The conductors of a 10 km long, single phase, two wire line are seperated by a distance of 1.5 m. The diameter of each conductor is 1 cm. If the conductors are of copper, the inductance of the circuit is ??

Q: A. For the following figure, the diameter of each conductor is 2.5 cm. Find the inductance and…

A:

Q: Redo it again with full details..

A: Given: 3:8 Decoder To find: we have to form the truth table for 3:8 decoder.

Q: Which Arc Extinction Method operates by increasing the Arc Resistance by lengthening the Arc? A. Low…

A:

Q: Number of parallel paths in a wave winding is equal to the number of magnetic poles True False

A: Number of parallel paths in wave winding is 2. In wave winding : A = 2   In case of lap winding…

Q: True or False rotates a phasor (a) faster than operator (j)

A: True or False rotates a phasor (a) faster than operator (j)

Q: The bridge method commonly used for measuring mutual inductance is: A. wheat stone bridge B. Wien…

A: Given Bridges, A. wheat stone bridge B. Wien bridge C. De Sauty bridge D. Heaviside campbell bridge

Q: Derive the expression for total inductance of a transmission line.

A: According to the question we have to drive the expression for total inductance of a transmission.

Q: The voltage in Fig. 5 is applied across a 30uF capacitor. Draw the current waveform through it. (1)…

A: This question belongs to circuit theory . It is based on the concept of drawing current waveform…

Q: The ACSR conductor Falcon is used in a 3-phase equidistant configuration with D = 25 feet. The per…

A: Given data : distance D=25 feet

Q: Given a single phase inductance Lm.1) ,1phase = 12 mH, what is the mutual inductance between stator…

A: Given:Single phase inductance Lm,1 phase=12 mH

Q: (b) Define the five of the following: Ampere's Law, Gauss's Law of electric field, Standing wave,…

A:

Q: A series RL circuit has a resistance of 6 ohms and a inductive reactance of 10 ohms. If connected…

A: It is given that: R=6 ΩXL=10 ΩV=120 V

Q: Q6/B: A three-phase double circuit line is shown below, the diameter of each conductor is 2 cm. F…

A:

Q: The number of disc insulators used in a suspension insulator setup with string efficiency 80 %,…

A: In this question , we will find no of disc insulator used with given data..

Q: 12. The ac resistance of a slab conductor is depending on.

A: AC resistance of slab conductor depends on proximity effect and skin effect. Skin effect : When a…

Q: Calculate the capacitance / phase / km of the line.

A:

Q: How far should a quarter wave transformer be located from a load of 123.45ohm with Zo = 100ohm ?…

A:

Q: a string of 2 suspension insulators, each unit has a self capacitance X and a pin to earth,…

A: Given a string of 2 suspension insulator has, Self capacitance, Cs=X. Mutual capacitance, Cm=0.1X.…

Q: An ACSR conductor has 54 aluminum stands with each strand diameter of 0.1628 inches. The steel core…

A: Given : An ACSR Condution has N 54 Aluminum stands,each stands diameterda = 0.1628 inchesCross…

Q: The number of disc insulators used in a suspension insulator setup with string efficiency 80 %,…

A: In this answer let us find the number of insulator discs in order to obtain a string efficiency of…

Q: 1. What is the phase relationship between R, L, and C components in a series AC circuit? 2. What is…

A: The solution is given below

Q: Sinusoidal voltage (or emf) is generated by rotating a conductor by means of a spindle in a uniform

A: In this question we need to complete the given statement .

Q: A circuit consists of an AC voltage source, a 10-ohm resistor, and a capacitor, all connected in…

A: A resistor of 10 ohm is connected in series with a capacitor of impedance 10 ohm. We have to…

Q: Noise due to inductive coupling can be reduced by twisting the wires carrying a signal. True False

A: In radio frequency when disturbance in external source affects the electrical circuit by…

Q: Each conductor of a 3-0 overhead line is suspended from a cross arm of a steel to a string of 4…

A:

Q: What is the relation between the voltage drop and the distance in radial and ring circuit?

A: Concept: Using a constant voltage system, electrical power distribution is performed. Radial…

Q: The validity of Ohm's law in AC circuits and impedance?

A:

Q: Find the inductance in mH/km of the follo

A:

Q: Eddy current losses can be reduced by making the core of a stack of plates electrically insulated…

A:

Q: In a series AC resistive circuit: O a) voltage leads current by 90°(degrees). b) current leads…

A: Option c Current and voltage are in phase

Q: what will be the total and unit for impedance if the given is 8mA and 9mV?

A: Electrical impedance is the amount of opposition that a circuit presents to current or voltage…

Q: 2 The conductors in a single phase ine are 6m above the guünd. Each conductors are spaced 3m a pant.…

A:

Q: If the area of cross-section increases, the resistance of the conductor decreases. Select one: O…

A:

Q: The ACSR conductor Falcon is used in a 3-phase equidistant configuration with D = 42 feet. The per…

A: Given data, D=42 feet Standard data, For Falcon ACSR(steel) Diameter=0.5150 inch

Q: Determine the Primary Conductor Size (include the AWG size number), Secondary Conductor Size…

A: P= 90 KVA Three phase transformer 400/230 V

Q: 1. What is the phase relationship between R, L, and C components in a series AC circuit? 2. What is…

A:

Q: The inductance effect is predominant in underground cables than overhead lines. Select one: True…

A: In this question we have to define inductance effect in cable...

Q: APPLICATION  OF IMPEDANCE AND ADMITTANCE IN AC CIRCUIT

A: we need to answer what are the APPLICATION  OF  IMPEDANCE  AND ADMITTANCE IN AC CIRCUIT .

Q: 6. In symmetrical components, if IR1 90° What is the value of Ip ? 100 z 30° and Iy2 = 20 -

A: From the symmetrical components

Q: A 300 Km single circuit 30 transposed TL is composed of 2 conductors per phase, with horizontal…

A: In this question, we need to choose the correct options. What is GMR and total inductance .

Q: Which of following layer is below the drift layer in non bunch through IGBT ? a) p- B) n- c) p+ D)…

A: The Insulated Gate Bipolar Transistor (IGBT) can be classified Punch Through IGBT      2.Non-Punch…

Compensation Techniques

The compensation techniques are the methods that are employed in the electrical control systems to enhance the performance of the system. The performance are generally affected by the factors like lag in the compensating devices, slow response of the system of the components like sensors used in the control system. The basic compensation technique involves lag compensation, lead compensation or the combination of the both.