Solve the Discrete-Time Fourier transform solution just enlun the nenhlem.) b) x[n]-un-11

Q: Problem 5. Based on the pole/zero placement, Is the following filter a LPF, HPF, BPF, or Notch…

A: it is asked to find the type of filter based on given Z-transform

Q: Q-2) A non-uniform surface current density flows as: = {ªlor'sin (r) over S': (a≤r'≤ 2a, 0 ≤ 4' <…

A: According to the question, for the given geometry as shown below A non-uniform surface current…

Q: Problem 4.4: A 200-hp, three-phase, 60-Hz, six-pole, 1150-rpm, 0.90-pf induction motor operates with…

A: It is given that: Actual speed =11502=575 rpm Rated speed =1150 rpm cos θ =0.9 VLL line =480 V

Q: In the network shown in Fig.2 the voltage source is given by vs = 24 cos(100t)V and the work shown…

A: here vs=24cos100tV,is=12cos(200t)A

Q: 3. Given diagram below, implement an equivalent circuit using ONLY NA and NOR gates. Conditions: All…

A:

Q: 2. For the network of Figure 2 with the measurement Vs = 1.7 V, determine: a. Ip b. VGS c. lpss d.…

A:

Q: Given the following image, which BCD codes which output will be high for the following input…

A: For the given circuit, the list of output which will be high for the given input values.

Q: 2K LIK Fig. 4 Io = 2 mA R -lo v

A:

Q: A shunt motor is rotating at 1500 rpm and is powered by a 120V voltage source. The current line…

A: In this question we need to find the following a) the armature current, b) the back emf (E), c) the…

Q: The output y(k) of a discrete-time system is given by y(k)= u(k+2)-u(k-2) where k is an integer…

A: Given Data: An output of a system is, yk=uk+2. uk-2 Where, uk=Discrete Unit Step Sequence To…

Q: A three phase, 60 Hz, 6-poles induction motor has a full-load speed of at 1150 rpm and delivers…

A: Given data f=60 Hz P=6 NFL=1150 rmp Nreduced=960 rpm To find out We have to determine the ratio of…

Q: a) This question is about discrete-time convolution. Use the Table Method to solve this question.…

A:

Q: Find the equivalent resistance Rab R1=5 ohm R2=9 ohm R3=15 ohm

A: It is given that: R1=5 ohm,R2=9 ohm,R3=15 ohm.

Q: 3. Consider the LED driver circuit to the right. Vcc=5V.Vin = SV, B= 200, and V, for the LED is 2 V…

A: Given Circuit: Given Data: β=200 VCC=5V Vin=5V Vf=2V for If=20mA   To determine: Value of R1 to…

Q: (5) In this circuit: y(t) = 4 sin (500t +45°) ig(t) = 1 Cos (500t +45°) Use the phasor method and…

A: In this question we need to find vo(t) and v1(t) using superposition principal for the given circuit…

Q: Write a brief report on the electrical power subject that was studied in the second Explaining the…

A: Dear student, Since you have posted multiple questions, we will provide the solution only to the…

Q: laplace transform a) h(t)= 2t² sin (3t)

A: The Laplace transform of the signal is given by, Fs=∫-∞∞fte-st dt Properties of Laplace transform,…

Q: A 50-kW, 440-V, 50-Hz, six-pole induction motor has a slip of 6 percent when operating at full-load…

A:

Q: 2/Design an FIR Linear Phase. For Band - Stop Filter having the ideal response Hd (w)=√ O IWICZ &…

A: Given: Frequency response of an FIR linear phase band stop filter,  Hdω=1;ω≤π60;π6&lt;ω≤π31;π3≤ω≤π,…

Q: ten-turn solenoid has a ferromagnetic core with a relative permeability of 10,000. The length of the…

A:

Q: x[n] Z -1 -1→ Z-1 Z-1 Z-1 y[n]

A:

Q: CONTROL SYSTEM ( NEED ONLY HANDWRITTEN SOLUTION PLEASE OTHERWISE DOWNVOTE)

A:

Q: U(S) U(S). + + 75 k SS+4) K S²+(4+7k)s » modified as y(s) y(s)

A: Given Data: A Negative feedback system with, Open loop system Gs=Kss+4 The feedback elements of,…

Q: Question 3 Calculate Vx in the circuit of Fig. 3 using the method of source transformation. 5Ω 4Ω -…

A: A voltage source in series with the resistance or reactance can be transferred into the current in…

