Solute: H2SO4 Composition of Solution: mole% H2SO4 = 40 % Density, g/mL: 20 degrees: 1.681 ; 80 degrees: 1.625 Find:  1. g solute per 100 mL of solution at 80 degrees 2. g solute per 1000 mL of solution at 20 degrees 3. ppm of solute

Q: Draw the repeat unit of the polymer produced by cationic polymerization of 1,3-dioxolane using HBF4,…

A: It is asked to draw the repeating unit of the polymerization of Tetrahydro furan.

Q: What is the half-life of a first order process with a rate constant of 4.50 x 10°³ s²¹? (A) Cannot…

A:

Q: NH₂ OMe (i) PhCHO, cat. H+ (ii) BF3.OEt₂ SiMe3 Ph HN OMe

A: Steps of the organic transformation are given below:

Q: solution was prepared by dissolving 34.7 g of KOH in 88.0 g of ethanol (C₂H5OH). A What is the…

A:

Q: suppose a current of 0.510 A flows through a copper wire for 281. seconds, calculate how many moles…

A:

Q: how can a laptop considered as organic or inorganic compound?

A: ORGANIC AND INORGANIC COMPOUNDS

Q: 27. A 286 mL sample of gas is initially at a pressure of 901 torr and a temperature of 32 °C. If…

A:

Q: Consider the reaction. Fe(s) + 2HCl(aq) FeCl₂(s) + H₂(g) Based upon the stoichiometry of the…

A: Fe(s) +2HCl(aq) -----> FeCl2(s) + H2(g)  -> Gas has greater entropy than liquid and liquid has…

Q: b. Winnie the Pooh wants to fill 5 pots of honey each day. Each pot holds 2.0 liters of honey. Pooh…

A: Answer: This question is based on unit conversion where 500cm3 needs to be converted in Liter in…

Q: Which of the choices is a simple lipid? lecithin tripalmitin O sodium lauryl sulfate androsterone O…

A:

Q: a) Draw the structure and the systematic name of the following d-metal complexes: (0) [Mn(CO),H₂]…

A: As per the rules only the first three subparts of the first question can be answered

Q: Question 25 Ciprofloxacin is an antimicrobial used in the treatment of a wide variety of bacterial…

A: c). There would be no replication of E.coli DNA Ciprofloxacin is an antimicrobial used in the treat…

Q: A single droplet of three unknown liquid substances I, II and III were added to a flat, uniform,…

A: A question based on properties of liquid that is to be accomplished.

Q: 49. Which of the following fatty acids is most likely to be found in an oil (usually liquids at room…

A:

Q: A student performs the Electrochemistry, and obtains the following data: [Cu²+], M Potential, V 0.1…

A:

Q: Pressures up to 2000 atm are measured with a dead-weight gauge. The piston diameter is 4 mm. What is…

A: Given - Pressure = 2000 atm            Diameter of piston = 4 mm

Q: Calculate the heat of reaction for the reaction 25(g) + 2 OF 2(g) → SO₂(g) + SF4(g) using the…

A:

Q: > In a typical quantitative analysis, which step is the most crucial? What part will make or break…

A: Quantative analysis is the technique that is ysed to estimate the the quantity of unknown sustance.…

Q: 1.How many moles of butane (C4H10(g)) were combusted in the presence of excess oxygen gas if 55.8 L…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: Explain which, if any, of misonidazole and tinidazole will be selectively reduced in protozoa over…

A: Please find the attachment.

Q: A compound has the following % composition data 49 48% Carbon 5.15% Hydrogen 28.87% Nitrogen 16.49%…

A:

Q: The herbicide simazine is more polar than atrazine. In reverse phase chromatography of a solution…

A: It is asked which compound between simazine and atrazine will elute first in reverse phase…

Q: ACTIVITY 3.1.2 Explain the influence of solutes on water properties? Does this reflect colligative…

A: Negative water potential will emerge when a solute is added to pure water. The total pressure…

Q: The volume of a sample of gas is 650 mL at STP. What volume will the sample occupy at 0.00C and 950…

A: At STP, 1 mole of any gas occupies 22400 mL of volume. So, by unitary method, number of moles of gas…

Q: Given the following two reactions that occur in the atmosphere: 1) N₂O(g) + 1/2O₂(g) = 2 NO(g) K =…

A:

Q: C4H6O3), which has a molar mass of 102.04 g/mol. The density of acetic anhydride is 1.082 g/mL.…

