The arm in the figure below weighs 38.9 N. The force of gravity acting on the arm acts through point A. Determine the magnitudes of the tension force F, in the deltoid muscle and theforce F, exerted by the shoulder on the humerus (upper-arm bone) to hold the arm in the position shown. (Enter your answers to at least the nearest newton.)NF. =F0.080 m-0.290 m

Answered: Image /qna-images/answer/0b09be38-5034-4c3d-a46c-1cb1de64373b.jpg

The arm in the figure below weighs 38.9 N. The force of gravity acting on the arm acts through point A. Determine the magnitudes of the tension force F, in the deltoid muscle and t force F, exerted by the shoulder on the humerus (upper-arm bone) to hold the arm in the position shown. (Enter your answers to at least the nearest newton.) F = F. = F, 12° 0.080 m 0.290 m

The arm in the figure below weighs 38.9 N. The force of gravity acting on the arm acts through point A. Determine the magnitudes of the tension force F, in the deltoid muscle and t force F, exerted by the shoulder on the humerus (upper-arm bone) to hold the arm in the position shown. (Enter your answers to at least the nearest newton.) F = F. = F, 12° 0.080 m 0.290 m

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Related questions

Q: T=? 40° 400 N

A: We have a system where a rope having tension T is balancing a stich of length L which is carrying a…

Q: Take a look at this image. The skeleton with mass of 60.2 kg sits 52 cm from the balance point (d;).…

A: Answer..

Q: N A uniform plank of length 2.00 m and mass 31.0 kg is supported by three ropes, as indicated by the…

A: Given length of plank = 2.00 m mass of plank = 31 kg weight of person = W = 685 N person is at a…

Q: 1. Two traffic signals are attached to the 36 ft support cable at equal intervals as shown.…

A: Draw the free body diagram as below. Draw the diagram as below. ∑Fx=0 -TAB cosα+TBC cosβ=0…

Q: Determine the magnitude of the components of the force and the lever arm d that would put the…

A: Use the lever principle of balance That is F1d1=F2d2

Q: The joints of the human body can be studied as levers, as can be the elbow that appears in the…

Q: 77-kg man stands on his toes by exerting an upward force through the Achilles tendon, as in the…

Q: Everett is attempting to lift 112 N. The perpendicular distance from the weight to his elbow joint…

A: Please follow the steps below.Explanation:

Q: 3. The pulley shown in the figure is free to ride on the supporting guide wire. If the pulley…

A: Note:- you have posted two different question. As per guidelines, I will solve first question only.…

Q: 1. Problem 1: Determine the resultant in Newtons of the two forces acting on the screw using…

A: Given that:

Q: The plate is suspended using the three cables which exerts the forces shown. Express each force as a…

A: Solution: As per the given figure, The position vector of the BA is given as:…

Q: 18 D. From the step ladder shown in the figure, sides AC and CE are each 2.44 m long and hinged at…

Q: The arm in the figure below weighs 35.5 N. The force of gravity acting on the arm acts through point…

Q: The arm in the figure below weighs 35.1 N. The force of gravity acting on the arm acts through point…

A: Apply the torque balance equation about point O.

Q: As you are sitting, draw the FBD of your right foot. How would the FBD of your foot change if…

A: Given:- As you are sitting and you are standing on the right foot Find:- The free body diagram for…

Q: (a) What force, F, (force of reaction), should the woman in the Figure below exert on the floor with…

A: Step 1: Step 2:

Q: Look at the figure below. The horizontal beam weighs 200N, Find the tension in the cable if the…

Q: A plane is inclined at an angle of 30 degrees from the horizontal surface. A mass of 5kg is kept on…

A: mass m = 5kgangle g=10 m/s^2

Q: 1. Problem 1: Determine the resultant in Newtons of the two forces acting on the screw using…

Q: Four forces are exerted on the eyebolt as shown. If the net effect on the bolt is a direct pull of…

A: Vector.

Q: A 80-kg block is suspended as shown. The beam is weightless and is hinged to the wall at A. The…

Q: The flanged steel cantilever beam with riveted bracket is subjected to the couple and two forces…

Q: 1. A beam has a weight of 1425 N which acts at its center and a length of 2.30 m. Determine the…

Q: The large quadriceps muscle in the upper leg terminates at its lover end in a tendon attached to the…

Q: A cook holds a 2.17-kg carton of milk at arm's length (see the figure below). What force FB must be…

Q: 2. SOLVE THE FORCE ACTING ON THE 5 KN BLOCK IF IT IS IN EQUILIBRIUM. P 58⁰ 380

Q: If you hold your arm outstretched with your palm upward, the force to keep your arm from falling…

A: Draw the free-body diagram of the arm.

