steps on the orange part please, on how he got the answer, thanks.

Q: write a program using tinkercard, using one dimition called data.this array has patern of 0 and 1 tp…

A: We have to write a program using Tinkercard, using one dimension called data. This array has a…

Q: The plans show curved lines running between switches and various outlets. What does this means

A: The plans show curved line running between switches and various outlets enhances to differentiate…

Q: When a ground wire is connected to an interior gas piping system and the underground portion of the…

A: Given:When a ground wire is connected to an interior gas piping system and the underground portion…

Q: ladder diagram for bottom half of a switched receptacle is to always be hot plus a duplex receptacle…

A: According to the question, we need to design a ladder diagram for the bottom half of a switched…

Q: Can you show the circuit for this or the diagram?

A:

Q: Which of follow statements is NOT true about the breadboard tie-point connections? A Tie points A1…

A: Which of follow statements is NOT true about the breadboard tie-point connections?A) Tie points A1…

Q: What do call to the encircle part of socket and what is the purpose?

A: It is a 3 pin plug. There are three wires in a 3 pin plug named as- 1 – Earth -E 2 – Neutral -N 3 –…

Q: Use nodal analysis to determine each of the circuit parameters for the provided circuit

A: The circuit is shown below:  Using the nodal analysis,  VA=40 VVC=10 VVB-VAR1+VBR3+VB-VCR2=0

Q: A long, inexpensive extension cord is connected from inside the house to a refrigerator outside. The…

A: The resistance of the extension cord depends on, R=ρlA Here, ρ is the resistivity of the cord, lis…

Q: When calculating a dwelling lighting load on the "volt-ampere per ft" basis, the receptacle load…

A: Given: Receptacle loads used are Floor and table lamps. When dwelling loads are calculated what must…

Q: Shown below is a DC circuit that contains a number of switches. The resistance of each switch is…

A: We have to rank as per ammeter reading from highest to lowest.     Let we consider,  R= 1 ohm and…

Q: What is the allowed ampacity of tap conductors that supply a motor lead and do not exceed5 feet in…

A: 5. (i) Except as permitted in 240.21(A) through (H), conductors must be equipped with over-current…

Q: Question 17 The electrode and circuit must provide a flow path to the earth with less than of…

A: In this question We need to choose the correct option.  All question related to the grounding.…

Q: 9. What is the minimum ampacity of the wire that can be used for a 30A branch circuit?      a. 30A…

A:

Q: Directions: Draw the schematic, single line and pictorial diagram of the following problem: A. One…

A: Ans-: Pictorial diagram of a one lamp controlled by 2 three-way and 1 four-way switch . Pictorial…

Q: Three types of electric devices A, B, and C are connected in series across a 115-volt a-c source,…

A: GivenEA=EB=EC=E∠EB=∠EA+90°∠EC=∠EA-90°

Q: B.  Electrical -lighting layout -power layout

A: B. Electricity is available in a form that may be used; nevertheless, it will be necessary to…

Q: A cable has a VSWR of 10. If the minimum voltage along the cable is 20 volts, what is the maximum…

A:

Q: What assumptions can you make regarding the following receptacle wiring? Check all that apply.

A: A split pair is a wiring fault in which two twisted pair wires are linked instead with two wires…

Q: (15) Electrical fires are rated as Class __________ fires. Select one: A. D B. B C. C D. A

A: A fire-class is a system of categorizing fire with regards to the type of material and fuel for…

Q: Exposed structural metal that is interconnected to form a metal building frame that not…

A: As per the new NEC in 250.104(C) all the structural steel whether it contributes to the interior or…

Q: Given an input energy from sunlight of 1000 kWh, solar panels can generate about 170 kWh of…

A: The efficiency of the solar panel is,  ηsolar=PoutPinPout=170 kWhPin=1000…

Q: The LRT trolley system 10 miles ling is fed by two substations that generate 600 volts and 500…

A: Total resistance of the wire = resistance per mile× length of the wire in mile. Voltage drop in line…

Q: Using Manual drawing or CAD. Convert the pictorial cabling to a wiring diagram

A: According to the question, for the given diagram as shown below, We need to draw wiring diagram.

Q: B1 Battery B2 Battery + A НОНІ Switch B WHOI C 3.30 C 3 VOLTS BAX m 10: KIT NO.

A:

Q: supplementary grounding electrode is required when the only grounding electrode available is ? NEC…

A: According to NEC 250.53 (D)(2)  A supplementary grounding electrode is required if metal…

Q: Stair lighting in a three-storey apartment is made with a key switch on each floor. All of the lamps…

A: Given:  Conditions: When any one of  three  storey , the switch is close , lamp glows. when all…

Q: 4) Calculate the value of the resistance Rled in Circuit #1, to ensure that a GREEN LED will have a…

A:

Q: . What is the maximum load to be connected to a single receptacle rated at 20A?

A: The current rating of a single receptacle is,

Q: A hotel with a length of 12m, a width of 9m and a ceiling height of 4m

A: The required number of fixtures, watt of the bulb, and type of bulb used in an electrical system…

Q: 1. Which of the following are the three main components of a simple circuit? A. battery,bulb, fuse…

A: Given: Five electric bulbs are connected in parallel with battery.

Q: What is a closed path made of several branches of the network called? Select the correct response:…

A: Select the correct option : The closed path made of several branches of the network called :…

Q: What dimensions are used when measuring the area of a building? See NEC 220.12.

A: Referring to the NEC 220.12, the floor area is evaluated using the outside of the building…

Q: .A. The insulation color of a grounded wire should be A. white. B. red. C. black.   4.B. A switch…

A: To select proper options from given

Q: YOUR TURN # 19-A: Determine how many 6 RHW-2* conductors can be installed in trade size 3 ½ in.…

A:

Q: using the base of 2 to answer following subtraction:  1000 base 2 -101 base 2 ________________

A: According to the given question, it is required to determine the binary subtraction of the two given…

Q: 19 - What is the code of the underground cable? A) NV (NYA) B) NVV (NYM) C) NYCY (YVMV) D)…

A: This question is from basic nomenclature of electrical devices like "transformers, power-cables,…

Q: diagram R-2R ladder type DAC? ‏

A: R-2R ladder type DAC - In R-2R Digital to Analogue converter is a resistive ladder network provides…

Q: The resistance of a nine inch length of copper that has a diameter of 0.005 in. is ______  (the…

A: Approach to solving the question:Please see attached photos for detailed solutions. Thank you.…

Q: I'm feeling O run up O run across O run into O run run over and could do with a holiday.

A: Given sentence is I am feeling ................and could do with a holiday.

Q: Q) There are method of 1 measuring. * one. two. O three. O four. O Option 3

A: There are two types of measurement methods. 1)direct measurement 2)indirect measurement

Q: What is a matching circuit?

A: Matching circuit : A matching circuit is a circuit which is mainly connected by source and load at…

HVDC

HVDC stands for high voltage direct current in the electric power transmission system. The high voltage direct current system uses direct current (DC) for the transmission of electrical power through transmission lines in contrast with the alternating current that is the AC system. The HVDC is used to transmit bulk power point-to-point through long distances transmission lines. Power is rapidly transferred because the efficiency of transmission lines is greatly increased over long distances due to HVDC lines.