نقطة واحدةThe transfer function of a givensystem is shown below, this:system is100G(s)s²+20s+100An overdamped system.An underdamped system.A critically damped system.Unstable system.

Answered: Image /qna-images/answer/26941ccd-d70c-4404-8b42-07b83cbd7430.jpg

Answered: :sys 100 G(s) s²+20s+100 An overdamped…

Engineering

Electrical Engineering

:sys 100 G(s) s²+20s+100 An overdamped system An underdamped system A critically damped system ||

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: 4) B) The switch in the circuit shown in figure has been elosed for a long time before it is opened…

A: This question belongs to circuit theory . It is based on transient and steady state analysis in…

Q: 10. The sketch (right side) shows a simple RC circuit. The capacitor is initially uncharged, and at…

A: (a) In the given RC circuit, The capacitor will be entirely depleted and the potential value across…

Q: C = 10 μF, L = 8 mH, R = 100 E L www R Since E=e(t) is a given function, find the differential…

A: In a RLC circuit with R=100 Ω, L= 8mH, C=10 μF; the source voltage E=et is function of time. First…

Q: A capacitor of 2 mF has a voltage of 525cos(201). The energy stored in it at t = 850 ms is: O a.…

A: Capacitance C=2 mF. Voltage V=525cos20t V. Time t=850 ms =0.850 sec.

Q: Given that: R1=7494, R2=7.7, Is=3.7, Under steady-state dc conditions, find V i 2 mH ll + Is A R1 Q…

Q: 8. Design a lag compensator to modify the behavior of the plant 1 G,(s) - (s+1)(s +25 +2) Such that…

A: Steps- Find old Steady-state error Write Lag compensator general expression Locate pole and zero on…

Q: It contains a resistor, an inductor, and a capacitor in

Q: 5) In the circuit shown, steady state has been reached before the switch moves at time t = 0. Find…

Q: A series RLC circuit has an inductor that has a value 500 mH, the capacitor 25 µF, and the resistor…

A: An a.c circuit differs from a d.c circuit in many respects. First, in a d.c circuit we consider…

Q: Write a small essay about transient in RL Circuits then : For the circuit shown below, The switch…

Q: Provide an example of a CT system T that is Time-Invariant (TI) but not linear. Justify your answer…

A: Example of a time invariant and non linear system is =

Q: c) IS d) Find the energy (in microjoules) stored in the inductor at 5 ms. e) Find the maximum energy…

A: Energy stored E = 0.5 × inductance L × Current 2. So, find current at 5ms to find energy stored in…

Q: The differential equation of a circuit containing a resistance R, capacitance C, and emf di i de e =…

Q: 4. A series RL circuit has a square wave Vs as input: (a) Draw the graph of voltage VL. Note: the…

A: Inductors does not change current suddenly and behave as open circuit while switching Capacitor does…

Q: e capacitor combination in the figure below is charged to an initial voltage of AV between points a…

Q: The voltage u (t) = 100 cos (314t + 15°) V is applied to a 100-µF capacitor as shown in Figure. Find…

A: Voltage v(t) = 100 cos(314 + 15° ) V Capacitance = 100 μF = 100×10-6 F

Q: Use the mesh-current method to find the steady-state expression for i(t) in the circuit in (Eigure…

A: The given circuit isva=100cos(50000t), V.vb=100sin(50000t+180∘) V.R=60 Ω.We need to determine the…

Q: n the circuit shown, the switch has been in the open position for a long time. It then moves to the…

A: Given Data:A DC transient RLC circuit with,Input supply voltage To Find:The value of the output…

Q: Given the characteristic equation of the denominator below, what is the damped frequency (od) of the…

A: Given, Transfer function, Gs=25s2+3s+25

Q: For the circuit shown in the Figure, assuming that the capacitors are initially uncharged, if C = 5…

A: Resistors, inductors and capacitors form an integral part of any electrical circuit. A source,…

Q: Consider a continuous-time system with input x(t) and output y(t) related by y(t) = x(cos(t)) + 1 a)…

Q: switch is closed. At that instant: find dl/dt, the rate at which the current is changing in the…

Q: Write a small essay about transient in RC Circuits then : For the circuit shown below, The switch…

Q: In the following circuit, the voltage source is supplying Vdc = 59.70 V. The switch S remains close…

Q: Problem #2: In the transient circuit shown below find Ve(t > 0) when switch moves to position 2.…

Q: Question I The input to the circuit shown in Figure 1 is the voltage of the voltage source 0.1 F…

A: In the circuit Find the output voltage across the inductor and steady state output

Q: Write your ID No. Let C 80 µF and L 2mH if the last digit of your ID No. is from 0-4; otherwise, let…

Q: QUESTION 1 A system can be classified as one of the following, to describe its response to non-zero…

A: System classified based on its response to its to non zero initial conditions. Nature of…

Q: Post-Lab 1. The circuit is at steady state before the switch opens. Find the current i(t) that goes…

Q: Consider the circuit shown below where the battery has an emf of = 9.4 V, the resistors have the…

Q: 6. For the RC circuit given below. E 60 V R₁ ww 12 ΚΩ ic June C 6.8 μF vc a) Determine the time…

