Steam enters an adiabatic turbine at 6 MPa and 550 °C and leaves at 10 kPa and 50 °C. If the environment temperature and pressure is 0 °C and 103.325, what is the second law efficiency of the turbine? O a. 0.70 O b. 0.75 O c. 0.81 O d. 0.72 O e. 0.78

Steam enters an adiabatic turbine at 6 MPa and 550 °C and leaves at 10 kPa and 50 °C. If the environment temperature and pressure is 0 °C and 103.325, what is the second law efficiency of the turbine? O a. 0.70 O b. 0.75 O c. 0.81 O d. 0.72 O e. 0.78

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: is the RMS value of output voltage of the step down chopper which is having 240 V as a input for a…

Q: A single-phase AC voltage controller has a resistive load R = 10 Ohm, and %3D the RMS input voltage…

Q: What are the losses taking place in an alternator?

A: The Power losses occur in the alternator due to a number of different mechanisms. These can be…

Q: A 4-pole DC generator has 1,000 turns on its rotor. It is being turned by a prime mover at 4,000 RPM…

Q: An alternator is generating an emf per phase of EO while the rotor is rotating at a speed of 3000…

A: We know that Ephase=4.44Kpkdfrequency*flux*turn frequency=speed*no of pole /120

Q: induction motor is rated 5 HP, 75% power factor and 220 V. What approximate size of capacitor (VAR)…

A: We need to find out VAR size for increased power factor

Q: A 600 V load connected to a DC series generator has the following resistance given: Ra-045 2 and Re…

Q: An induction machine is supplied with phase input voltage of 22020 and input current 164-10. The per…

A: There are two types of machines depending upon the type of input. 1) AC machine- Induction…

Q: The rotor winding of the induction motor at no load condition is equivalent to O connected to an…

A: Rotor Winding of the Induction Motor at No load Condition is Equivalent

Q: 1. A 30 4 pole alternator runs at 1,800 rpm. Each phase covers 2 slots under each pole. The full-…

A: Given data: 3 phase alternator Pole P=4 Speed N= 1800 rpm Phase covers 2 slots under each pole…

Q: The DC shunt generator with the terminal voltage 350 V, armature drop 9 V and the each brush drop 4…

A: We need to tell about generated voltage for generator.

Q: 78 The induced emf of a dc machine running at 750 rpm is 220 V. The percentage increase in field…

A: we need to determine percentage increase in the field flux.

Q: A slow speed alternator works in parallel with a turbo-alternator, the combined output being 2500 kW…

A: We got two alernators one is slow speed alternator and another is turbo-alternator they both work in…

Q: Identify the effect of the power coefficient for a wind turbine if the power extracted by rotor…

Q: A load consisting of induction motors is drawing 40 kW average real power from a 110-V (RMS), 6 Hz…

Q: The generated voltage per phase of an alternator is E0 while the speed of rotor rotation is 3000…

A: We will establish the relation between the generated voltage and the speed of the alternator.

Q: In generator, the generated e.m.f will increase with the load. separately excited dc generator self…

A: In this question we need to choose a correct option.

Q: A dc separate excited genera speed = 1500 R.P.M at a certa gives a voltage = 180 Volt. Its speed 110…

A: In this question we will find voltage of separately excited generator at given excitation and…

Q: Gear box in the wind turbines rotate typically between 400 rpm and 40 rpm. Generators typically…

A: Yes it is TRUE

Q: In steam power station: What are the benefits of superheater? What are the Qi advantages of water…

Q: What are the losses types of 3-phase induction motor?

Q: A 6 pole DC wave wound generator has 28 armature conductors with flux per pole is 23 mWb and the…

A: First option is correct. The explanation is provided below.

Q: The type generator field winding is supplied from the external D.C. source. O Shunt O Self excited o…

A: Seld excited generator does not require addtional power DC supply.

Q: The generated voltage per phase of an alternator is EO while the speed of rotor rotation is 3000…

A: We will establish a relation between generated emf and the speed with which the rotor is rotating to…

Q: An alternator is generating an emf per phase of EO while the rotor is rotating at a speed of 3000…

A: The generated EMF phase is given by Ephase=4.44Kpkdfrequency*flux*turn Here frequency is…

Q: If two 3-phase induction machines are mechanically coupled with each other. The two machines are…

A: The induction motors are coupled here mechanically. The speed will same for both machines because of…

Q: Alternator A (100 kVA, 3-f, 240 V, 60 Hz, 1800 rpm) is operating in parallel with alternator B (125…

A: In this question We need to determine the pf of load. If Alternator A (100 kVA, 3-f, 240 V, 60 Hz,…

Q: A three-phase synchronous generator is rotating at 1500 RPM synchronous speed. The output power of…

A: In this question we will find induced torque in generator...

