The ___________ command is used to change the router name in packet tracer. Host Name Namehost Hostname Name Host
Q: When a computer attempts to connect to a host with a recognized IP address on another network, what…
A: In order to track the IP addresses or names of the commenters a client uses the help of the UNS…
Q: In which of the following scenarios, the packet will be forwarded directly to the destination host…
A: In computer networking, a default gateway helps in passing signals through the default route between…
Q: A router in the same subnet as a designated router will share routing information with which routers…
A: option c - designated router and backup designated router. These routers helps to exchange…
Q: What type of interface represent an EtherChannel as a whole? a. Channel b. Channel Port…
A: Note we are only allowed to solve one question in one post. please post-second question in a new…
Q: Subnet the network address 200.100.10.0/24 according to the required number of usable host addresses…
A: Given : Subnet the network address 200.100.10.0/24 according to the required number of usable host…
Q: Laptopo Laplop2 120 hosts Switcho [ 61 Hosts ilch1 30 Hosts 15 Hosts Swich2 Swich3 R2 R3 Sample MAC…
A: ANSWER:-
Q: In a network, the local hosts are able to communicate only within the LAN, but are not able to…
A: In a network, the local hosts are able to communicate only within the LAN, but are not able to…
Q: Refer to the below exhibit. What protocol should be configured on SW-A Port O/1if it is to send…
A: Lets see the solution.
Q: MCQ: When a new host is connected to a switch with STP enabled, what mode is the port placed into?…
A: When a new host is connected to a switch with STP enabled, the port is placed into Blocking mode.…
Q: Answer the following questions and provide the commands and screenshots where applicable in a…
A:
Q: When a host on network A sends a message to a host on network B, which address does the router look…
A: Actually, network is a group or interconnected people or things.
Q: Analyze the below diagram. The client is sending a message to the Whatsapp server. Fill the missing…
A: Destination MAC bbbb:1111:aaaa Source MAC aaaa:1111:aaaa Source IP 20.4.4.1/24 Destination IP…
Q: Find the Network address, subnet mask and broadcast address of the network 80 Hosta LAN 1 10.0.0.0/8…
A: Given : Find the Network address, subnet mask and broadcast address of the network
Q: Which of the following device is used to connect two systems, especially if the systems use…
A: Please find the answer below
Q: Which of the following allows a router to respond to an ARP request that is intended for a remote…
A: Given that: Which of the following allows a router to respond to an ARP request that is intended for…
Q: A Network switch is used to create a LAN with 5 hosts (host1, host 2, ….host5). How will the…
A: (i) Host 1 sends two consecutive frames to host 3 after which host 3 sends two consecutive frames…
Q: Assume that Host C hosts a Web server that is accessible via port 80. Assume that A and B are the…
A: Introduction: Consider a Web server that supports persistent connections operating on Host C on port…
Q: Q10: Complete the frames (x & y) given below with appropriate port, IP and MAC addresses. The sender…
A: A packet is the unit of data used in the network layer, a frame is the unit of data used in the OSI…
Q: A receiving host computes the checksum on a frame and determines that the frame is damaged. The…
A: . data link
Q: NAT I A Cone NAT is using port X for a private host. Which external hostis) are allowed to use…
A: A Cone NAT is using port X for a private host. Which external host(s) are allowed to use port-X to…
Q: Which type of connection is used to transmit two packets over a medium at the same time? A…
A: Synchronous and Asynchronous transmission are the two types of serial data transmission techniques…
Q: A _____ is a device that forwards packets between networks by processing the routing information…
A: A _____ is a device that forwards packets between networks by processing the routing information…
Q: 2. Based on the number of hosts in the topology, you need to calculate the NIDS and FHID,LHID, BID,…
A: 172.16.0.0/16 Here we will assign one by one bits for each subnet. Here the number of network bits…
Q: The following packet captured by Tcpdump shows "win 512" which indicates ___________________.…
A: 09:32:43:9147882 This is the time stamp in the format of two digits for hours, two digits for…
Q: 6- Which of the following is the multiple access protocol for channel access control? a) CSMA/CD b)…
A: NOTE :- As per our company guidelines we are supposed to answer only first 3 sub-parts. Kindly…
Q: Which one of the following mechanism can be used to prevent a sigle point of failure at the default…
A: According to the asked question, the solution is given below with a proper explanation.
Q: What will the router do when it received a packet and encapsulate this packet with new Ethernet…
A: Dear Student, A packet if has to be dropped is dropped before sending it to the egress port or exit…
Q: Multiple When a new host is connected to a switch with STP enabled, what mode is the port placed…
A: The question asks for choosing the correct mode a port is placed into when a new host is connected…
Q: What does it mean when someone refers to DHCP, or dynamic host configuration protocol
A: Please find the answer below
Q: a host find out the MAC address of the nearest router (= default gateway)
A: a host find out the MAC address of the nearest router
Q: Do fou Phase 1: Addressing the WANS, LANS & VLANS DCE so0 Galway Internet Seve simule rternet 10…
A:
Q: MCQ: Which of the following is a better solution to defend DoS attack in a network? a. Packet…
A: Better solution to defend DoS attack in a network
Q: You are given this IP address 195.143.208.133/28. Give its Subnet address Site address NetID
A: AS PER THE POLICY, ONLY FIRST THREE PARTS ARE ANSWERED. In case you want an answer for other parts,…
Q: Assume that Host C hosts a Web server that is accessible via port 80. Assume that A and B are the…
A: Introduction: The source and destination IP addresses, as well as the source and destination port…
Q: How does a host find out the MAC address of the nearest router (= default gateway)? Group of answer…
A: Answer: It sees the router's IP in the computer configuration and then sends an ARP request
Q: Q10: Complete the frames (x & y) given below with appropriate port, IP and MAC addresses. The sender…
A: Actually, IP stands for Internet Protocol.
