Solid sodium sulfite is slowly added to 50.0 mL of a 0.159M silver nitrate solution until the concentration of sulfiteion is 0.0408 M. The percent of silver ion remaining in solution is

Q: If the mass of a solution is 80g and the mass ratio of the solute is equal to 20%, calculate the…

A: Given, Mass of solution is 80 g. Mass ratio of solute to the solution is 20%. It represents for…

Q: In a titration experiment, 10.0 mL of 0.10 M NaOH solution reacted completely with20.0 mL of a…

A: VNaOH =10.0 mL MNaOH = 0.10 M  VHCl = 20.0 mL

Q: An aqueous solution contains 12 % Na2CO3 by weight. Express the composition in mole ratio and mole%.

A: let total mass of aqueous solution=100 g mass of Na2CO3=12 g moles of Na2CO3=mass of Na2CO3molecular…

Q: Methane diffuses from a gas phase onto a catalytic surface where it undergoes the following reaction…

A:

Q: Indicate the concentration of each ion present in the following solutions: a) 0.35 M NaOH b) 0.55 M…

A:

Q: What happens when a small amount of sodium hydroxide is added to a mixture of ammonia and ammonium…

A: The given mixture of ammonia and ammonium chloride is a buffer solution.

Q: Example 4.2. HNO, and 8 wt% water, by mixing You are asked to make 1,000 kg of the mixed acid…

A:

Q: Silica gel is to be used to separate a mixture of butane and butylene. The feed containing 55%…

A: Given :Feed at the bottom contains-Basis feed= 100 mol (supposed)Butane= 55% = 55 molButylene= 45%…

Q: V Self-diffusion A. Concentration profile v Fick's firts law B. Diffusion flux is linear function of…

A:

Q: Design of Absorption Tower A mixture of gas containing 90.5% mole % Hydrogen peroxide (H₂O2) and…

A: It is given that,the fraction of methanol recovered is mole fraction of methanol in the gas mixture…

Q: diffusion

A: Diffusion in solids occurs through the mechanism of interstitial diffusion or vacancy diffusion.…

Q: 1000 kg of a solution of citric acid (C6H8O7)and water contains 5% acid and 95 % water. Citric Acid…

A: Given Find a.Weight of the benzene used in this operation b. Weight of the benzene layer

Q: A 5 mm thick ammonia-water solution layer is in contact with an organic liquid on one side of an…

A: In mass transfer the transport phenomena is diffusion. The concentration diffuses from higher levels…

Q: What is the concentration of the HCI acid solution, if 75 ml of the solution is neutralised by 125…

A: This question is related to neutralization of HCl and NaOH We will apply the concept of…

Q: Note that if the % carbon and net hydrogen lost in the refuse is around 7%, a. Determine the orsat…

A: The moles of components are calculated by assuming a basis. The loss percent is considered and the…

Q: #2. (NH4)2C2O4 is soluble to the extent of 4.4 kg per 100 kg of water. A slurry is made by mixing 20…

A: Given.

Q: Solid lead nitrate is slowly added to 75.0 mL of a 0.0624 M ammonium carbonate solution. The…

A: Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: The molar solubility of lead chloride in a water solution is М.

A:

Q: An aqueous solution of this is used as an embalming agent butyraldehyde caproaldehyde O pentanal

A: Embalming agents are variety of preservatives chemicals.

Q: [Gas Absorption/Scrubbing] In a plastic manufacturing concern, air is used to dry plastic sheets in…

A: here desorption of acetone is taking place from air using water as solvent- rate at which…

Q: Dissolve 2g of table salt in 8 g of distilled water. Calculate the percentage of solvent and solvent

A:

Q: In order to obtain barium in a form that may be put into solution, the natural barytes, containing…

A: Balance reaction BaSO4 + Na2CO3 = BaCO3 + Na2SO4 Formula weighs BaSO4 − 233.36 g/mol BaCO3 − 197.3…

Q: Solute S has a distribution constant of 4.1 between water (phase 1) and hexane (phase 2). A 82.0 ml…

A: Given: Between water and hexane solute has Distribution constant k=4.1 Volume of water phase V1= 82…

Q: Calculate the percent ionization of propionic acid 1C2H5COOH2 in solutions of each of the following…

A: The percent ionization of the propionic acid is to be calculated for the given concentration.

Q: If 38.5 mL of lead(II) nitrate solution reacts completely withexcess sodium iodide solution to yield…

A: The molarity of the lead(II) ion in the original solution is to be determined.

Q: In a solution there is 15.3 g of phosphoric acid that has 8.6 L of water, 10.9 g of calcium…

A: Write the reaction between phosphoric acid and calcium hydroxide as follows: H3PO4 + Ca(OH)2  →…

Q: 1. Two salts A and B are dissolved in water. At the temperature of the experiment, the solubility of…

A: Dear Subscriber! You have posted two numbered questions, with the first question itself having four…

Q: that is exposed to air. An open tank, 12 ft in diameter, contains methyl tert-buytl-ether (MTBE).…

A: The expression for unimolar counterdiffusion under bulk flow isNB=C DB(yB1)∆z(1-yB)LMMolar…

Q: Silica gel is to be used to separate a mixture of butane and butylene. The feed containing 55%…

A: A substance molecule's retainment onto a solid's surface or liquid's surface is an adsorption…

Q: How much water (in kg) must be evaporated in the evaporator per kg of product? Sodium hydroxide is…

A: After dissolver=30 % solution Product: 50% NaOH7% NaCl43% H2O

Q: The maximum amount of magnesium fluoride that will dissolve in a 0.291 M sodium fluoride solution is

A:

Q: Silica gel is to be used to separate a mixture of butane and butylene. The feed containing 55%…

A: The feed is a mixture of butane and butylene with 55% and 45% by mole respectively. Silica gel is…

Q: Some HC1 gas diffuses across a film of air 0.1 in. thick at 20°C. The partial pressure of HC1 on one…

A:

Q: Biochar is believed to be a good absorbent for various contaminants. In an isotherm experiment, a…

A: The Freundlich Adsorption isotherm is given as:  KF is adsorption capacity or constant and n is…

Q: When high concentrations of SO3 gas are added to sulfuric acid, the compound formed is Check all…

A: Given - Components High concentration SO3 and H2SO4 Find - Compound formerd

Q: The surface of a 2.5 mm thick ammonia (A) (NH3) – water (B) (H2O) solution at 298 K is in contact…

A: Given data: Thickness of ammonia water solution surface = 2.5 mm Temperature = 298 K The…

Q: 2) Calculate the pH, pOH, and all of the equilibrium concentrations for a 3.00 mM solution of…

A: Potassium benzoate (C6H5COOK) is the salt formed from the benzoic acid (C6H5COOH). Here, benzoate…