Show that velaaly, and particle as measwed with velcity V wi8.ts) are in sand sfwheres is maving related where the motion is considered along x-axis. with velocity4e Also find the inverse Yelation to ine
Q: Why is mercury rather than water manometers used for pressure measurements?
A: We know pressure by a material of density (d) having height (h) is given by P= dgh = density* acc...
Q: Consider a system of two Einstein solids, where the first "solid" contains just a single oscillator,...
A: The expression for the micro states for first Einstein solid is, Here, N is the number of harmonic ...
Q: In this problem you will investigate the behavior of a van derWaals fluid near the critical point. I...
A: GIVEN: behaviour of vanderwaals fluid near critical point. to find : (Vg - Vi )
Q: Two particles are created in a high-energy accelerator and move off in opposite directions. The spee...
A: Given: The speed of first particle is u=0.650c. The speed of particles relative to each other is v'...
Q: Choose the right answer: i) In scanning tunneling microscopy (STM) a. the tip is heated to generate ...
A: Scanning tunneling microscopy is a technique introduced to study the surfaces of various samples dow...
Q: Problem 5.2: Gaussian Beams and a Two Mirror Resonator (a) What are the characteristics of a Gaussia...
A: (a) At waist the beam radius is minimum and the radius of curvature is infinite that is the phase of...
Q: An object is moving in damped SHM, and the damping constant can be varied. If the angular frequency ...
A: The frequency of damped oscillation is f=12πω2-b2here ω-natural frequency of the SHM(when damping c...
Q: How many years would you have to wait to observe a 18 angular shift in the perihelion of Mercury due...
A: By using Kepler's law of motion and Newton's law of motion we haveF=ma ...
Q: A shear force of 350 N is applied to one face of an aluminum cube with sides of 30 cm while the oppo...
A: Given : Force F = 350N Side S = 30cm =0.3m The shear modulus for ...
Q: (15) Given the following time-dependent position function: 7(t) = 3 ti-24t23, what will this object'...
A:
Q: An object of mass m is at rest on a rough inclined plane with height h, length 8 m, and which makes ...
A: Conservation of Energy According to the law of conservation of energy, for an isolated system, the i...
Q: We known that the 808 nm and 655 nm diode laser are same durations and power but why are the effects...
A: Solution: The effects of these laser devices are different is characterized and defined as below:
Q: Solve for me branch d and e
A: Dimensional Analysis Dimensional Analysis is the study of dimensions of various complex quantities a...
Q: A 5.6-kg block is pushed 3.9 m up a vertical wall with constant speed by a constant force of magnitu...
A: Given: The mass of the block is m = 5.6 kg The vertical distance moved by the block is d = 3.9 m The...
Q: Advanced Physics Question
A: Hello. Since you have posted multiple questions and not specified which question needs to be solved,...
Q: In a real hemoglobin molecule, the tendency of oxygen to bind to a heme site increases as the other ...
A: given that Answer: In a reel hemoglobin molecule, the tendancy of oxygen to bind to a heme site incr...
Q: A central force with potential V(r)=kmr² (k>0)is acting on a particle of mass m. Calculate the angul...
A:
Q: Three different processes act on a system. (a) In process A, 42 Jof work are done on the system and ...
A: According to the first law of thermodynamics, ∆U = Q - W where, ∆U is the change in the internal ene...
Q: A machinist is required to manufacture a circular metaldisk with area 1000cm2 .(a) What radius produ...
A: Area of the intended disk, A=1000 cm2 Let its radius be r Therefore, πr2=Ar2=1000*722r=1000*722=17.8...
Q: A basket of negligible weight hangs from a vertical spring scale of force constant 1500 N/m. (a) If ...
A: Total Energy of brick-basket-spring system before stretching of springEi=KE1+mgyiTotal Energy of bri...
Q: A fine metal foil separates one end of two pieces ofoptically flat glass, as in Fig. 24–33. When lig...
A: Given: Wavelength λ=670 nm 24 dark bands
Q: A car and driver of total mass 1350kg are moving at 30 m/s on a horizontal road when the driver sees...
A: This problem is under constant acceleration motion because the force acting on the vehicle is consta...
Q: In one form of cataract surgery the person’s natural lens, which has become cloudy, is replaced by a...
A: Given: The object distance: s=24cm To find: the power, in diopters, of the corrective contact lense...
Q: A 1-kg mass is attached to a spring with stiffness 100 N/m. The damping constant for the system is 0...
A: Given Mass = 1 kg Stiffness = 100 N/m Damping constant = 0.2...
Q: A solid conducting sphere has net positive charge and radius R = 0.400 m. At a point 1.20 m from the...
A: Given: The radius of the sphere R = 0.4 m. The electric potential at 1.2 m from the center Voutside...
Q: White light is incident on a soap film at an angle of sin -1 and the reflected light on examination ...
A: Let i denotes the incident angle, r denotes the refracted angle inside the film, t denotes the film ...
Q: A baseball is hit into the air at an initial speed of v0 = 25.6 m/s at angle ? = 60o above the horiz...
A: The time taken by fielder to catch the ball is,t=2v0Sinθgwhere, v0 is the velocity with which the ba...
Q: Sketch f(y) versus y. Show that y is increasing as a function of t for y < 1 and also for y > ...
A:
Q: Two blockS are connected Figure E6.7 by a very light string passing over a massless and frictionless...
A: The work done by a force is W=F→·d→=Fdcos(θ) where θ is the angle between the force and displacement...
Q: The Heaviside function H is defined as given in the question It is used in the study of electric ...
A: (a) The heavy side function is given as: H(t)=0 if t<01 if t≥0 The graph is:
Q: A water balloon is fired at 34.0 m/s from a water cannon, which is aimed at an angle of18° above the...
A: given that, initial velocity of ballon, u = 34m/s Angle, θ = 18o distance of target, R = 42 m radius...
Q: Find the explaination for the Bernouli's theorem,
A: According to the Bernoulli's theorem, the total mechanical energy comprised by the fluid in motion o...
Q: Find the image positions corresponding to object distances of; (a) 20.0 cm, (b) 10.0 cm, and (c) 3.0...
A: We'll answer the first question since the exact one wasn't specified. Please submit a new question s...
Q: Graph the functions. Then find the extreme valuesof the function on the interval and say where they ...
A: Input interpretation:
Q: Adiabatic compression of air in a cylinder of a diesel engine. Maximum Initial volume compression Th...
A: Solution: We know that, In the adiabatic process, the work done is given as: W=∫V1V1/15 P.dVan...
Step by step
Solved in 2 steps