Q: In the calculation of the maximum available valid host addresses in each subnet, the total addresses…
A: Here in this multi part question we have asked that while calculating valid host address ,2 host…
Q: down the command that specifies the maximum number of MAC addresses that can be used on a port in…
A: To configure the given scenario the commands required are as follow's- Switch(config)#int…
Q: Which of the following is a static routing feature? * a. Security increases because only the network…
A: In Static routing, a router uses a manually-configured routing entry, rather than information from…
Q: Assume Host C has a Web server listening on port 80. Assume A and B are the web hosts. Is every…
A: Here is the Answer
Q: HTTP persistent a. Create signal TCP connections. b. Create one connections only. c. None is true.…
A: Please find the answer below
Q: Which of the following is a form of hub that routes packets to the proper port depending on the…
A: Intro It is the process through which systems decide where to send a packet which is known as…
Q: Which of the following is the broadcast address that class B network ID using the default subnet…
A:
Q: MCQ272: The Mobile Application Protocol (MAP) typically runs on top of which protocol ? a. SNMP…
A: This question is related to Network protocols.
Q: Which parameter must be specified while redistributing a route into EIGRP? Administrative Distance…
A: The use of a routing protocol to advertise routes that are learned by some other means, such as by…
Q: Q No 7 a) A host with IP address 132.23.44.20 and physical address B2:34:55:10:22:10 has a packet to…
A: ARP is Address Resolution Protocol. An ARP request contains the IP and Physical address of the…
Q: network administrator is verifying the configuration of a newly installed host by establishing an…
A: the correct answer is application
Q: Assume that Host C hosts a Web server that is accessible via port 80. Assume that A and B are the…
A: Given: Assume that Host C hosts a Web server that is accessible via port 80. Assume that A and B are…
Q: 4. Which of the following ICMP packets is used to detect the connectivity between the source and…
A: 1. ICMP Echo It is used to ping the network to detect the connectivity between source and…
The ___________ command is used to change the router name in packet tracer.
Host Name |
||
Namehost |
||
Hostname |
||
Name Host |
Step by step
Solved in 2 steps
- In data Encapsulation Decapsulation Routing O Addresing MAC sublayer adds header and a trailer to the IP Packet * It primarily refers to error detection and retransmission. * Error checking Error control Error detection Error codingA router receives a packet with a destination address that is not found within its routing table. The router is configured to send all such packets to a specific next hop address. What is this next hop address called? Dynamic route Discard route Final route Default routeIPV4 is a Connection oriented Protocol. * False True Broadcast is the process of sending a packet from one host to a selected group of hosts. * False True The prefix length is the number of bits in the address that gives the Host portion. " False True The metric is used to decide which route appears on the routing table. * True False The throughput value is greater than The Bandwidth Value. * True False O O O O
- In link state routing, flooding allows changes to be recorded by: some routers neighbor routers only all Internet routers all routers in the subnet domain5 When a router cannot route a datagram or host cannot deliver a datagram, the datagram is discarded and the router or the host sends a message back to the source host that initiated the datagram. Destination unreachable Time exceeded Router error Source quenchIf a host's routing table has an entry of 0.0.0.0/0 in its routing table, the associated Gateway address will usually be:
- MC9: In wireless LAN communication, MACA is widely used. In this protocol, in order to avoid collision, a sender can send sender is granted the privilege to send a frame to the receiver only after it receives request signal to a receiver. The replied from the receiver. RTS, RTS CTS, CTS RTS, CTS CTS, RTSA host in class C does not know its IP address and wants to send a message to a bootstrap server to find its address. what are the source and destination addressesOn a TCP connection, current congestion window size is 4 KB. The window size advertised by the receiver is 6 KB. The last byte sent by the sender is LastByteSent = 10240 and the last byte acknowledged by the receiver is LastByteAcked = 8192. The current window size at the sender is_____(in bytes)
- Metric is used to choose between multiple paths learned via the different protocols True False is the interface that allow you to include an IP subnet in the routing protocol without sending updates out of the interface * O Loopback interface Passive interface Physical Interface Ethernet interface In Equal Cost Multi Path, If you have one particular host that is talking to a web server, its traffic for that flow will be divided between routers. * False TrueA default static route is similar to a default gateway on a host. The default static route specifies the exit point to use when the routing table does not contain a path for the destination network. A default static route is useful when a router has only one exit point to another router, such as when the router connects to a central router or service provider. To configure an IPV4 default static route, use the following command: Router# ip route 0.0.0.0 0.0.0.0 { exit-intf | next-hop-ip} O True O FalseFind the odd one out. Link state update Link state request Link state response Hello packet What is the default router priority value for all OSPF router? 0 1 200 255