Q: urrent through capacitor is shown below. At the voltage, power, and stored energy to scale versus…

A: define voltage across capacitor

Q: A capacitor of 2 mF has a voltage of 525cos(201). The energy stored in it at t = 850 ms is: a. 36.22…

A: Given data: C=2 mFV=524 cos20tt=850 ms

Q: 1> 0 In the figure below, the switch will close at t=0. Using step-by-step method, find i, (t) for…

A: In the circuit, 2 independent source are consist. Find the current io (t) in the 2 ohm resistance…

Q: lectric Circuit Analysis 2020/2021 Dr. Yaseen H. Tahir EW.: a) A parallel RLC circuit contains a…

Q: Given is the following circuit: Switch loc (1 R Initially, there is no current in the inductor. The…

A: From the question this is given that initially, there is no current in the inductor. Now, the switch…

Q: The response curve of the system as shown, what will be the natural frequency and damping ratio?…

Q: L V R In the circuit in (Eigure 1), the voltage and current expressions are v = 320e 5t V, t 0t; i =…

A: Resistance = voltage across resistor/ current through resistor. Time constant = inductor/ resistor.…

Q: The circuit below is operating in the sinusoidal steady state. Find the steady-state expression for…

A: Given data, vg(t)=60sin(8000t)VInductor (L)=3.125mHResistance (R)=50Ω

Q: A 350 Hz sinusoidal

Q: 1) Find and select the correct general form of the capacitor voltage (in time domain) for the…

Q: Determine the complete response of the current through the inductor it (t) for the following circuit…

A: The complete response of the current through the inductor needs to be calculated by analysing the…

Q: Q.35: For the circuit shown in figure beside, the switch has been in position "a" for a long time.…

A: In d.c. analysis, under steady state condition a capacitor will behave as OPEN CIRCUIT. The voltage…

Q: 1. (a) Obtain the steady-state response of the following model, and estimate how long it will take…

A: We have given the following problem

Q: Suppose the two capacitors in the example above are connected in series (instead of parallel). What…

Question

نقطة واحدة
The transfer function of a given
system is shown below, this
:system is
100
G(s)
s²+20s+100
An overdamped system.
An underdamped system.
A critically damped system.
Unstable system.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The circuit is at steady-state when the switch closes at time t = 0. Calculate the steady-states currents & voltages ic(0-), ic(0+), vL(0-) and vL (0+). Hint: don't forget about the internal resistance of the inductor. RL = 0.025 10kΩ. 5k2. RL + 40V 25mH 0.01µF: 1kQ
The switch in the picture below has been open for a long time. It is then closed at t=0 s. A) Write the mathematical expression for the current iL and vL after the switch is closed. B) Sketch the waveform of iL and vL from the initial value until the circuit reaches steady state. Indicate on the graph the values of VL and iL for 1T and 5T in each step.
Please answer all subparts is compulsory to answer in typing format solution Please answer in typing format solution please I will like it please all subparts in short
XE0 8H Q.39: The switch in the circuit shown in figure beside has been closed for a long time, then 12A, opened at t=0. Find the numerical expression for the current through the inductor i(t). i(t) 160 00
Why is the following situation impossible? The LC circuit as shown has L = 30.0 μH and C = 50.0 μF. The capacitor has an initial charge of 200 μC. The switch is closed, and the circuit undergoes undamped LC oscillations. At periodic instants, the energies stored by the capacitor and the inductor are equal, with each of the two components storing 250 μJ.
C C a R The switch is placed at position a. The capacitor is being charged. The switch is placed at position b. The capacitor is being discharged. (1) Charging the capacitor: What is the equation for the charge q (t) of the capacitor as it is being charged in the RC circuit? Give your answer in terms of R, C, ɛ, and t? What is the equation for the current I (t) as a function of time when the capacitor being charged? Give your answer in terms of R, C, ɛ, and t? (2) Discharging the capacitor: What is the equation for the charge q (t) of the capacitor as it is being discharged in RC circuit? Give your answer in terms of R, C, ɛ, and t? What is the equation for the current I (t) as a function of time when the capacitor being discharged? Give your answer in terms of R, C, ɛ, and t? (3) What is the equation for the time constant for charging and discharging the capacitor?
Determine the energy in the inductor for the circuit shown under steady-state conditions. Enter your value of energy stored in units of J Show all work
3. Consider a simple RL circuit with R = 4.00 2, L = 8.00 mH, and E = 6.00 V. a) What is the inductive time constant in the circuit equal to? b) Calculate the current in the circuit 250 us after the switch is closed. c) What is the value of the final steady state current? d) After what time interval does the current reach 80% of its maximum value?
Question 2 The switch in Figure 1 has been closed for a long time. It is open at t=0 (the voltage source is disconnected). Let the current i(t) be the output. Derive the differential equation and specify the initial state. 252 www G www.elle 2H i(t) 1F Figure 1 8V
2 At what time is necessary for a current on a series RL dc circuit to reach 83.5 % of the final steady state value if the time constant is 10 millisecond Assume that at t=0, i (0) = 0.?
signal and system
i need solution very very quickly please #circuit analysis#