soil sample 15 cm in diameter is placed In a tube 2 m long. A constant supply of water is allowed to flow into one end of the soil at A and the outflow at B is collected by a beaker. The average amount of water collected is 2 cubic centimeter every 5 seconds. The tube is inclined and has a head difference of 2.5 m. Determine the following 1. Hydraulic Gradiant. 2. Flowrate in cm/s. 3. Discharge Velocity in cm/s. 4. Seepage velocity in cm/s if porosity is 0.420. 5. Hydraulic Conductivity

soil sample 15 cm in diameter is placed In a tube 2 m long. A constant supply of water is allowed to flow into one end of the soil at A and the outflow at B is collected by a beaker. The average amount of water collected is 2 cubic centimeter every 5 seconds. The tube is inclined and has a head difference of 2.5 m. Determine the following 1. Hydraulic Gradiant. 2. Flowrate in cm/s. 3. Discharge Velocity in cm/s. 4. Seepage velocity in cm/s if porosity is 0.420. 5. Hydraulic Conductivity

Fundamentals of Geotechnical Engineering (MindTap Course List)

5th Edition

ISBN:9781305635180

Author:Braja M. Das, Nagaratnam Sivakugan

Publisher:Braja M. Das, Nagaratnam Sivakugan

Chapter8: Stresses In A Soil Mass

Section: Chapter Questions

Problem 8.14P

See similar textbooks

Similar questions

3. A permeameter is filled with sand. When water is allowed to flow through the device, a flow rate of Q.er = 10 cm'/s is observed. The sand is dried and filled with oil. The total hydraulic head at the inflow and outflow ends of the permeameter are the same in both tests. Calculate the flow rate of oil Qol. Data: puil=0.9 pwaer Hlail = 1.8 lue
A soil sample is placed in a 1m long and 10cm diameter tube. A constant supply of water is allowed to flow from inlet to outlet. The total water head at the inlet is 2m and the total water head at the outlet is 1m. The hydraulic conductivity is 0.001 cm/s. Which of the following answer is correct? O a. The flow velocity is 0.001 cm/s Ob. The flow velocity is 25 cm/s c. The hydraulic gradient in the tube is 2 Od. The hydraulic gradient in the tube is 0.001
A soil sample 10 cm in diameter is placed in a tube Im long. A constant supply of water is allowed to flow into one end of the soil at A and the outflow at B is collected by beaker. The average amount of water collected is 1 cm for every 10 seconds. Determine: a. Hydraulic gradient b. Flow rate c. Average velocity d. Seepage velocity, if e 0.6 e. Hydraulic conductivity 1 m 1 m 0.8 m Datum Table
6. The sludge hopper of a sedimentation tank is approximated as a truncated square prism provided with an orifice of 100 mm dia. at its bottom as shown in the figure. The sludge is being discharged through the orifice Determine the time taken for emptying the hopper. Assume Cd=0.62. 2m 1m E im -
A falling head hydraulic conductivity test is performed on a sample of soil. The stand pipe having a diameter of 0.20cm is observed and it takes 60 seconds for the water to drop by 50 cm from an initial hydraulic head of 90cm. The sample has a length of 20cm, and a diameter of 4cm. a.Find the coefficient of permeability (cm/sec) b.Solve for the hydraulic gradient c. Compute the rate of flow of water in the soil. (cm' /sec.) 0.20 cm 6 s TAND PIPE 50cm Acm 不 20am -: SOIL
PROBLEM 2 A well is constructed to pump water from a confined aquifer. Two observation wells are constructed at distances of 100 m and 1000 m respectively. Water is pump from the pumping well at a rate of 0.2m3/min. At steady state, the draw down is observed as 2 m and 8 m respectively in the farthest and the nearest observation wells. Diameter of the test well is 1m. a. Determine the hydraulic conductivity in cm/s if the thickness of the aquifer is 20 m. b. Determine the drawdown in the test well.
4. Piezometric tubes are tapped into a pipe section as shown in the figure below. The liquid is incompressible and flowing at a volumetric flowrate of 0.35 m³ s-¹. The piezometric head is 1 m at the upstream location (1) and 0.5 m at the throat (2). The pipe diameter at the upstream location (1) is 0.5 m. Answer the following: 1 m Flow Streamline- 0.5 m Datum Hint: the piezometric head is the sum of the elevation and pressure heads. (a) Find the velocity in the upstream section. (b) Find the velocity in the throat section. (c) Find the diameter in the throat section. (d) Based on your findings in (a) and (b), qualitatively describe how pressure and velocity are related along the streamline.
In the heterogeneous system shown below, 1-D groundwater flow is perpendicular to layers of varying hydraulic conductivity. K1 = 0.5cm/sec; K2 = 0.10cm/sec; K3 = 0.25cm/sec and b1 = 20 m; b2 = 40 m; b3 = 60 m Ah, Ahz Ah3 K1 K2 K3 b1 b2 b3 a) The flow across the system q is 0.03cm/sec/m². Using Darcy's Law, find the change in head Ah across each layer. b) Find the effective hydraulic conductivity (Ke) for an equivalent homogeneous system, that is, a system with the same total gradient and flow rate as the heterogeneous system.
A constant head test is performed using a permeameter in the laboratory. The graduated cylinder collects 892 cm3 of water in 112 seconds. The soil specimen diameter = 18 cm , th elevation of water in upper-most piezometer is 181 com , the elevation of water in lowest piezometer is 116.6 cm and the piezometer inlets are evenly spaced at 16.7 cm on center. Compute the hydraulic conductivity, k and choose the correct answer below based on that. O A. 2.1 x 10^-3 cm/second O B. 1.5 x 10^-2 cm/second O C. 2.91 x 10^-2 cm/second O D. 2 x 10^-2 cm/second QUESTION 10 Given: -Applied stress on a soil = 122 kPa %3D -Influence Factor = 0.4 Compute the change in stress at 10 m below the edge of 25 m dimeter oil tank and select the correct answer from below: O A. Change in stress = 44 kPa O B. Change in stress = 49 kPa O C. Change in stress = 40 kPa O D. Change in stress = 42 kPa %3D
Don't copy from other solutions thank you. Three piezometers have been installed in the confined aquifer having a uniform thickness of 4.6 m. and hydraulic conductivity of 2 x 104 m/s. a) Compute the hydraulic grądient. b) Compute the transmissivity in m2/day. c) Compute the flow rate per unit width of the aquifer in liters/day.
4. A falling-head permeability test was run on a soil sample 9.6 cm in diameter and 10 cm long. The head at the start of the test was 90 cm. The coefficient of permeability of the soil was found to be 5x106cm/sec. The diameter of the stand pipe was 1 cm. Determine the flow after 30 minutes, in cm³/hr. Determine how much head was lost during the first 30 min. 1 m ø Standpipe 9.6 cm Ø Sol L= 10 cm
Q1:For the apparatus shown in Fig.1. Determine: a) the pressure, elevation, and total head at points A-E. b) the average or discharge velocity of flow through the soil (the soil is located between points B and D), where the coefficient of permeability for the soil is estimated to be (k = 0.05 cm/s). 20 15 + 5.0 cm Ah = 5 cm Неad (cm) 5.0 cm 10 1 2.0 cm soil 5.0 cm 2.5 cm 1.5 cm Datum Fig.1 centerline D 5,