The built-up steel beam section is shown in the figure.   Determine the center of gravity (mm) about the indicated x- axis.0 Determine the center of gravity (mm) about the indicated y-axis.0 Determine the moment of inertia, _ x 108 mm4 with respect to the centroidal y-axis.0

Q: A -40 ft- H 000 oooooo B P₁ 40 ft- G Ţ P₂ 40 ft- F ၁၁၁ D 40 ft- 15 ft 30 ft E

A:

Q: RA L RB

A:

Q: Situation 1: A simple curve have tangents AB and BC intersecting at a common point B. AB has an…

A:

Q: Problem 3. Calculate the maximum depth, h, behind the concrete dam below that maintains a factor of…

A:

Q: Describe something on the slide or figure that you understand, then create a question to ask a…

A: The image shows the graph drawn between the body's mass to the minimal weight and the specific cost…

Q: Draw shear force and bending moment diagrams for the frame shown in Fig.1. Assume the support at A…

A:

Q: When an unconfined compression test was conducted on a cylindrical soil sample, it failed under an…

A: Given- confining pressure σc=σ3=0,deviator stress σd=σ1=120 kN/m2,Angle of failure plane…

Q: #2 Determine the force in members GF, FC, and CD of the bridge truss. State if the members are in…

A:

Q: 3. Draw the free-body diagram 4. Write the equilibrium equations 5. Apply the method of sections at…

A:

Q: Determine the deflection at point C using moment area method

A:

Q: 1. Four forces are applied to point P as shown. Knowing that F₁ = 50 lb, F2 = 20 lb and F4 = 70 lb,…

A:

Q: 2. Consider the same coplanar nonconcurrent force system above. Determine the following: a. Angle of…

A: The distances of each grid is 1' The summation of forces in x and y direction should be determined.…

Q: Determine the displacement at B using Moment-Area Method

A:

Q: Determine the reactions R₁ and R₂ of the beam is loaded with a concentrated load of 1600lb and a…

A:

Q: A duct of diameter 0.8 m carries gas (p = 1.3 kg/m³). At one point, the duct diameter reduces to…

A: Given : dia of duct = 0.8 m reduced dia of duct = 0.74m To Find : The velocity of flow in reduced…

Q: 1. All level should have a minimum frequency of sampling for drinking water for physical and (How…

A:

Q: 2. A 100 m tape is suspended at the ends under a pull of 15 kg. It has also supports at 30 m and 75…

A:

Q: The pressure inside a soap bubble of 10 mm diameter above the atmosphere is (o = 0.04 N/m) 1. 2. 3.…

A: Given data- dia D=10 mm,surface tension σ=0.04 N/m, To Find- The pressure inside the soap bubble.

Q: An axial bar is shown below. E = 200 × 10⁹ Pa, A = 0.42 × 10-3 m². The bar can be divided into two…

A:

Q: Problem. An 8-meter simply supported beam is loaded with concentrated loads as shown. If the weight…

A: Given Diagram, We have to find out (i) reactions at supports (ii) Shear Force Diagram (SFD) &…

Q: Discuss what types of clay minerals are likely to be produced under the following morphoclimatic…

A: Clay is one of the fine-grained natural soil which contains clay minerals. Clay minerals usually…

Q: mp is formed in a 5 m wide outlet at a short distance downstream of control gate. If the flow depths…

A:

Q: Draw the S.F.D and B.M.D for the frame in the system shown in Fig. 10 kN/m B 3 m 20 kN to 10 m 3 m Y…

A: We need to draw shear force and bending moment diagram of the given frame. First we will find…

Q: A uniformly distributed line load of 500 kN/m is acting on the ground surface based on Boussinesq's…

A: Given data: A uniformly distributed line load of 500 kN/m. The ratio of vertical stress at a depth 2…

Q: The moist unit weight of a 0.00566 m³ of a soil is 0.1023 kN. The moisture content is 11%. If the…

A: find the volume Occupied by water.

