings forinaccessible points, where it was found that the multiplying and additiveconstants are 98 and 0.1, respectively. The instrument was setup at point C and the readings listed in the table were taken while the staff was held vertically. Calculate the horizontal distance between BM and station D. Also, calculate the reduced level of station D. Figure 1 shows a schematic view of the site.
A transit with a stadia interval factor of 100.80 was set at C on the line between point A and B, and the following stadia readings were observed. If the stadia constant is 0.318m, determine difference in elevation between points A and B. (Use 3 decimal places) Position of Rod Rod held at A Rod held at B Vertical angle +25°35' -18°08' UPPER 1.330 1.972 Hair Readings MIDDLE 1.175 1.854 LOWER 1.020 1.736
19. Using this data set explain how you could estimate how often control needs to exist if you want to keep error ellipses and elevation coordinate standard deviations under .1 ft. 20. Job1n.1d and job1n.2d are results from the same .obs processed very differently compared to job1.
pls help me solve this. 1) a transit with stadia interval factor of 100.8 was set up at point C on the line bet. A and B. The ff. readings were observed: (*see from attached photo) If the distance from the focus is 0.38m. determine the ff.: a) horizontal distance bet. A and B b) Diff. in elevation bet. A and B of the value of HI are 300m and 315m respectively.
A transit with a stadia interval factor of K = 100 and C = 0.381 was set at point C on the line between points A and B, and the following stadia readings were observed- Vertical Hair Readings(m) angle(°) | Upper Middle Lower 1.325 1.806 Position of Rod 1.450 1.850 1.200 1.762 Rod held at A 15.58 Rod held at B -8.13 Determine the following: a) length of line AB b) difference in elevation between points A and B