Steam power plant operating on the ideal regencrative Rankine cycle with one open feedwater heater. Steam enters the turbine at 15 MPa and 600°C and is condensed in the condenser at a pressure of 10 kPa. Some steam leaves the turbine at a pressure of 1.2 MPa and enters the open feedwater heater. Determine the fraction of stam extracted from the turbine and the thermal efficien., the cycle. Ees

Steam power plant operating on the ideal regencrative Rankine cycle with one open feedwater heater. Steam enters the turbine at 15 MPa and 600°C and is condensed in the condenser at a pressure of 10 kPa. Some steam leaves the turbine at a pressure of 1.2 MPa and enters the open feedwater heater. Determine the fraction of stam extracted from the turbine and the thermal efficien., the cycle. Ees

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

The net work output and the thermal efficiency for the Carnot and the simple ideal Rankinecycles with steam as the working fluid are to be calculated and compared. Steam enters theturbine in both cases at 10 MPa as a saturated vapor, and the condenser pressure is 20 kPa.In the Rankine cycle, the condenser exit state is saturated liquid and in the Carnot cycle, theboiler inlet state is saturated liquid. Draw the T-s diagrams for both cycles.
A dry and saturated steam supplied in a power plant is at 1500 kPa. Determine theefficiencies of Carnot and Rankine cycle if the pressure at the condenser is at 40 kPa,neglecting pump work.
An Ideal Reheat Cycle , steam enters the high pressure turbine at 750 psia and 800F and leaves at 100 psia. It is then reheated to 800F, passes through the low pressure turbine and exhausts to a condenser at 1 psia. Find the thermal efficiency of the cycle in %. From Steam Table h1 =1401.5 Btu/lb h2 =1189.96 Btu/lb h3 =1429.8 Btu/lb h4 = 1031.13 Btu/lb h5 = 69.72 Btu/lb h6 = 72.09 Btu/lb (include the diagram)
A 8000 kW gas-turbine power plant operates with single stage compression, two-stageexpansion and with a reheating process. The high pressure turbine drives the compressor andthe low pressure turbine produces the net work output. Atmospheric air enters the compressorat 27 oC and the combustion gasses enter the high pressure turbine at 927oC. The combustiongasses leaving the high pressure turbine is reheated back to 827 oC before expanding in the lowpressure turbine. The overall pressure ratio is 9. The isentropic efficiency of each turbine is85% and the isentropic efficiency of the compressor is 90%. Sketch the schematic diagram andthe temperature-entropy (T-s) diagram of the cycle. Determinei. the heat supplied to the system, kJ/kgii. the net work, kJ/kgiii. the thermal efficiency, %iv. the work ratiov. the mass flow rate of the gasses, kg/s.For air take cpa = 1.005 kJ/kgK and a = 1.4 and for the gasses takecpg = 1.15 kJ/kgK and g = 1.33
Consider a steam plant operating on the ideal Rankine cycle. Steam enters the turbine at 3 MPa and 350°C and is condensed in the condenser at a pressure of 10 kPa. Determine The thermal efficiency if steam is superheated to 600°C instead of 350°C in %. Include your T - S diagram on your solution SI unit plsss thankyou
TNB steam power plant in Genting Highlandsoperates on reheat Rankine cycleand has power net output of 50MW. Steam enters the turbine at aMPa and b °Cand it is cooled in the condenser at a pressure of ckPa by running cooling water from the Bertam River through the tubesof condenser. Steam enters both stages of the turbine at b°C. If the moisture content of the steam at the exit of the low-pressure turbine is not to exceed 10 percent, show the cycle on a T-s diagram and determine;i.The pressure at which reheating takes place, ii.The thermal efficiency of the cycleandiii.Please justify how does the thermal efficiency of the cycle if the temperature to low turbine is increase to 600°C? a=12 b=500 c=12
rankine cycle, the pressure and temperature entering the turbine is 1800 kpa and 380 degrees celsius and the pressure leaving the turbine is 20 kpa, the quality of steam entering the condenser is 90%. what is the turbine work in kj/kg at 1.8 mpa and 380 degrees celsius
A flashed steam geothermal power plant is located where underground hot water is available as a saturated liquid at 700 kPa. The well head pressure is 600 kPa. The flashed steam enters the steam turbine at 500 kPa and expands to 15 kPa when it is condensed. The flow rate from the well is 29.6 kg/s. Determine the cycle thermal efficiency of the plant in %.
In an ideal Rankine cycle, steam is generated at 4.1 MPa and 480°C. The condenser is at 32°C. For an engine with the same end states, determine its thermal efficiency in %.
A power plant is to be operated on a Rankine Cycle with superheated steam exiting the boiler at 4 MPa and 500°C. The condenser pressure is 20 kPa. Compute the thermal efficiency of the cycle in %.
In a reheat cycle steam at 15 MPa, 540 ̊C enters the engine and expands to 1.95 MPa.At this point the steam is withdrawn and passed through a reheater. It reenters the engineat 540 ̊C. Expansion now occurs to the condenser pressure of 0.0035 MPa (a) For theideal cycle, find e. (b) A 60,000 kw turbine operates between the same state piontsexcept that the steam enters the reheater at 1.95 MPa and 260 ̊C, departs at 1.8 MPa and540 ̊C. the steam flow is 147,000 kg/hr, generator efficiency is 96%. For actual enginefind ek, mk, and nk.
A power plant operating in a Reheat Rankine Cycle produces steam at 3 MPa, 600oC in the boiler. It keeps the condenser at 45oC by transfer of 10 MW out as heat transfer. The first turbine section (high-pressure) expands to 500 kPa and then flow is reheated followed by the expansion in the low-pressure turbine. Provide a detailed solution. Avoid shortcuts. Determine the values of enthalpy for each state.