Soil with a unit weight of 16.97 kN/m^3 is loaded on the ground surface by a uniformly distributed load of 300 kN/m^3 over a circular area 4 m in diameter. Compute the vertical stress increment due to this uniform load at a depth of 5 m below the center of the circular area.

Soil with a unit weight of 16.97 kN/m^3 is loaded on the ground surface by a uniformly distributed load of 300 kN/m^3 over a circular area 4 m in diameter. Compute the vertical stress increment due to this uniform load at a depth of 5 m below the center of the circular area.

Principles of Foundation Engineering (MindTap Course List)

9th Edition

ISBN:9781337705028

Author:Braja M. Das, Nagaratnam Sivakugan

Publisher:Braja M. Das, Nagaratnam Sivakugan

Chapter8: Vertical Stress Increase In Soil

Section: Chapter Questions

Problem 8.12P

See similar textbooks

Related questions

Q: In the figure shown, the concrete dam is 16m high and 13m wide at the base. If the specific weight…

A: The concrete dam in the illustration is 16 metres high and 13 metres broad at its base. Find the…

Q: A reinforced cocncrete beam has a width of 250mm and total depth of 500mm. The beam will be designed…

A: Reinforced concrete- Reinforced concrete (RC), also known as reinforced cement concrete (RCC), is a…

Q: pumping test was carried out in a soil bed of thickness 15 m and the following measurements were…

Q: Calculate the coefficient of permeability in mm/s of a soil sample, 6 cm in height and 50 cm2 in…

A: Given data, Height of sample (L) = 6 cm Area of cross section (A) = 50 cm² Volume of water (V) =…

Q: A double wall sheet pile coffer dam retains a height of water 9 m on one side. A flow net…

Q: Question 13 of 14 > - /5 View Policies Current Attempt in Progress Determine the coordinates of the…

Q: A pole is held vertically on a soil surface by three equally spaced wires tied to the top of the…

Q: A canal having side slopes 1:1 is proposed to be constructed in a cohesive soil to a depth of 10 m…

Q: The initial principal stresses at a certain depth in a clay soil are 100 kPa on the horizontal plane…

Q: The factor of safety of an infinite soil slope shown in the figure having the properties c = 0, 0 =…

Q: A glass cylinder 5 cm internal diameter with a screen at the bottom is used as a falling head…

A: Please find step by step solution below:

Q: A reinforced cocncrete beam has a width of 250mm and total depth of 500mm. The beam will be designed…

A: Steel ratio = Astbd * 100 Mu = 0.87 * fy * Ast (d - 0.42 xu lim) Mu = Factored moment = 540 KN -m…

Q: Find the displacemnt value if work done is equal to 120 j and force applied object 40 N on

A: Introduction : The given question is related with mechanics . In this question we are provided with…

Q: An unconfined aquifer is known to be 32 m thick below the water table. A constant discharge of 2…

Q: An earth dam is built on an impervious foundation with a horizontal filter at the base near the toe.…

Q: A wooden beam is fabricated by nailing together three boards as shown. The boards have dimensions of…

Q: (4) 30 t W 27x84 A992 steel (a) If the beam is not laterally braced 4 Mn= ? 6) If the beam is…

Q: ate the ntaid f the aua

Q: There is a line load of 120 kN/m acting on the ground surface along the y-axis. Determine thr…

Q: Which of the following pavement has greater life? A. Bituminous pavements В. О Cement concrete…

A: Which of the following pavement has greater life? The correct answer is B ) Cement concrete…

Q: Determine the beam deflection at point B.

Q: The materials not included in highway construction are A. Stone Dust C. Soil D. Petrol B.

