Steam enters a turbine steadily at 3 MPa and 450°C at a rate of 8 kg/s and exits at 0.2 MPa and 150°C. The steam is losing heat to the surrounding air at 100 kPa and 25°C at a rate of 300 kW, and the kinetic and potential energy changes are negligible. Determine the second-law efficiency.

Q: A compressor draws in 0.5 kgm/s of air with 7 m/s speed, 100 kPa pressure, and 0.95 m2/kgm. The air…

A:

Q: Steam at 1MPa and 554.8726 °C enters an insulated turbine and exits as saturated vapor at 20 kPa.…

A:

Q: L Steam flows steadily into a turbine with a mass flow rate of 20 kg/s at 6 MPa and 600°C with a…

A:

Q: Steam enters a turbine steadily at a flow rate of 1 kg/s at 7 MPa and 500 degrees and exits as…

A: Inlet conditions:Mass flow rate (ṁ) = 1 kg/sInlet pressure (P1) = 7 MPaInlet temperature (T1) =…

Q: A hot-water pipe at 80°C is losing heat to the surrounding air at 5°C at a rate of 1600 W. Determine…

A: Given: The temperature of the hot-water pipe is T1=80 °C The temperature of the surrounding air is…

Q: Steam enters an adiabatic turbine at 8 MPa and 500°C at a rate of 3.1 kg/s and leaves at 10 kPa. If…

A: P1 = 8 MPaT1 = 500°C P2 = 10 kPa m = 3.1 kg/sW = 2.5 MW = 2.5 x 103 kWT2 =?

Q: Air is compressed steadily in a compressor from 100 kPa and 400 K to 1 MPa and 500 K, at a rate of…

A:

Q: Superheated steam enters the turbine of a steam power plant at 5 MPa and 450 ºC, and exits at 10…

A: Given:P1=5 MPaT1=450°CP2=10 KPaη=90%m=10 Kg/s

Q: An insulated piston-cylinder device contains 0.02 m³ of steam at 300 kPa and 200°C. Steam is now…

A: The initial volume of the steam, (V1)=0.02 m3The initial pressure of the steam, (P1)=300 kPaThe…

Q: Water initially at 25 C and having a mass of 120 kg is to be heated to 85°C in a boiler using biogas…

A: Specific heat of water is 4.2 KJ/KgC.

Q: A turbine is operating steadily and connected to a generator to convert mechanical work to…

A: Solution: Inlet conditions Inlet Pressure P1=4.5MPa Inlet temperature T1=400°C From superheated…

Q: Steam expands in a turbine steadily at a rate of 11.11 kg/s, entering at 8 MPa and 500°C and leaving…

A: The mass frow rate of the turbine, The inlet pressure to the turbine, (P1)=8 MPaThe inlet…

Q: enters an expander with an enthalpy of 1200 kj/kg and leaves with an enthalpy of 899 kJ/kg. 20 kJ/kg…

A:

Q: 3. Steam enters an adiabatic turbine steadily at 8Mpa and 500C at a rate of Skg/s and leaves at…

A:

Q: Steam enters an adiabatic nozzle at 3.5 MPa and 300°C with a low velocity and leaves at 1.6 MPa and…

A: Answer : Second law efficiency is the ratio of exergy destruction to the exergy at initial state and…

Q: Steam flows through a turbine at a rate of 2.0 kg/s, at 3 MPa and 450°C with a velocity of 80 mis…

A: given; mass flow rate (m)=2kg/sinlet pressure(P1)=3MPainlet temperature(T1)=4500cinitial…

Q: A 100-lbm block of a solid material whose specific heat is 0.5 Btu/lbm·R is at 80F. It is heated…

A: Given data: *The mass of the block is mb=100 lbm. *The specific heat capacity of block is cb=0.5…

Q: A piston-cylinder device contains 0.13 kg of air initially at 2 MPa and 350°C. The air is first…

A: Introduction In this problem, we will calculate the work done by the piston cylinder device or work…

Q: Steam enters a nozzle at 400°C and 800 kPa with a velocity of 10 m/s, and leaves at 3008C and 200…

A:

Q: d 80 m/s and leaves at 50 kPa, 1008C, and 14 e power output of the turbine is 5 MW, deter

A: GivenAt EntranceP1=6 MPa , T1=600°C, v1=80 m/sP2=50 kPa, T2=100°C, v2=140 m/sWout=5 MW Ts=25°C

Q: Refrigerant-134a enters a compressor as a saturated vapor at 160 kPa at a rate of 0.03 m3 /s and…

A: Given: The initial pressure P1=160 kPa. The final pressure is P2=0.03 m3/s. The entropy increase is…

Q: Air is compressed by an adiabatic compressor from 95 kPa and 27°C to 600 kPa and 277°C. Assuming…

A:

Q: An air compressor compresses 15 L/s of air at 120 kPa and 20 degree C to 800 kPa and 300 degree C…

A: given : V˙ = 15 L/s = 15*10-3 m³/s  (∵ 1 Litre = 10-3 m³ , ∴ V˙ = 15*10-3 m³/s)   state 1 : P₁ =…

Q: Steam enters a turbine at 6 MPa and 450°C at a rate of 33 kg/s and exits at 50 kPa as saturated…

A:

Q: perheated steam at 0.5 MPa and 400 °C enters an adiabatic nozzle na low velocity and leaves at 0.1…

A:

Q: Air enters the compressor of a gas turbine plant at ambient conditions of 100 kPa and 25 ⁰C with a…

A:

Q: Steam expands in a turbine from 6 MPa and 500?C to 0.15 MPa and 160?C at a rate of 1.2 kg/s. Heat is…

A: From the superheated steam table, the specific enthalpy of steam at 6 MPa pressure and 5000C…

Q: Steam expands in a turbine steadily at a rate of 18,000 kg/h, entering at 7 MPa and 600°C and…

A: The values of enthalpy and entropy are taken from the steam table                h1=3650.6…