Q: A 3m long cantilever beam of solid rectangular cross-section of 100mm width and 150mm depth is…

A:

Q: RA -L/2- P -L- -L/2- R₁

A: Required : To derive the equation for maximum deflection for given beam beam using double…

Q: 1.5 Why is it important to make accurate surveys of underground utilities?    1.6 Discuss the uses…

A: Answer (1.5) Underground utilities are accurately surveyed in order to achieve following scenarios…

Q: What is the difference between earthquake magnitude and earthquake intensity? Also how is the…

A: Earthquake Magnitude-  Earthquake magnitude measure the size of earthquake .  Magnitude remains…

Q: A gas is stored in a cylindrical tank of inner radius 7 m and wall thickness 50 mm. The gauge…

A: inner radius of cylindrical tank(R) = 7m wall thickness(t) = 50mm Gauge pressure of gas = 2MPa To…

Q: A compund curve is laid out 496.63 meters from the P.C. to P.CC. having a radius of 745.57 meters.…

A:

Q: lem 2. A steel tape weighing 0.85 kg has a cross-sectional a res exactly 30.00 m when supported…

A: Given data, Total weight of tape = 0.85 Kg area of cross-section = 0.05 cm2 Nominal length = 30m…

Q: A rectangular plate is supported by three cables as shown. Knowing that the tension in cable AD is…

A: Given data:-

Q: Find the absolute maximum shear in the girder of the floor beam system shown in Fig. (1), due to the…

A:

Q: 1. calculate various angles and support reactions. 2. Using method of joints, calculate the forces…

A: Given figure shows the truss Required- to calculate support reactions member forces and to plot the…

Q: Determine the reactions of the structure, given that X= 7 ft. 10 kips F ———X—₁▬▬▬▬▬▬5²- The…

A: Given data:- X = 7 ft.

Q: please

A: using Hortens equation :f(t)=fc+(fo-fc)e-ktfo=2.4inhrfc=0.5inhr

Q: A strip footing is resting on the ground surface of a pure clay bed having an undrained cohesion c.…

A: Bearing capacity of soil is defined as the capacity of soil to support the applied loads over the…

Q: Construct the load, shear & moment diagrams for the following using the semi- graphical approach.…

A: Given data A simply supported beam with 4 dead loads and 4 service loads. Each load is separated by…

Q: What is a geocentric coordinate system?

A: to know about geocentric coordinate system

Q: Two years ago, Snoop Lion deposited P15,000.00 in a fund that earns 10% interest compounded…

A: Given Interest rate = 10% compounded semiannualy 15000 deposited 2-years ago 10000 deposited today…

Q: 4.8 m 2 m ↓ 1.98 kN Ans. 0 = 33.7°, NA = 3 m 7. Determine the value of P and F to maintain…

A:

Q: Chlorine is used as the disinfectant in a municipal water treatment plant. It achieves 50 percent of…

A: Given data: Disinfection efficiency, η1=50 % Time, t1=3 min For Disinfection efficiency, η1=99 %…

Q: Q6/A grade gl of+ 1.23% intersects grade g2 of -2.75% at a vertex whose station 18+00 and elevation…

A: Given:- The gradient of first tangent = g1 = +1.23% The gradient of second tangent = g2 = -2.75%…

Q: express each measurement in inches.5 feet

A: Given:- The measurement in feet = 5 feet To determine:- Convert the given measurement in inches

Q: Give an insight and reflection about this "Health and Safety in the Construction Industry in…

A: Health and safety is usually concerned in areas or countries where there is development promotion…

Q: 6. Two cables are tied together at C and loaded as shown. Determine the tension in cable AC and BC.…

A: Given:Load at C=1.95 KNLet,TAC=Tension in the cable ACTBC=Tension in the cable BCθ=Angle made by the…

Q: Draw the S.F.D,A.F.D and B.M.D for members AB and BC of the frame in Fig. 5 kips/ft B A 20 ft + 5 ft…

A: Solution:

Q: 3 12 kN/m C A 15 kN/m 10 m D Figure P4.7 5 5 m 6 m

A:

Q: Situation 2: The common tangent BC of a reverse curve is 280 m and has an azimuth of 312º. AB is…

A: Solution:-