Show that minimum spacing for non-coherent orthogonal fsk is double than the minimum spacing for coherent orthogonal fsk.
Q: Determine the carrier to noise ratio for a receiver with a receive power value of -80dBW, the…
A: Given
Q: A person with a receiver is 5 km away from the transmitter. What is the distance that this person…
A: The distance between the transmitter and the person with the receiver is 5km as shown below:
Q: Derive the equation to get the message from DSB-SC signal using homodyne receiver.
A:
Q: F the carrier signal of AM system is with frequency fc-500kHz and Amplitude 20Vp and a message…
A: According to the question, carrier frequency fc=500 kHz; The amplitude of carrier signal Vc= 20 V…
Q: For a communication link what are the different types of modulation and their diagrams including…
A: Modulation : It is the process, where properties of carrier signal lke amplitude, phase or…
Q: Consider a single shunt resistor of R=100 2 as a two-port with Zo=50 2 characteristic impedance…
A:
Q: Sketch the Z-plane pole- Zero plot for this filter.
A: conside the given question;
Q: 8. For an unmodulated carrier amplitude of 16 Vp and a modulation coefficient m = 0.4, determine the…
A: The solution can be achieved as follows.
Q: In a baseband communications link, frequencies upto 3500 Hz are used for signalling. Using a raised…
A: Given a base-band communication link, Frequency used for signalling, W = 3500 Hz The excess…
Q: A cellular service provider decides to use a digital TDMA scheme which can tolerate a signal-…
A: According to question we have to find the value of optimal value of N for (a) omnidirectional…
Q: Determine the energy per bit-to-noise density ratio when the receiver input carrier power is 100…
A:
Q: For a given optical fiber cable in air, what happens to the maximum usable data rate when the…
A:
Q: For a conversation signal from a phone call, what its frequency domain plot looks like?
A: frequency signal Frequency is measured in a Hertz (Hz), i.e 1 cycle per second. The radio spectrum…
Q: 1- Indicate the sidebands in the modulated signal spectrum. 2- Calculate Signal-to-noise (SNR) at…
A: Given data is - fm=20 kHzfc=43.67 MHz Solution 1- Sideband calculation- Lower Sideband-…
Q: Answer the following questions with simple answer within few lines only. A. If the probability of…
A: Hello. Since you have posted multiple questions and not specified which question needs to be solved,…
Q: a) Draw clearly the block diagrams of the coherent and non- coherent detectors that can be used to…
A: a. coherent detection the same network signal (used to generate a DSBSC signal) is used to receive…
Q: i) A communications of 20 dB. Determine channel with a bandwidth of 4 MHz has a signal-to-noise…
A: Since you have asked multiple questions, we will solve the first question for you. If you want any…
Q: Example: The carrier signal is 10 cos(2n x 10°t) v has amplitude modulation with modulating signal…
A:
Q: A channel was designed to transmit information with capacity (3000 kbit/sec) and bandwidth (1 MHz),…
A: Solution 1.Compute the signal power required at this case(in dB): Given that: Channel capacity…
Q: Enumerate things that can be done to improve transmission distance and communications reliability of…
A: The VHF bands(between 30 MHz to 300 MHz), UHF and microwave and communication like television, radar…
Q: It is given as Z1 = Z3 = 50Ω and Z2 = 25Ω in the two-port Π circuit given in the figure. According…
A: Apply nodal analysis at V1 side I1=((V1-0)/50)+((V1-V2/25) 50I1=V1+2V1-2V2 3V1-2V2=50I1…
Q: For the transsmision line below find the average incident Power p and the average refelcted Power p…
A: According to the question, for the given circuit as shown below We need to find the average…
Q: (6) Without modulation, the carrier power in an AM transmitter is 5 KW. This carrier is modulated by…
A: AM transmitter: The transmitter is a device that transmitter or sends the radio wave that wave has…
Q: A) Briefly explain the effect of increasing the modulation index value on power efficiency in Full-…
A: According to the question, we need to discuss A) Briefly explains the effect of increasing the…
Q: Question 3: Enumerate solutions to decrease propagation delay. Question 4: What are the effects of…
A: 3) Following are the solutions to decrease propagation delay- 1. Minimize no. of transistors through…
Q: Select the correct statement regarding transmission systems. a. only unguided systems need to worry…
A: According to the question, we need to select the correct statement regarding transmission systems.
