System: N = 3; q = 4. A)what is the Number of microstates with one heat unit in the second oscillator. B) what is the Number of microstates with 3 heat units in the first oscillator.
Q: 1) A particular fluid has the fundamental equation of state S = A (N²V²E)'/5 where A is a constant.…
A: S=A(N2V2E)15 (a) The chemical potential is defined as : μ=-T∂S∂N μ=-T∂∂NA(N2V2E)15μ=-TA(V2E)15∂∂NN25…
Q: Problem 2: A bubble of CO2 forms at the bottom of a lake and rises to the surface. Recall that the…
A: Here, the bubble A expands adiabatically, and the bubble B expands isothermally, the expressions for…
Q: Calculate the ratio between the population of state 1 and state 2 two for the following two systems…
A: Energy difference in system a, ∆E=10-21J Energy difference in system b, ∆E=10-20J Temperature,…
Q: piston mA ideal gas A movable piston (mass = m and cross-sectional area = A) holds 0.5 mol of an…
A:
Q: all electric immersion heater is used to heat 85 g of water for a cup of instant coffee. The heater…
A:
Q: A sealed container with a fixed volume has 4 moles of ideal gas at a temperature of 440 K. 3.9 x 104…
A:
Q: The heat of melting of ice at 1 atmosphere pressure and 0°C is 1.4363 kcal/mol. The volume of ice is…
A:
Q: Energy is emitted from a hole in an electric furnace at the rate of 20 watt, when the furnace is at…
A: To find- Area of hole (A)=? Given- Energy radiated dQdt=20 watts Temperature (T)=2270C=(227+273) K…
Q: 15 Which figure represents the path for the work on the gas, if the work was given by: W=P,(V-V)?…
A:
Q: The heat engine shown in the figure uses 2.0 mol of a monatomic gas as the working substance.…
A:
Q: Since heat is always transferred to/from the calorimeter, What is the ideal value (high or low) for…
A: The "calorimeter constant" is just the specific heat of the calorimeter and its thermal…
Q: 11. A helium-filled toy balloon has a gauge pressure of 0.226 atm and a volume of 10.O L. How much…
A:
Q: Question 5 How much is the power heat dissipation from a metal plate of area 4 m² heated to a…
A:
Q: A 300-g piece of ice at 0 °C is placed in a liter of water at room temperature (20 °C) in an…
A: Given that:-Mass of ice=300 gm=0.300 kgInitially temperature, T1=0°CFinal temperature,…
Q: The constant volume c, and pressure c, heat capacities can be treated as the temper- ature…
A: Heat is nothing but the energy in transit. Whenever there is a difference in temperature between two…
Q: constant pressure P the volume of a gas increases from V1 to V2 when ‘Q’ amount of heat is removed…
A: C
Q: Suppose V₁=160 cm³ in (Figure 1). Figure p (atm) 3- 2 1 V₁ 2V, 3V, 1 of 1 V (cm') Part A How much…
A:
Q: Argon is a monatomic gas whose atomic mass is 39.9 u. The temperature of eight grams of argon is…
A:
Q: Suppose you have a classical system that consists of N particles moving in three dimensions. You…
A:
Q: ned toy has a gauge pressure or 0.52 alm and a the helium in the balloon than it would be at zero…
A: Given value--- Initial pressure = 0.32 atm. constant volume = 9.33 l. final pressure = 0 atm = 0…
Q: Problem 7 How much error would one expect in determining the specific enthalpy by applying the…
A: P = 3000 psiT = 400 FNOTE : As per guidelines, first question is solved. Request you to post…
Q: Imagine a photon gas at an initial temperature of T = 400 K. What is the temperature of the photon…
A: GivenT1=400 kV1=VV2=3VT2=?γ=43 for photon gas
Q: A small electric immersion heater is used to heat 87 g of water for a cup of instant coffee. The…
A: Mass of water m = 87g Power P = 190 W Initial temperature Ti = 22 ° C Final temperature Tf = 100…
Q: J The specific heat capacity of water is the amount of energy (in Joules) required to raise the…
A:
Q: a system has five possible macrostates. The number of microstates for each macrostate is given…
A: a) The probability of a microstate is given by: P(microstate) = (number of microstates for that…
Q: The 2010 Nobel Prize in Physics was awarded for the discovery of graphene, a two-dimensional form of…
A: Since this is a 2-D lattice, an atom can only oscillate in 2 independent directions. Thus, the…
Q: The infinitesimal work done when expanding a liquid surface is given by SW = ydA. What are the…
A: The infinitesimal work done when expanding a liquid surface is given by the formula: δW = γ dA.This…
Q: Can the thermal resistance concept be used for a solid cylinder or sphere in steady operation?…
A: No, the thermal resistance concept be used for a solid cylinder or sphere in steady operation…
Q: Considering the system where a chicken is being smoked in an electric smoker and the system boundary…
A:
Q: A typical sugar cube has an edge length of 1.0 cm. If you had a cubical box that contained 1.9 mol…
A:
Q: A small electric immersion heater is used to heat 56 g of water for a cup of instant coffee. The…
A: Given, mass of water , m = 56 g = 0.056 kg change in temperature , ΔT = 100°C - 24°C = 76°C = 76 K…
Q: A heat pump is a heating system installed on some newer houses. It works by pumping heat from…
A:
Q: A weather balloon containing 130 moles of an Ideal Gas is released at sea level (atmospheric…
A: a.Here initially, the weather balloon containing 130 moles of an ideal gas at the atmospheric…
Q: A box contains two balls that can be either blue or red. A blue ball has an energy -E0 while a red…
A:
Q: Which of the following statements are IMPOSSIBLE? Choose all that apply. The temperature inside a…
A: Introduction: Thermodynamic properties: These are those properties of system which represent the…
Q: Р (Рa) 800 600 400 A C 200 2 8 10 v (m) 4 6 le of an ideal gas is taken through a closed cycle…
A: Given:
Q: me that Q₁ = -15.0 J and Q2 = -80.0 J in (Figure 1). help with math skills, you may want to review:…
A:
Q: Consider the following figure. (The x axis is marked in increments of 1 m³.) P (Pa) 6 x 10⁰ 4 X 10 2…
A:
Q: =tem with discrete energy level
A:
Q: For the heat pump (used for heating) illustrated below, what is its coefficient of performance for…
A: Indicator diagram between P and V for a cyclic -process.Concept Work done in cyclic process = Area…
Q: - What is the work done on the gas as it expands from ressure P₁ and volume V₁ to pressure P2 and…
A:
Q: 1. Let the plasma be an ideal gas of electrons (a) find the thermal force density Vp for an…
A: Solution:- a). Using Ideal gas-equation,…
Q: An insulated box contains 10 gas molecules. Each molecule has the same probability of being in the…
A: Part-i Given: Number of molecules n = 10.
Q: Q4- Water in piston cylinder system at (TI and XI). The water is heated isothermally until the…
A: The equation for a isothermal process is given by= P1V1= P2V2 And work done by the system in…
Q: The temperature at state A is 20.0°C, that is 293 K. During the last test, you have found the…
A: As per our policy, we are answering only 17 th question. Please repost the other as other question.…
Q: Problem 5 Consider a substance that has a melting temperature of T= 159 K at p=1 atm and a melting…
A: The melting temperature of the substance is given as, Tm=159 K, The melting enthalpy is given as,…
System: N = 3; q = 4.
A)what is the Number of microstates with one heat unit in the second oscillator.
B) what is the Number of microstates with 3 heat units in the first oscillator.
Trending now
This is a popular solution!
Step by step
Solved in 2 steps
