Suppose that a current source with Is amperes of current is connected in parallel to a pair of impedances Z₁ and Z2. Let I₁ be the current through Z₁ and 12 be the current through Z2. Then, the total voltage Is is divided between 11 and 12 in proportion to impedance values Z₁ and Z2. a. True b. False O

Suppose that a current source with Is amperes of current is connected in parallel to a pair of impedances Z₁ and Z2. Let I₁ be the current through Z₁ and 12 be the current through Z2. Then, the total voltage Is is divided between 11 and 12 in proportion to impedance values Z₁ and Z2. a. True b. False O

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.22P: The real power delivered by a source to two impedances, Z1=4+j5 and Z2=10 connected in parallel, is...

See similar textbooks

Similar questions

Let a series RLC network be connected to a source voltage V, drawing a current I. (a) In terms of the load impedance Z=ZZ, find expressions for P and Q, from complex power considerations. (b) Express p(t) in terms of P and Q, by choosing i(t)=2Icost. (c) For the case of Z=R+jL+1/jC, interpret the result of part (b) in terms of P,QL, and Qc. In particular, if 2LC=1, when the inductive and capacitive reactances cancel, comment on what happens.
Two impedances Z₁ and Z2 are connected in series to a voltage source with voltage Vs volts. Let V₁ be the voltage across Z₁ and V₂ be the voltage across Z2. Then, the total voltage Vs is divided between V₁ and V2 in proportion to impedance values Z₁ and Z2. O a. True O b. False
Driving-point admittance The actual impedance of a load is 30 OHM. The per-unit impedance of the load is 0.5 pu when Base Voltage is 600 V and Base Power is of O 6000 VA O 8000 VA O2000 VA 4000 VA Jump to ncements MacBook Air DD DII F10 F9 F8 000 F7 F6
For an ac circuit consisting of a load connected to a Thévenin circuit, is it possible for the load voltage to exceed the Thévenin voltage in magnitude? If not, why not? If so, under what conditions is it possible? Explain.
An AC voltage of 230 v is applied to a circuit consisting of a resistance of 10 ohms in series with an inductive reactance of 7 ohms. Find the power, reactive power and the power factor of the circuit. If a capacitor is connected in parallel with the RL series circuit of the preceding problem and if this capacitor supplies 1000 var, find the true power and the reactive power supplied by the 230 v source and find the resultant power factor.
AC Circuits Current, Voltage, Power, Power Factor and Phasor Diagrams. Consider the circuit shown in Figure 3. (i) Find the total impedance ZT as seen by the voltage source. (ii) Find the total current IT supplied by the source. (iii) Sketch phasor diagram of Vs and IT and State whether IT leads or lags Vs (iv) Determine the power factor angle for the circuit. 9. L R1 1002 0.213H IT Vs R3 1502 C 12020°V 22µF 60HZ R2 50Ω Figure 3 Answers |(1) Zr = (ii) IT= (iii)
The values of the elements for the given circuit are given below.The maximum average power that can be transferred to the ZL load iswhich one?R1 = 400 OhmsL = 1000j OhmsR2 = 500 Ohms
Figure 2 shows three "LC" circuits, two of them with capacitance capacitors "C" and the three with inductance coils "L", the three circuits are coupled by means of two capacitance capacitors "Cc". The currents that circulate through each mesh are those indicated in the figure: "I1", "I2" and "I3". Using Kirchhoff's law for voltages and taking into account the definition of current I = −dQ / dt, find the system of coupled equations of the system and then find the normal angular frequencies of the system.
Two circuits the impedance of which are given by z₁ = (10 + j15) and z₂ = (6 - j8) are connected in parallel. If the total current supplied is 15A, What is the power taken by each branch?
ZL impedance for maximum average power transfer in the circuit shown in Figure 2and find the value of the maximum average power transferred to the ZL? (Can you write the steps in detail in sentences?)
write a report to compare between ac througe capactance and ac throughe in inductance then:for the cirucit shown beside, find the total impedance between a & b and cirucit current (I)
Q2: Write a lecture for teaching the complex power fed to an (R-L) load fed from an AC power source of sinusoidal voltage and current waveforms, describing its three components, their waveforms, their power triangle, and units.