Q: b. Determine the proper spatial sampling interval required to make small-scale propagation…
A: The minimum sampling frequency should be at least twice the frequency of the system. The proper…
Q: If a communication bandwidth of Bc= 20,000 Hz is available how many bits, n, per signal clement are…
A: The bit rate and the bandwidth of the signal are known. For the perfect noiseless channel, the bit…
Q: a certain cell of a cellular mobile communication system, the serving base station is located 4 Km…
A: We will use free space analysis to calculate received power . First we will calculate path loss then…
Q: Question) A directional coupler has the scattering matrix given below. Find the return loss,…
A: Given:-
Q: ? CONSIDER a air- fille d woveguide operating &u the TEe Mode at trequeney Ceut off trequehey, find…
A: Given: An air-filled waveguide operating in TE12 mode. Operating frequency is 20% higher than the…
Q: The A.M transmission is used for long distance and video communication instead of F.M. Why? Also…
A: We need to explain why A.M transmission is used for long distance and video communication instead of…
Q: Draw the block diagram of Coherent detector for an SSB wave detection. Explain the significance of…
A: According to the question, we need to draw the block diagram of the Coherent detector for an SSB…
Q: 2. Calculate the channel capacity of a communication system with a channel bandwidth of 1 MHz and…
A:
Q: 5. The short circuit load is connected to a transmission line. When the transmission line length is…
A:
Q: Wireless communication Determine the minimum C/N ratio for an 8-PSK system when the transmission…
A: The solution is given below
Q: It is given as Z1 = Z3 = 50Ω and Z2 = 25Ω in the two-port Π circuit given in the figure. According…
A: consider the given question;
Q: Suppose the spectrum of the channel is between 5 MHz and 6 MHz. If the signal to noise ratio is…
A: Given data: SNR is 24dB Spectrum of the channel is between 5 MHz and 6 MHz.
Q: Assume that a voice channel occupies a bandwidth of 4 kHz. We need to combine three voice channels…
A: Given, Voice channel bandwidth = 4kHz Combination of three voice channel into single link with…
Q: An optical Fibre System is to be installed between two towns that are 74 Kms apart. If the fibre has…
A: The solution is given below
Q: a. For a Communications system with capacity of 40000 bps and SNR = 30dB and a lower frequency of…
A:
Q: For a transmission medium, SNRdb is given as 30. If bandwith is selected as 9,06 MHz, which answer…
A:
Q: The Maxwell bridge is said to be independent of the frequency. VWhy?
A:
Q: Q. No 2. The A.M transmission is used for long distance and video communication instead of F.M. why?…
A: Firstly, Amplitude transmission (AM) is used for the long distance instead of Frequency modulation…
Q: 1. A pulse is transmitted down a cable that has a velocity of propagation of 0.8c. The reflected…
A: We need to find out range and time for given details .
Q: The A.M transmission is used for long distance and video communication instead of F.M. why? Also…
A: AM has a recurrence scope of 531 kHz to 1602 kHz and then again, FM has a recurrence range between…
Q: In multiamplitude scheme with M = 16 a) Determine the minimum transmission bandwidth required to…
A:
Q: Find 1-the value of pulse dispersion per unit length 2-maximum Bandwidth on nannel ,if you have a…
A: multimode graded index fiber pulse broadening (t)=0.2 µs distance, D= 16Km assuming there is no…
Step by step
Solved in 3 steps with 2 images
- pleease have step by step solution for each part and explain. also i dont understand what to do with -3Db cutoff frequency.When the first element in any row of the Routh array is zero while rest ofthe row has at least one nonzero element ,we have to replace ‘S’ by 1/Z tofind the stability using Routh Hurwitz.True/ FalseA. Find the following requirements in plotting the root locus. • number of branches • number of asymptotes • asymptote real-axis intercept • asymptote line angles • real-axis break-away points / break-in points • points at the jw-crossing B. Manually plot the root locus based on the requirements from item A.
- b) If quantity A is PATAT with TC of 2mV/C, and quantity B is CTAT with TC of -1mVrC, then determine the following quantities if they are PTAT or CTAT 1. 1/A 2. 1/B 3. A+ 5°B4/ Which parameter is neglected or ignored in Short Transmission Lines? A. SHUNT CAPACITANCE ONLY B. SERIES CONDUCTANCE AND SHUNT CAPACITANCE C. SHUNT CONDUCTANCE AND SHUNT CAPACITANCE D. SHUNT CONDUCTANCE ONLYFor the T-junctio, the 522 parameter is made equal to zero. A power of 5 mW is incident at port 2 and the other ports are reflectionless matched. Determine the power flow through the junction.
- Hi, I need help with this problem. Please use scattering matrix for this. DO NOT USE ABCD PARAMETERS!Ideally, a dc load line is a straight line drawn on collector characteristic curves between which of the following? Please select one: a. Q Point and shear b. Q Point and saturation c. V_CE (interrupt) and I_C (sat) d. I_b = 0 and I_B = I_C/ß_DCIn Nyquist stability criterion, 's' contour and F(s) contour will have different shape. Select one: O True O False
- Optical loss in unstable resonators is an disadvantage but in stable resonators, loss is a advantage and needs to be minimized. True FalseA single-phase transmission line consisting of two conductors, the radius of each conductor is 0.4 cm, the distance between the conductors is three and half meters and the height above ground is eight 1-The capacitance in uF/km without effect of ground is 2-The capacitance in pF/km with effect of ground isEstablish Friis Transmission Equation. Please help me quickly. I need it.