Q: 7. Three masses are hanging vertically as shown in the drawing on the right. Assume the pulleys are…

Q: The bear of weight 700 N walking on the horizontal beam pivoted at point A and supported by a rope…

Q: A bridge of length 57 m and mass 80000 kg is supported at each end. A truck of mass 38200 kg is…

Q: The flanged steel cantilever beam with riveted bracket is subjected to the couple and two forces…

A: Let split the force 1.91 kN as 1.91 cos 80i^+1.91 sin 80j^= 1.910.331i^+1.88j^=1.91 ..(i)Split the…

Q: The flanged steel cantilever beam with riveted bracket is subjected to the couple and two forces…

Q: Jamal and Dayo are lifting a large chest, weighing 264 lb, by using the two rope handles attached to…

A: Visualize the Problem:

Q: Sam and Joe carry a beam, walking to the right. Calculate the force that Sam exerts, in pounds.…

A: weight of Beam , W=163lblength of beam , L=22 ftsam is 5ft from the backJoe is 5ft from the front

Q: Figure FM 15 -12 cm-- 24 cm- 1 of 1 Calculate the magnitude of the force, FM. required of the…

Q: Problem 6: The figure shows the forearm of a person holding a book. The biceps exert a force FB, and…

A: Apply the equilibrium condition of torque about the elbow joint and substitute the corresponding…

Concept explainers

Torque

Torque is the rotational equivalent of linear force in physics and mechanics. Based on the course of study, it is also known as the moment of force, rotational force, or turning effect.

Question

100%

The arm in the figure below weighs 38.9 N. The force of gravity acting on the arm acts through point A. Determine the magnitudes of the tension force F, in the deltoid muscle and the
force F, exerted by the shoulder on the humerus (upper-arm bone) to hold the arm in the position shown. (Enter your answers to at least the nearest newton.)
N
F. =
F
0.080 m
-0.290 m

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Trending now

This is a popular solution!

Step by step

Solved in 4 steps with 4 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

i need the answer quickly
The large quadriceps muscle in the upper leg terminates at its lower end in a tendon attached to the upper end of the tibia (see Figure a). The forces on the lower leg when the leg is extended are modeled as in Figure b, where T is the force of tension in the tendon, w is the force of gravity acting on the lower leg, and F is the force of gravity acting on the foot. Find T when the tendon is at an angle of 25.0° with the tibia, assuming that w = 29.0 N, F = 12.3 N, and the leg is extended at an angle ? of 40.0° with the vertical. Assume that the center of gravity of the lower leg is at its center and that the tendon attaches to the lower leg at a point one-fifth of the way down the leg. (Give the magnitude.)
The man is holding upthe 35-kg ladder ABC by pushing perpendicular to the ladder. The total length of the ladder is AC= 6m. If the maximum force that the man can exert is 400Nat B which is 2m from A, determine the smallest angle, theta, at which the man can support the ladder.
A cook holds a 2.33-kg carton of milk at arm's length (see the figure below). What force FB must be exerted by the biceps muscle? (Ignore the weight of the forearm. Give the magnitude.)
The pulley system holding a crate of unknown weight is at equilibrium. Cord BD can support a maximum load of FBD = 1860 N. www D 01 A B a. Determine the maximum weight of the crate, W. b. Determine the angle 0₁. Round your final answers to 3 significant digits/figures. ) N W = 0₁ = 12 5 13 degrees
The door has a weight of 230 lb and a center of gravity at G. (Bouto 1) Figure ▼ Part C NA = 1 of 1 HÅ Value Determine the constant force F that must be applied to the door to push it open 19.0 ft to the right in 5 s. starting from rest. Express your answer to three significant figures and include the appropriate units. Submit Request Answer Part B. Value Units Submit Previous Answers Request Answer X Incorrect: Try Again; 5 attempts remaining μA Also, find the vertical reaction at the roller B Express your answer to three significant figures and include the appropriate units. No - Value Submit Also, find the vertical reaction at the roller A. Express your answer to three significant figures and include the appropriate units. Previous Answers Request Answer Units Units ?
USING THE COMPONENT METHOD, SOLVE THE FOLLOWING: Four forces acting on a bolt A as shown, determine the magnitude and the direction of the resultant. F = 150 N F; = 115 N 12 40° 55 F3 = 95 N F4 = 130 N 25
Look at the figure below. The horizontal beam weighs 200N, Find the tension in the cable if the object hanging on it is 350N. (Note: its center of gravity is at its center)
The flanged steel cantilever beam with riveted bracket is subjected to the couple and two forces shown, and their effect on the design of the attachment at A must be determined. Replace the two forces and couple by an equivalent couple M and resultant R at A. The couple is positive if counterclockwise, negative if clockwise. 2.20 KN 0.45 m 1.55 m 68° A Answers: M = i R = ( L. 620 N.m kN-m i+ i 1.02 KN 0.18 m 0.18 m j) kN
The leg and cast in the figure weigh 220 N (w1). Determine the weight wz and the angle alpha needed so that no force is exerted on the hip joint by the leg plus the cast. 110 N
The screw is subjected to two forces F1 and F2.Determine:a. the magnitude b. direction of the resultant force
3. The pulley-cable system supports the 150-lb weight. The weights of the pulleys and the horizontal bar ABC are negligible. Determine the cable tensions at A and Cand the distance x. 3t 150 Ib