The armature of a four-pole 200 V, lap wound generator has 400 conductors and runs of 300 rpm. Determine the useful flux per pole. If the number of turns in each field coil is 900, what is the average induced emf in each field coil on breaking its connection if the magnetic flux set-up by it dies away completely in 0.1 second? *

The armature of a four-pole 200 V, lap wound generator has 400 conductors and runs of 300 rpm. Determine the useful flux per pole. If the number of turns in each field coil is 900, what is the average induced emf in each field coil on breaking its connection if the magnetic flux set-up by it dies away completely in 0.1 second? *

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Q2. A 4-pole, wave-wound armature has 72 slots with two coil-sides per slot, each coil has four turns. If the flux per pole is 20 mWb and the armature rotates at 720 rpm, what is the induced emf across the armature? (Ans. 276.48 V) 0.05
ASAP, answer now please..
The total conductor of the direct current generator shown in the figure is 1440. The length of the armature is 30cm, the magnetic flux of a pole is 0.8 Tesla and the armature rotates at a speed of 4 m / s. Find the value of the voltage generated by the armature according to the position in the figure.
Q2. A 4-pole, wave-wound armature has 72 slots with two coil-sides per slot, each coil has four turns. If the flux per pole is 20 mWb and the armature rotates at 720 rpm, what is the induced emf across the armature? (Ans. 276.48 V)
A 4-pole alternator runs at 1,200 RPM. There are 10,000 kilolines per pole. (a) Determine the effective voltage built up for each full pitch armature coil of one turn if the flux distribution in the air gap is sinusoidal. (b) Suppose that the armature coil is short 30 electrical degrees of being full pitch, what will be the effective voltage per coil? (a) What is the pitch factor for this winding? Ans. 17.76V; 17.15V; 0.966
Problem #1: A 6-pole, 3-phase, Y-connected, 60-Hz alternator has 12 slots per pole and 4 conductors per slot. The winding is 5/6 pitch. There are 0.025 Wb entering the armature from each north pole, and this flux is sinusoidally distributed along the air gap. The armature coils are all connected in series. Determine (a) pitch factor (b) distribution factor (c) induced emf per phase
3. A 4-pole armature of a d.c. machine has 1000 conductors and a flux per pole of 20 mWb. Determine the e.m.f. generated when running at 600 rev/min, when the armature is (a) wave-
The strength of the rotating magnetic field in a three phase induction motor is equal to times the flux produce ...... ....... in one of the phase windings. 1.25 1 O 1.5
A separately-excited dc generator develops 288 volts at a certain flux and at a certain speed. What should be the new generated voltage in volts for this machine if the speed is changed to 85 % of the original value and the flux is increased by 67 % from the original value?
i need the answer quickly