A: Ans- (D)Petrol Stone, dust and soil is used in subgarde and base. Petrol is not used directly in…

Q: The initial head is 300 mm in a falling head permeability test. It drops by 10 mm in 3 minutes. How…

Q: 2. For the beam shown in the figure, find (a) the maximum shear stress and (b) the shear stress at a…

Q: В L A 40° 30°

Q: For a roof truss system of an industrial building, following data is given Span of truss = 6m %3D…

Q: For a homogeneous earth dam 32 m high and 2 m free board, a flow net was constructed with four flow…

Q: From the beam shown with fixed end support atA and rollers at B and C respectively, it carries a…

Q: Determine the force in member BE of the loaded truss. The force is positive if in tension, negative…

Q: Consider a wood beam (see figure) carrying a uniform load of 16.5 kN/m (which includes the weight of…

Q: The initial principal stresses at a certain depth in a clay soil are 100 kPa on the horizontal plane…

A: Option (a) is the correct answer. Draw the Mohr's circle before & after construction. The…

Q: An aluminum pipe with a length of 60 m at a temperature of 10°C rests freely on the ground. An…

A: Answer:- The length of the ALUMINUM pipe after the change in temperature can be expressed as by the…

Q: 5.13 A two-dimensional flow is described by velocity components u= 2x and v= -2y. The discharge…

A: Please find step by step solution below:

Q: An unconfined aquifer is known to be 32 m thick below the water table. A constant discharge of 2…

Q: 4. Find the lightest S-shape for the beam shown if the working stress in bending is 175 MPa. What is…

Q: The volume of the pyramid formed in the first octant by the plane 6x + 10y +5z-30 =0 is: 45

A: Given, 6x + 10y + 5z - 30 = 0

Q: For the beam with cross-section shown, the allowable flexural stresses for tension and compression…

A: L = 10m

Q: pole carries a vertical load of 200 kN. Determine the vertical total stress increase in kPa at a…

Q: A permeameter of 8.2 cm diameter contains a sample of soil of length 35 cm. It can be used either…

A: We have to find the time in seconds required to fall the head from 150 cm to 100 cm

Q: An excavation is to be performed in a stratum of clay, 9 m thick, underlain by a bed of sand. In a…

Q: There is a line load of 120 kN/m acting on the ground surface along the y-axis. Determine thr…

A: Line load intensity and loading coordinates have been given and it has been asked to determine…

Q: A pumping test was carried out in a soil bed of thickness 15 m and the following measurements were…

Q: Determine the allowable load capacity of the 0.4 m diameter pile shown in Figure 4. The fill is new…

Q: 4.30 locate the centoid x of a

Q: A baseball is thrown from a horizontal plane following a parabolic path with an initial velocity of…

Q: 6.25 Ai a distance of 20 cm from the axis of a whirlpoo! in an ideal liquid, the velocity is 10 m/s.…

A: Appreciate if there is detailed work with explanation and finds you helpful for ease of…

Q: Soil with a unit weight of 16.97 kN/m^3 is loaded on the ground surface by a uniformly distributed…

A: We will use formula for circular area stress.

Q: I 1.0 m 23.5 kN/m³ Yw = 9.81 kN/m³ Yc 0 = 60 ° F 3.0 m 8.0 m

Q: A cylindrical sample of soil has a height of 205mm and a diameter of 102.4mm. The sample was found…

A: Given data in question Height Diameter Specific gravity Bulk mass Oven dried mass To find out…

Q: Determine the x-, y-, and z-coordinates of the mass center of the body constructed of three pieces…

A: We will find out centroid according to each area provided.