A:

Q: Devise a laboratory exercise based on the Ehlrich test for Proteins  1. write a 3 paragraph…

A: Ehlrich test  A biochemical test called the Ehrlich Test is used to find the amino acid tryptophan…

Q: 10 110 12 each compound with the predominant intermol ed between the molecules of the compound: u 1.…

A: The intermolecular interactions are the intermolecular forces which mediate interaction between…

Q: Determine E cell reactions are: Pb²+(aq) + 2 e* Zn²+ (aq) + 2 e for the reaction: Pb2+ (aq) + Zn(s)…

A:

Q: 76. Most wine is prepared by the by yeast: C6H12O6(aq) →→2C₂H5OH(aq) + 2CO₂(g) How many grams of…

A:

Q: A sample of water at -4 ° C is converted to water at 80 ° C  Draw a heating curve to represent the…

A: Please find the attachment.

Q: What volumes of H₂(g) and O₂(g) at STP are produced from the electrolysis of water by a current of…

A: The gas H2 and O2 produced in the electrolysis is considered as Ideal gas. Volume of a ideal gas at…

Q: how can we clasify galvanized iron is it organic or inorganic compound?

A: Organic compound are large class of chemical compounds in which one or more atoms of carbon are…

Q: Q/ Give the IUPAC name for each ofthe following polymers? H(-OCH,OCO-CH,CH,CO-)OH H (-HN-C3H₂NH…

A:

Q: Decomposition Reactions Carbon Reduction Reactions O 2 Ag₂0(s)→ 4 Ag(s) + O₂(g) O2 MgO(s) → 2 Mg(s)…

A: Given:  Ellingham diagram of different metals with tabular data of enthalpy and entropy.

Q: For the reaction: 2 N₂O5(g) - 4 NO2(g) + O₂(g) the rate law is: Δ[02] = At At 300 K, the half-life…

A:

Q: b) Calculate the mass of oxygen in a 89.2 g sample of calcium phosphate.

A: Since you have asked for part b only, we are providing you a solution for part b of the question.…

Q: A measurment for the  Lambda-max for a colored solution is 671 nm with a very high Absorptivity.…

A: The frequency of light is the ratio of the standard speed of the light in a vacuum to the light's…

Q: Which of the following compounds cannot be used, even theoretically, in the :preparation of…

A:

Q: In Europe, gasoline efficiency is measured in km/L. If your car's gas mileage is 28.0 mi/gal, how…

A:

Q: Calculate the mass of precipitate formed after 54 mL of 0.68M Na3PO4 is mixed with 34 mL of 0.84M…

A:

Q: how can we classify softdrinks if its organic or inorganic compounds?

A: Ionic bonds are created between the atoms of molecules in inorganic substances.  Organic substances…

Q: Given the following initial rate data, calculate the specific rate constant. [A]o, M 5.1 x 10-4 5.1…

A: First we would determine rate law using the given experimental data.  Then we can calculate rate…

Q: Q/Give the IUPAC name for each ofthe following polymers? (- OCH2CH-Ph-) (-O-CH2CHCI-)…

A: Please find the attachment

Q: The ionization constant for ammonia is 1.8 x 10-5. What is the pH of an aqueous solution labeled…

A: we have to calculate the pH of 0.50 M ammonia solution

Q: Explain why there is no reaction when sodium is added to a solution of methyllithium but when…

A: Methyl lithium is an organometallic compound in which the bond between li and methyl group has more…

Q: What is the electronic configuration of oxygen? Does it have any unpaired electrons? And if it does…

A:

Q: Provide the necessary reagents to accomplish the following transformation. Match the Letter…

A:

Q: Write the solubility product constant expression for the following salt: Ca(OH)2(s). [Ca2+][OH-]…

A: To write expression for solubility product , we first write a dissociation reaction of Ca(OH)2.

Q: The mad scientist has one solution that is 6% acid and another solution that is 9% acid. How much of…

A: Let, the volume of 6% acid in Litre = V L the volume of 9% acid in Litre = (300 - V) L Total volume…

Solutions

Solutions can be considered as homogeneous mixtures which contain two or more than two chemical substances. The chemical substance which is the greater part is defined as solvent. And the chemical substance that is dissolved in a solvent is referred to as solute. Solution chemistry plays an important role in chemistry since it supports many commercial applications of solutions.