Q: The speed of an alternator rotor in rpm that has 4 poles and is producing a voltage at 45.4 Hertz…

Q: v. With reference to an 50 Hz3 phase alternator explain how P,Q,V and F are controlled.

A: It is asked to explain the control of P (active power),Q (reactive power), V (voltage) and F…

Q: Prove that in a DC generator the maximum efficiency is obtained when constant loss is equal to the…

A: Solution: The efficiency of a D.C generator is given by the formula,…

Q: A synchronous generator generates 350 V at 55 Hz when the field current is 3.7A. The e.m.f generated…

A: The solution is given in next step.

Q: A synchronous generator generates 370 V at 55 Hz when the field current is 4.4A. The e.m.f generated…

A: Generated emf of the synchronous generator is proportional to is frequency and current.

Q: A short shunt compound generator supplies a load of 20 kW at 500 V. The armature, series and shunt…

A: Load current = power delivered to load/ terminal voltage voltage. Power developed = armature…

Q: If a 19 m/s wind is blowing on a wind turbine and the tips of its blades are rotating at 62 m/s,…

A: Need to find tip speed ratio

Q: ideal Diesel cycle

Q: At a speed of 1500 rev/min, a separately excited dc generator has the following O.C.C e.m.f (V)…

A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: Your company is to supply a 50 Hz alternator to a European company. The stator is wye connected with…

A: Given:- f=50 Hzϕ=0.173 weberT=28 turns

Q: If a 16 m/s wind is blowing on a wind turbine and the tips of its blades are rotating at 60 m/s.…

A: tip speed ratio = speed of blade/ wind speed speed of blade = 60m/s wind speed = 16 m/s

Concept explainers

DC Generator

An electromechanical machine which converts input mechanical energy to respective output electric energy is called a generator.

Question

Steam enters an adiabatic turbine at 6 MPa and 550 °C and
leaves at 10 kPa and 50 °C. If the environment temperature and
pressure is 0 °C and 103.325, what is the second law efficiency of
the turbine?
O a. 0.70
O b. 0.75
O c. 0.81
O d. 0.72
O e. 0.78

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Explain how the real and reactive power is controlled in synchronous generators.
q9
A commutator is the main part of the rotor to spread the flux in the air gap Select one: O True O False
A 6 pole DC wave wound generator has 26 armature conductors with flux per pole is 21 mWb and the e.m.f generated is 63 V, then the speed of the machine is O 6.55 rps O 0.66 rps O 38.46 rps O 115.38 rps The Auto transformers are used to provide a variable voltage output Select one: O True O MEEZ11ON-Electrical O False
Electrical Machines A 4-pole single-phase induction motor is rotating in a clockwise direction at a speed of 1000 rpm having a voltage of 100 V with a frequency of 50 Hz. At a standstill, if the rotor resistance is 1.70, then in the backward branch what will be the effective resistance?
A synchronous generator is generating 300 V at 55 Hz at a field current of 3.4A. The e.m.f generated when the frequency is 40Hz and the field current is 2.2A is .........
A synchronous generator generates 365 V at 60 Hz when the field current is 3.9A. The e.m.f generated when the frequency is 40Hz and the field current is 2.1A is ...............
An ac controller has a resistive load of R = 10 2 and the input is 220 V, 50 Hz. The thyristors switch is on for n 25 cycles and for m 75 cycles. Determine: (i) (ii) (iii) the rms value of the output voltage, the input power factor, the average and rms current through thyristors.
The meter constant of a single phase 230 V, induction energy meter is 800 rev/ kWh. What will be the speed of rotation of meter disc in rpm for a current of 20 A at 0.7 pf lagging?
The RMS value of current, if the value of armature current is 14 A, a = 51 degrees, and B = 160 degrees is Ia a+T B+T a O 10.89 O 2.91 O 5.16 O 82.46
Solve it quickly please
If the speed of an Induction machine is 100 rad/sec, the speed in rpm is