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Stresses in saturated soil without seepage

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

A circular area having a radius of 3 m carries a uniformly distributed of 90 kPa is applied to the ground. Compute the total vertical stress in kN/m^2 increment due to this uniform load if the unit weight of soil is 18.40 kN/m^3 at point 6 m below the ground surface at a horizontal distance of 1.5 m from the center of the cirular area.
From the given Figure, determine the following: a. Effective stress at the bottom of the clay b. if the water table rises to the level of the soil surface, what is the effective stress at the bottom of the clay. c. if the water is 3m above the soil surface, what is the effective stress at the bottom of the clay. 4m 5m 156 kN/m² 16.6 kN/m² Water table Y = 17,8 kN/m
A soil profile is shown in figure below. Dry sand 6m Ydry = 16.5 kN/m³ B Groundwater table Saturated sand 13m Ysat = 19.25 kN/m² C Dry sand Saturated sand Clay Calculate the following: a. Effective stress at point A in kPa. b. Effective stress at point B in kPa. c. Effective stress at point C in kPa. 5.
A circular area having a radius of 3 m carries a uniformly distributed of 90 kPa is applied to the ground. Compute the total vertical stress in kN/m^2 increment due to this unifrom load if the unit weight of soil is 18.40 kN/m^3 at point 6 m below the edge of the circular area.
A clay formation having a depth of 4 m. underlies a sand formation having a depth of 3 m. The dry unit weight of sand is 16.5 kN/m3 and the saturated unit weights of clay and sand are 20.4 kN/m3 and 19.6 kN/m3 respectively. The groundwater table is at the interface of the sand and clay. Compute the effective stress at the bottom of clay. Use 3 decimal places in MPa.
A circular area having a radius of 4.5 m carries a uniformly distributed load of 125 kPa is applied to the ground. Compute the total vertical stress in kPa due to this uniform load if the unit weight of the soil is 17.30 kN/m3 at a point 6 m below the edge of the circular area.
A Dry sand 6m Ydry = 16.5 kN/m³ B Groundwater table Saturated sand Ysat = 19.25 kN/m³ 13m Dry sand Saturated sand Clay Calculate the following: a. Effective stress at point A in kPa. b. Effective stress at point B in kPa. c. Effective stress at point C in kPa.
A vertical load of 300 kN is applied to a 1.5 m * 1.5 m area at the ground surface that is level.a. Compute the induced vertical stress, ∆sz, at a point 2.0 m below the corner of this squareloaded area.b. Compute the induced vertical stress, ∆sz, at a point 2.0 m below the center of this squareloaded area.
IV. A soil element is shown in Figure 3. (use equations) 130 kN/m² +35kN/m² 30⁰ 60 kN/m² 10 11. 12 + + B SITY FICAT 35 kN/m² Figure 3 What is the value of the maximum stress in kPa? What is the value of the normal stress acting at the plane AB in kPa? What is the value of the shear stress acting at the plane AB in kPa?
Problem 1 A ground profile consists of 2 m of silty sand underlain by 3 m of clay. The ground water table is 3 m below the ground surface. The sand has a unit weight of 14 kN/m3. The clay has unit weight of 16 kN/m3 above the water table and 20 kN/m3 below the water table. a. Determine the total stress at bottom of the clay b. Determine the pore water pressure at the bottom of the clay c. Determine the effective stress at the bottom of the clay Problem 2 50 ft thick sand is underlain by 25 ft clay. The ground water table, initially at the ground surface, was lowered to a depth of 25 ft below the ground. After such lowering, the degree of saturation of the sand above water table was lowered to 20%. Saturated and dry unit weight of sand are 135 pcf and 116 pcf respectively. The saturated unit weight of clay is 120 pcf. a. What is the vertical effective pressure at the midheight of the clay layer before lowering of the water table in psf? b. What is the vertical effective pressure at the…
A circular area having a radius of 3 m carries a uniformly distributed of 90 kPa is applied to the ground. Compute the total vertical stress in kN/m^2 increment due to this uniform load if the unit weight of soil is 18.40 kN/m^3 at point 6 m below the center of the circular area. a. 27.26 b. 137.66 c. 129.02 d. 135.17
or the soil profile shown in the Figure: a. Calculate the effective stress at point C. b. How high should the water table rise so that the effective stress at C is 200 kN/m²? Dry sand Yory-165 AN 6m Groundwater table Saturated sand 13m 7-19.25 AN Dry sand Satted sand Clay