Q: x(t) = sinc(200t)cos (2000) z(t) c(t) = cos(π10000t) High Pass Filter H(f) 1 -5000 0 1 5000 -f y(t)

A: Given: A system,  To find: ii) Plot the Fourier transform of the intermediate signal z(t).  iii)…

Q: 3. The circuit below has an AC power supply with 20 V max voltage and a frequency of 50 Hz.…

A:

Q: For L1=13 H, L2=10 H, L3=10 H, L4-30 H, L5=75 H, L6=30 H, L7=24 H & L8-59 H in the circuit shown…

A: Given: A network,  with, , and considering no energy stored in the inductors. To find: Equivalent…

Q: A A ㅁ INJ

A: A simple digital circuit diagram given we need to simplify the output Q in terms of A and B

Q: A) Determine the transfer function of HS = V out(S) / Vin (S) B) Specify the filter type and…

A: We need to calculate - a) transfer function H(s)=Vout(s)/Vin(s) b) the type of filter and cut off…

Q: What is the output of e 1 e-4tu(t) -e-3t 2 e -3t -4t u(t) * e²³t u(t)? -e-³tu(t) -3tu(t) - e-4t₁ 1+…

A:

Q: 23/ For the JFET transistor shown in figure (1), find the following :- VGsa, IDQ, VDS, VG, VD and…

A:

Q: A dc-dc converter is built so that Vout(t) = q1Vin(t). The switch operates at 50 kHz with duty ratio…

A: The Fourier series of the signal at the filter output, we need to determine the transfer function of…

Q: Each lamp has a resistance of 10.0 k Ω. Determine the following: (a) total voltage, (b) total…

A:

Q: U(s) G3(S) G₁(s) H₂(s) G₂(S) H₁(s) Y(s)

A:

Q: In a certain delta-connected balanced load, with line voltages of 230 V and impedances of 60 35°…

A:

Q: What is the inverse z-transform of X(z) = (2-1)/(z^2-2z+1)? (n+1)(1^n)u[n+1] n(1^n)u[n] (-1)^n u[n]…

A:

Q: Find to in the circuit in (Figure 1), given that is = 0.550 mA. Assume the op amp is ideal. Express…

A: We need to calculate the output current.

Q: What is the value of node voltage 1? 4Ω ΖΩ 10 V 2 Hi 5A ΣΩ 3 8 Ω

A:

Q: Problem 17 Select a stabilizing, first-order controller to place a dominant closed-loop pole at z =…

A: Select a stabilizing, first-order controller to place a dominant closed-loop pole at z=0.8 for,…

Q: A ten-turn solenoid has a ferromagnetic core with a relative permeability of 10,000. The length of…

A:

Q: In the circuit of the following figure, the input voltage Vs is 15 volts rms with a frequency of 60…

A: Input voltage Vs=15 V  (rms) Frequency f=60 Hz Resistance R=150 ohms Capacitance C=100,000 pF Vd=0.2…

Q: A) An energy meter whose constant is 1500 reVolutions per KWh makes, 20 reVolutions in 30 seconds.…

A: In this question we need to find the following A) Calculate the load inKW. B) meter constant and  If…

Q: Determine the transfer function for the system shown in Figure Q3. R(s) G₁ + H₁ H3 G₂ Figure Q3 G3…

A:

Q: 30 V + Μ ΖΩ For the circuit shown above, if the 30 V voltage source delivers 150 W resistor R is (a)…

A: The circuit is, Power delivered by the source is, P=150W

Q: Problem 5. Based on the pole/zero placement, Is the following filter a LPF, HPF, BPF, or Notch…

A:

Q: 5. What is the maximum power that can be transferred to the load Resistor, R..! R₂ www lokn www 12V…

A: given an electrical circuit is

Q: WΞΩΤ Problem 2. If the signal, x(n), shown below is band limited to @Max=π/10 rad, what is the…

A: Given w_max = π/10 rad X(w) bounded to [-π  to π] Decimation factor = M

Q: In a 3-phase, 4-wire system, the currents in R. Yand B lines under abnormal conditions of trading…

A: In this question we need to find the positive, negative and zero sequence currents in the R-line and…

Q: Given a PNP transistor in the figure below, determine Vc and IB -22 V

A: In the given questions we need to do the DC analysis of the given circuit and need to calculate…

Q: Consider the cascaded Op Amp circuit shown below. is ✓ uni 4 кл ли 10 кл M Voi un2 12 кл w -M Į t…

A: