Shear Strength of SoilThe following are the results of two consolidated-drained triaxial tests on a clay:Test I: 03 = 140 kN /m2; o,ʻi failure)= 368 kN /m²Test II: 03 = 286 kN/m²; ơ,(ailure) = 701 kN /m²?Determine the shear strength parameters; that is, c' and o'.(Enter your answers to three significant figures.)d'kN /m²||3.

Please refer the attached image for complete solution. THANK YOU.

Shear Strength of Soil The following are the results of two consolidated-drained triaxial tests on a clay: Test I: 03 = 140 kN /m²; o,(failure) = 368 kN /m² Test II: 03 = 286 kN /m²; o, °1(failure) = 701 kN /m² Determine the shear strength parameters; that is, c' and ø'. (Enter your answers to three significant figures.) kN /m² $ = 3.

Shear Strength of Soil The following are the results of two consolidated-drained triaxial tests on a clay: Test I: 03 = 140 kN /m²; o,(failure) = 368 kN /m² Test II: 03 = 286 kN /m²; o, °1(failure) = 701 kN /m² Determine the shear strength parameters; that is, c' and ø'. (Enter your answers to three significant figures.) kN /m² $ = 3.

Fundamentals of Geotechnical Engineering (MindTap Course List)

5th Edition

ISBN:9781305635180

Author:Braja M. Das, Nagaratnam Sivakugan

Publisher:Braja M. Das, Nagaratnam Sivakugan

Chapter10: Shear Strength Of Soil

Section: Chapter Questions

Problem 10.20P

See similar textbooks

Similar questions

A CU triaxial test was carried out on a silty clay that was isotopically consolidated using a cell pressure of 125 kPa. The following data were obtained: Axial load (kPa) 0 5.5 11.0 24.5 28.5 35.0 50.5 85.0 105.0 120.8 Axial strain, &₁ (%) 0 0.05 0.12 0.29 0.38 0.56 1.08 2.43 4.02 9.15 Au (kPa) 0 4.0 8.6 19.1 29.3 34.8 41.0 49.7 55.8 59.0 (a) Plot the deviatoric stress vs. axial strain and excess porewater pressure vs. axial strain, respectively. (b) Determine the undrained shear strength (sµ). (Note: we assume that the sample reaches failure). (c) Determine the total principal stresses (0₁,03) and the effective principal stresses (0₁, 03') at the failure, respectively.
Question 2 The result presented in Table Q2a were obtained from a consolidated drained (CD) triaxial test on a normally consolidated clay sample of 75mm height x 38mm diameter tested at a confining pressure of 50 kPa. Table Q2a. CD triaxial test result Axial strain (%) 1 2 5 10 15 Applied force (kN) 0.01 0.03 0.05 0.08 0.10 Page 3 of 6 (a) Draw the Mohr circle for each stress state in the sample and the total stress path (TSP) throughout the test and determine the slope of the TSP to the horizontal.
Below are results from three unconsolidated undrained triaxial tests performed on a fully saturated clay specimen: Test No. 1 2 Minor principal stress (psi) Major principal stress at failure (psi) 10 25 33 22 37 45 Moisture content = 21 % Determine: a) Void ratio (e) of the soil. You may use eS = wG_ (assume Gs = 2.70) %3D b) Deviatory stress at failure for each test trial c) Shear strength parameters (cu and ø). Hint: Sketch the Mohr's circles for the three trials. 3.
In a drained triaxial test on consolidated clay the stress and angle are as follows: Deviator stress is 20 1b/in2 and friction angle is 210 . Calculate the effective confining pressure at failure.? A) 21 1b/in2 B) 22.2 1b/in2 C) 25.4 1b/in2 D) 17.9 1b/in2 make it fast
12.4 The following are the results of four drained direct shear tests on undisturbed nor- mally consolidated clay samples having a diameter of 50 mm. and height of 25 mm. Normal Shear force at Test no. force (N) fallure (N) 1 67 23.3 133 46.6 3 213 44.6 4 369 132.3 Draw a graph for shear stress at failure against the normal stress and determine the drained angle of friction from the graph. © Ceng age Leaming 2014
Q-2: Following are the results of four drained direct shear tests on an over consolidated clay: Diameter of specimen = 50 mm Height of specimen = 25 mm Test no. 1 2 3 4 Normal force (N) 150 250 350 550 Shear force at failure (N) 157.5 199.9 257.6 363.4 Determine shear strength parameters by plotting graph
9. A consolidated drained test was carried out on a sandy clay under a cell pressure of 250 kPa. A constant back pressure of 120 kPa applied throughout the test. The dimensions of the sample were 76 mm x 38 mm. Addional test data recorded at failure were: Load transducer force = 368 N 3 Measured change in volume = 2.42 x 10 m³ Axial deformation = 2.05 mm Determine the major principal stress, o, at failure. (455 kPa)
A sample of saturated clay, taken from a depth of 5 m, was tested in a conventional oedometer. The table below gives the vertical effective stress and the corresponding thickness recorded during the test. The water content at the end of the test was 40% and the initial height was 20 mm.(a) Plot a graph of void ratio versus ??′(log scale).(b) Determine ?? and ??.(c) Determine ?? between ??′ = 400 kPa and ??′ = 500 kPa. (d) Determine ???′ using Casagrande’s method.
The results of two drained triaxial tests on a saturated clay are given next: Specimen 1: Chamber confining pressure = 15 lb/in.? Deviator stress at failure = 31.4 lb/in.? Specimen II: Chamber-confining pressure = 25 lb/in.? Deviator stress at failure = 47 lb/in.? Calculate the shear strength parameters of the soil.
Q # 4. The following are the results of four drained direct shear tests on undisturbed normally consolidated clay samples having a diameter of 50 mm. and height of 25 mm. Test No. Normal Force (N) Shear Force at Failure (N) 1 67 23.3 133 46.6 213 44.6 4 369 132.3 Draw a graph for shear stress at failure against the normal stress and determine the drained angle of friction from the graph. (Note: Use excel for calculation and drawing the graph).
Paragraph Styles Q#4. The following are the results of four drained direct shear tests on undisturbed normally consolidated clay samples having a diameter of 50 mm. and height of 25 mm Test No. Normal Force (N) Shear Force at Failure (N) 1 67 23.3 2 133 46.6 44.6 132.3 3 213 4 369 Draw a graph for shear stress at failure against the normal stress and determine the drained angle of friction from the graph. (Note: Use excel for calculation and drawing the graph).
12. Complete this problem. Drained direct shear tests were conducted on three specimens of soil, each with a different effective stress: 39 kPa, 29 kPa, and 59 kPa. The data are shown on the right. 60 50 Use Excel to plot the critical state Mohr- Coulomb failure envelope, and a. 40 b. Determine the critical state strength parameters of the soil. 30 5 20 10 1 3 4. Shear displacement (mm) Shear stress (kPa)