Solve the following integrodifferential equation t + 5x + 3 fx dt + 4 = sin 4t 0 dx dt x(0) = 1. 2 x(t) is calculated as [ e-1.5t. + sin( cos( t)]u(t). p=t+| A) + (

Q: Which of the following explanation is NOT TRUE? a. Recorder will be the most appropriate choice if…

A: 1)Recoder is used when an reading or observation is to be noted from an instrumet for high speed or…

Q: Explain the successive approximation

A:

Q: The ARDUINO IDE stands for. O a. Integrated development environment O b. None of these O c.…

A: The correct option for 57 is option a

Q: Differentiate between MCB and kit kat fuse

A: MCB : MCB stands for miniature circuit breaker it is a electrical device in such way that it…

Q: CRO  __________________ generates the saw tooth sweep voltage.   Y plates control grid…

A: In CRO  Y plates generates the saw tooth sweep voltage

Q: Draw a simple pulse detector (positive-edge) diagram and explain how it works.

A: The edge detector circuit generates a positive spike at at the positive going or negative going edge…

Q: 142-0701-801 RF / Coaxial Connector, SMA Coaxial, Straight Jack, Solder, 50 ohm, Beryllium Copper

A:

Q: mounting and positioning of switch board khn h?

A: Electricity is safely distributed throughout commercial and industrial buildings using switchboards.…

Q: Cần be driven by a single digital 1C output is a characteristic called a) low power dissipation. c)…

A: 2. The number of parallel loads that can be driven by the single digital IC output is a…

Q: Name the type of wiring for the 3 wires proximity sensor shown below. BN Select one: O a. NPN…

A:

Q: Describe ring counters in detail and how they are used.

A:

Q: What can you say/perspective about National Electrical Code?

A: The National Electrical Code (NEC) was created to protect people and property from the risks posed…

Q: The output  voltage of the given electronic controller will be a _____________________ signal

A: This given circuit is combination of 2 controller -: 1st is the derivative controller and 2nd part…

Q: How are the input and output parameter options for a function block set? Multiple Choice O O Pin is…

A: How are the input and output parameter options for a block set?

Q: 21. Which voltage range that is sometimes called a “float" in TTL circuits?

A:

Q: Crystal radio receiver Please explain how this circuit works

A: NOTE- According to the policy, we can answer only one question, please post other question as…

Q: of the following statements is true for an SCR. It is an on-only controllable switch, which is…

A: There are three types of switches: Uncontrolled switches : In these turn on and turn off can not be…

Q: Computer Digital Logic. Design 4 X 1 Multiplexer.

A: The 4 X 1 Multiplexer has 4 inputs and 1 output. The block diagram of the 4 X 1 Multiplexer is shown…

Q: Level to voltage transducer based on Buoy and Chain

A: Since you have asked multiple question ,we will slove the first question for you .If you want any…

Q: Q) In measurement system, which of 1 point the following static characteristics are desirable? *…

A: Accuracy is the degree of closeness of the measurement and sensitivity is the how output is reacts…

Q: Explain the different type of routin test In CB ??

A: There are different kinds of routine tests done for the Circuit Breaker.   Power frequency…

Q: For what purpose we use the Ohm's 2 option in IT intellitone 200 probe transmitter?

A: Purpose of Ohm's symbol in IT intellitone 200 probe transmitter :- The ohm's symbol is used in IT…

Q: The best sentence to describe dead band/time of the sensor is _____________________________. a. the…

A: Theere are certain  characteristic which defines how good theinstrument is these characteristic are…

Q: How does Signaling System Number 7 (SS7) work? Explain fully.

A: Signaling System Number 7 (SS7) : The Signaling System 7 (SS7) is indeed an international…

Q: is it possible you can work in multi-sim?

A: Given, We need to implement it in multisim.

Q: What is the difference between blocking assignments and non- blocking assignments ? What is the…

A: Verilog is a hardware description language. The memory and array declaration in Verilog is static.…

Q: Identify and Explain with neat sketch of the 1. Pin Type Insulator 2. Suspension Type 3. Strain…

A: Pin type insulator: This type of the insulators the most early grown overhead insulator, yet are…

Q: K1= K2= Note: Round off your final answer to the nearest ten thousandth.…

A:

Q: hoose the correct answer Which one of these is a DAC?   a. R-2R Ladder type b. Counter Ramp type c.…

A: DAC  is digital to analog convertor  R-2R is a DAC counter type, Flash type, Successive…

Q: B- What is the noise in communication sytems. Clasify the types of noise and how can elimiteate the…

A: we need to discuss what is the noise in communication system and  types of noise and how can we…

Q: Why switching circuits are called as finite state systems

A: In this question we will write about why switching circuits are called as finite state systems.....

Q: Define Digital

A: In the context of electrical engineering, Digital is a type of signal which is active at only…

Q: Draw the block diagram and describe the principle of operation of the UPS type inline-interactive

A: When power is lost, a line-interactive UPS keeps the inverter in line and changes the battery's DC…

Q: Match the appropriate number with the given statements. 4 DIGITAL (PWM-) OO UNO TX ON ARDUINO RX…

A: Given,

Q: Which switching technology will work best for high power, high voltage (greater than 6kV), high…

A: Switching frequency: Switches are used to turn ON and turn OFF the device. the switch can connect or…

Q: I have four ESP-WROOM-32D boards, and four NRF24L01 modules. Each ESP-WROOM-32D board is connected…

A: You can use the RF24 library for NRF24L01 modules and the ArduinoJson library for handling JSON…

Q: Explain how to determine the output voltage of the step-down configuration of a switching regulator.…

A: